3
SeeSection3ofyourOwnerManual.
A
B
C
D
E
F
G
InstrumentPanelCluster
Yourvehicle’sinstrumentpanelis
equippedwiththisclusteroronevery
similartoit.
Theinstrumentpanelclusterincludes
thesekeyfeatures:
A.TransmissionTemperatureGauge
(ifequipped)
B.TachometerC.SpeedometerandTransmission
GearSelector
D.OilPressureGauge
E.FuelGauge
F.Voltmeter
G.EngineCoolantTemperature
Gauge
H.DriverInformationCenter(DIC)
andOdometer
NOTE:
SeeSection3ofyourOwner
Manualformoreinformationabout
whatthelights,gaugesandindica
torsonyourvehicle’sinstrument
paneltellyouaboutyourvehicle’s
operation.
H
Yukon YukonDenali 06 Beta3 5/19/05 10:03 AM Page 3
Getting to Know YourYukon/Yukon Denali16
Fuel Information (if equipped)
Press the fuel information button
to scroll through the Fuel Range, Fuel
Used, Average Economy and Engine Oil
Life selections on the Driver Information
Center.
Fuel Range
This mode shows the range in miles that
the vehicle can travel with the current
amount of fuel.
Fuel Used
This mode shows the current amount of
fuel used in gallons since the last reset
for Fuel Used. This mode should be
reset after every fuel tank fill up.
Average Economy
This mode shows the average fuel econ
omy in miles per gallon since the last
reset for Average Economy.
Engine Oil Life
This mode shows the percentage of oil
life left until it is recommended to
change the engine oil. An oil and filter
change should be performed within 600
miles of the Change Oil message being
displayed.
See Section 3 of your Owner Manual.
Reset Trip Information
To reset TRIP A or TRIP B information,
press and hold the Select button ( )
for one second while in one of the trip
modes. This will reset the information for
TRIP A or TRIP B. You can also reset
TRIP A or TRIP B while they are dis
played by pressing the reset stem on
the cluster. If you press and hold the
reset stem or for four seconds, the
display will show the distance traveled
since the last ignition cycle for TRIP A
or TRIP B.
Timer
The DIC can be used as a timer. Press
while TIMER is displayed to start
the timer. The display will show the
amount of time that has passed since
the timer was last reset, not including
time the ignition is off, up to 99 hours,
59 minutes and 59 seconds (99:59:59).
Engine Hours
This mode shows the total number of
hours the engine has run. Pressing and
holding the reset stem located on the
instrument cluster for about four sec
onds will also display the engine hours
after the odometer is displayed when the
vehicle is off.
See Section 2 of your Owner Manual.
Yukon YukonDenali 06 Beta3 5/19/05 10:04 AM Page 16
