2006 HONDA CIVIC COUPE ignition

Make sure the rear window is clear
and you have good visibility bef ore
starting to drive.
The rear window def ogger will clear
fog, frost, and thin ice from the
window. Push the def ogger button to
turn it on and off. The indicator in
the button comes on to show the
def ogger is on. If you do not turn it
of f , the def ogger will shut itself of f
af ter about 15 minutes. It also shuts
of f when you turn of f the ignition
switch. You have to turn the
def ogger on again when you restart
the vehicle.
Push the button next to the steering
wheel to turn on the hazard warning
lights (f our-way f lashers). This
causes all f our outside turn signals
and both turn indicators in the
instrument panel to f lash. Use the
hazard warning lights if you need to
park in a dangerous area near heavy
traf f ic, or if your vehicle is disabled. Pushing this button also turns the
mirror heaters on or of f . For more
inf ormation, see page . The def ogger and antenna wires on
the inside of the rear window can be
accidentally damaged. When
cleaning the glass, always wipe side-
to-side.
101
OnCanadianLX,EXandSimodels
Rear Window Def ogger
Hazard Warning Button
Hazard Warning Button, Rear Window Def ogger
72
Canadian LX, EX, Si
——y

y
(+yy

Î
Î The master key fits all the locks on
your vehicle. The valet key works
only in the ignition and the driver’s
door lock . You can keep the trunk
and trunk release handle locked
when you leave your vehicle and the
valet key at a parking f acility.On DX model (except Canadian
DX-G), the passenger’s door can
also be locked or unlocked with
the key.
Youshouldhavereceivedakey
number tag with your keys. You will
need this key number if you ever
have to get a lost key replaced. Use
only Honda-approved key blanks.
Keys and Locks
74
MASTER KEY WITH
REMOTE TRANSMITTER MASTER KEY WITH
REMOTE TRANSMITTER
KEY NUMBER
TAG
U.S. EX and Si models
KEY NUMBER
TAG VALET KEY
(Gray)
VALET KEY
(Gray)
KEY NUMBER
TAG VALET KEY
(Gray)
MASTER KEYS (Black)
DX model (except Canadian DX-G) All LX models and Canadian DX-G, EX,
and Si models
——y


y
(+yy

If the system repeatedly does not
recognize the coding of your key,
contact your dealer.
Do not attempt to alter this system
or add other devices to it. Electrical
problems could result that may make
your vehicle undrivable.
If you have lost your key and cannot
start your engine, contact your
dealer.
The system may not recognize your
key’s coding if another immobilizer
key or other metal object (i.e. key
f ob) is near the ignition switch when
you insert the key. When you turn the ignition switch to
the ON (II) position, the immobilizer
system indicator should come on
brief ly, then go of f . If the indicator
starts to blink, it means the system
does not recognize the coding of the
key. Turn the ignition switch to the
LOCK (0) position, remove the key,
reinsert it, and turn the ignition
switch to the ON (II) position again. The immobilizer system protects
your vehicle f rom thef t. If an
improperly-coded key (or other
device) is used, the engine’s f uel
system is disabled.
These keys contain electronic
circuits that are activated by the
immobilizer system. They will not
work to start the engine if the
circuits are damaged.
Protect the keys f rom direct
sunlight, high temperature, and
high humidity.
Donotdropthekeysorsetheavy
objects on them.
Keep the keys away f rom liquids.
If they get wet, dry them
immediately with a sof t cloth.
The keys do not contain batteries.
Do not try to take them apart.
CONT INUED
On DX model (except Canadian DX-G)
Immobilizer System
Keys and Locks, Immobilizer System
Inst rument s and Cont rols
75
——y
y
(+yy

µ
µ
µ
µ If the f ront wheels are turned, the
anti-thef t lock may make it dif f icult
to turn the key. Firmly turn the
steering wheel to the lef t or right as
you turn the key.
You can
operate the audio system and the
accessory power socket in this
position.
This is the normal key
position when driving. Several of the
indicators on the instrument panel
come on as a test when you turn the
ignition switch f rom the
ACCESSORY (I) to the ON (II)
position.
Use this position
only to start the engine. The switch
returns to the ON (II) position when
you let go of the key.
You can insert or
remove the key only in this position.
To turn the key, push it in slightly. If
your vehicle has an automatic
transmission, the shif t lever must
also be in park. The ignition switch has f our
positions: LOCK (0), ACCESSORY
(I), ON (II), and START (III).
As required by the FCC:
This device complies with Part 15 of theFCC rules. Operation is subject to thef ollowing two conditions: (1) This devicemay not cause harmf ul interf erence, and(2) this device must accept anyinterf erence received, includinginterf erence that may cause undesiredoperation.
Changes or modif ications not expresslyapproved by the party responsible f orcompliance could void the user’sauthority to operate the equipment.
This device complies with IndustryCanada Standard RSS-210.Operation is subject to the f ollowing twoconditions: (1) this device may not causeinterf erence, and (2) this device mustaccept any interf erence that may causeundesired operation of the device.
A CCESSORY (I)
ON (II)
ST A RT (III)
LOCK (0) Ignition Switch
Immobilizer System, Ignition Switch
76
——y

y
(+yy

To lock the passenger’s door when
getting out of the vehicle, pull out
the lock tab and close the door. To
lock the driver’s door, pull and hold
the outside door handle then pull out
the lock tab. Release the handle,
then close the door.
Each door can be locked or unlocked
with the ignition key.
Each door has a lock tab next to the
inside door handle. Pull out the tab
to lock the door, and push it in to
unlock.
When the door is unlocked, the red
mark on the lock tab is shown.
You will hear a reminder beeper if
you leave the key in the LOCK (0) or
the ACCESSORY (I) position and
open the driver’s door. Remove the
key to turn of f the beeper.
If your vehicle has an automatic
transmission, the shif t lever must be
in Park bef ore you can remove the
key f rom the ignition switch.
On DX model except Canadian DX-G
Ignit ion Swit ch, Door L ocks
Door L ocks
Inst rument s and Cont rols
77
LOCK
UNLOCK LOCK TAB
RED MARK
Removing the key from the
ignition switch while driving
locks the steering. This can
cause you to lose control of the
vehicle.
Remove the key from the
ignition switch only when
parked.
——y
y
(+yy

Your vehicle has two custom door
lock settings: auto door locking and
auto driver’s door unlocking. Make
all settings bef ore you start driving.
With the driver’s door open and the
key in the ignition, both master door
lock switches are disabled. They are
not disabled if the driver’s door is
closed. Pushing the top of the switch
on the open passenger’s door will
lock both doors. To lock the passenger’s door when
getting out of the vehicle, pull out
the lock tab and close the door. To
lock the driver’s door, remove the
key f rom the ignition switch and pull
out the lock tab or push the top of
the master switch, then close the
door. To unlock only the driver’s door
f rom the outside, turn the key and
releaseit.If youturnitagain,both
doors unlock. The lock tab on the passenger’s door
locks and unlocks only that door.
Pushing in the driver’s door lock tab
only unlocks the driver’s door.
To lock the doors, push the top of
the master door lock switch on
either door, pull out the lock tab on
the driver’s door, or use the key in
the outside lock on the driver’s door.
Pushing the bottom of either master
door lock switch unlocks both doors.
If equipped On LX, EX, and Si model in the U.S., and
DX-G,LX,EX,andSimodelsinCanada
Door L ocks
A uto Door L ocking/Unlocking
Power Door L ocks
L ockout Prevent ion
78
MASTER DOOR LOCK SWITCH
——y
y
(+y
y

The auto door locking f eature has
two or three possible settings,
depending on the transmission type
(A/T or M/T):Make sure the shif t lever is in
Park (P), and close the driver’s
door.
Turn the ignition switch to the ON
(II) position.Set the parking brake.
Push and hold the brake pedal,
then move the shift lever out of
Park (P).
Pushandholdthefrontof the
master door lock switch on the
driver’s door. You will hear a
clicking sound, and af ter about 5
seconds, you will hear another
clicking sound.
Release the switch, move the shif t
lever to Park (P), and turn the
ignition switch to the LOCK (0)
position within 5 seconds.
Close the driver’s door.
Turn the ignition switch to the ON
(II) position.
The doors lock when the vehicle
speed reaches 9 mph (15 km/h).
On vehicles with automatic
transmission, the doors lock
whenever you move the shif t lever
out of the Park position.
The auto door locking is
deactivated all the time.
This is the def ault setting when
the vehicle leaves the f actory.
1.
2. 1. 3.
4.
5.
6.
2.
Locks both doors when the vehicle’s
speed reaches about 9 mph (15 km/h).
On vehicles with automatic transmission On vehicles with manual transmission
CONT INUED
Door L ocks
To activate either auto door lockmode:A uto Door L ocking
Inst rument s and Cont rols
79
——y
y
(+yy

Set the parking brake.
Pushandholdthefrontof the
master door lock switch on the
driver’s door. You will hear a
clicking sound, and af ter about 5
seconds, you will hear another
clicking sound.
Release the switch, and turn the
ignition switch to the LOCK (0)
position within 5 seconds.Make sure the shif t lever is in
Park (P), and close the driver’s
door.
Turn the ignition switch to the ON
(II) position.
Set the parking brake.Pushandholdthefrontof the
master door lock switch on the
driver’s door. You will hear a
clicking sound, and af ter about 5
seconds, you will hear another
clicking sound.
Release the switch, and turn the
ignition switch to the LOCK (0)
position within 5 seconds.
1.
2.
3.
4.
5.
3.4.
5.Locks both doors when the shif t lever is
moved out of Park (P).On vehicles with automatic transmissiononly
Door L ocks
80
——y
y
(+yy