2006 GMC ENVOY engine

3
SeeSection3ofyourOwnerManual.
A
B
C
D
E
F
InstrumentPanelClusterYourvehicle’sinstrumentpanelis
equippedwiththisclusteroronevery
similartoit.Theinstrumentpanel
clusterincludesthesekeyfeatures:
A.Tachometer
B.SpeedometerC.OilPressureGauge
D.FuelGauge
E.Voltmeter
F.EngineCoolantTemperature
Gauge
NOTE:
Theinstrumentpanelcluster
isdesignedtoletyouknowabout
manyimportantaspectsofyourvehi
cle’soperation.Itisimportanttoread
yourOwnerManualandbecome
familiarwiththeinformationbeing
relayedtoyoubythelights,gauges
andindicators,aswellaswhataction
canbetakentoensuresafetyandto
preventdamage.

Getting to Know YourEnvoy4
Heated Front Seats (if equipped)
Select a heat setting for both the
seatback and seat cushion
• Press and release the button labeled
with the heated seat ( ) icon
located on the front door armrest
until the indicator lights designate
your setting: three for High, two for
Medium, one for Low and none
for Off.
Select a heat setting for the seatback
only
• Press and release the vertical heated
seat button until the switch indicates
the desired setting: three for High,
two for Medium, one for Low and
none for Off.
The engine must be running to operate
this feature.
See Section 1 of your Owner Manual.
Malfunction Indicator Lamp
(Service Engine Soon Lamp)
This instrument panel cluster lamp
illuminates under a variety of conditions
when the OnBoard Diagnostics II (OBD
II) system detects a malfunction in the
vehicle’s emission controls.
If the Malfunction Indicator Lamp
is lit steadily, check the gas cap to
ensure it is present and securely
fastened
• Turn the cap clockwise until a ratch
eting sound is heard, signaling that it
is secure.
• If this is the cause of the condition, a
few driving trips with the cap installed
properly should turn the light off.
See Section 3 of your Owner Manual.
Interior Lamps
Your vehicle is equipped with illuminated
entry and exit lighting as well as dome
lamps.
Activate illuminated entry feature
• Open a door or press the Unlock
button on your Remote Keyless Entry
transmitter.
• With all doors closed, the dome
lamps stay illuminated briefly and turn
off automatically.
Disable entry and exit lighting
• Push in the Dome Override button
located below the exterior lamps
switch (see “A” above). This will over
ride the illuminated entry feature
unless the Remote Keyless Entry
transmitter is used to unlock the
vehicle. The Dome Override feature
is useful when the vehicle doors need
to be open for a long period of time.
See Section 3 of your Owner Manual.
A

Getting to Know YourEnvoy8
Content TheftDeterrent System
Arm the ContentTheft Deterrent
System
• Lock the doors using the power door
lock switch or by pressing the Lock
button on the Remote Keyless Entry
transmitter.
• After closing all doors, the security
lamp on the radio stops flashing and
remains lit. After a delay of about 30
seconds, the lamp darkens and the
system arms itself.
• When arming with the power door
lock switch, at least one door must be
open and the key must be removed
from the ignition. (A door does not
have to be open to arm the system
with the Remote Keyless Entry
transmitter.)
•The system will not arm if the door is
locked with a key or the manual door
lock button is pressed.
• If the alarm is tripped, the horn
sounds and the headlamps/taillamps
flash for about two minutes. The
alarm sounds whenever a locked
door is opened without the key or
Remote Keyless Entry transmitter,or
if someone attempts to turn on the
ignition without the correct key.
Turn off the alarm
• Unlock a door with the key or press
Unlock on the Remote Keyless Entry
transmitter.
• Starting the engine with the correct
key will also turn off the alarm.
See Section 2 of your Owner Manual.
Lockout Protection
Prevent your ignition key from being
locked in your vehicle
• When the key is in the ignition and
a door is open, pressing any power
door lock switch unlocks the driver
door and locks all other doors.
See Section 2 of your Owner Manual.
Headlamp Controls
The exterior lamps knob is located on
the instrument panel, to the left of the
steering wheel.
Turn off the Daytime Running Lamps
(DRL) and automatic headlamp
system
• Move the knob to the OFF ( )
position.
The automatic headlamp system auto
matically reactivates at the next keyon.

Fuel Information Button
• Press to scroll through the range,
average fuel economy, fuel used and
the GM Oil Life System
TM.
• RANGE estimates the remaining dis
tance you can drive without refueling.
Range is based on recent fuel econo
my and the fuel remaining in the tank.
• AVG. ECON calculates how many
miles per gallon you are getting
based on overall driving conditions.
Press and hold the Select button ()while AVG. ECON is displayed
and the DIC will begin calculating the
average fuel economy from that point
in time.
• FUEL USED shows the current
amount of fuel used in gallons since
the last reset for FUEL USED. This
mode should be reset after every fuel
tank fillup.
• ENGINE OIL LIFE calculates an esti
mate (percentage) of the engine oil’s
remaining useful life. It also will alert
you when it is time to change your oil
by illuminating the CHANGE ENG
OIL light on the DIC. Please remem
ber to always reset the oil life system
after an oil change by pressing and
holding for four seconds while
ENGINE OIL LIFE is displayed. When
successful, the DIC will display
ENGINE OIL LIFE: 100%.
15
Note:If your vehicle is not equipped
with DIC steering wheel buttons, press
the trip odometer reset stem located in
the instrument panel cluster to select
the information. Hold the stem for four
seconds to reset trip odometers.Personalization Button
• Press once and the vehicle settings
will be displayed. Press again to
scroll through and set the personal
ization features.
Select Button
• Press to scroll through the menu
choices for each personalization
feature. Finalize your choice by
pressing while it is displayed on
the DIC and move on to the next
feature.
• The personalization features can be
reset to their default mode by holding
and down for four seconds.
Language Options
• If you find that the unit displays a lan
guage other than the one you prefer
and you are unable to change it, hold
and down until the display
begins cycling through the three
available languages. Release the
buttons when you see the preferred
language.
Displaying Driver Preferences
•The driver preferences are recalled
by pressing memory button 1 or 2
located on the driver’s door. The last
value displayed for each preference
is saved automatically.
See Section 3 of your Owner Manual.

17
FourWheel Drive (if equipped)
Envoy’s fourwheel drive system rotary
controls are located on the instrument
panel. Your vehicle will have one of the
above transfer case knobs.
Shift into 4HI, 4 , A4WD or AUTO
• Turn the knob to 4HI, 4 , A4WD or
AUTO. This can be done at any
speed except when shifting from 4LO
or 4 .
Shift into 2HI or 2
• Turn the knob to 2HI or 2 . This can
be done at any speed except when
shifting from 4LO or 4 .
Shift into or out of 4LO or 4
• With the ignition in RUN and the vehi
cle stopped or moving less than 3
mph (4.8 km/h), shift the transmission
into Neutral.
• Turn the knob to 4LO (4 ), 2HI (2 ),
4HI (4 )or A4WD (AUTO), preferably
with the vehicle moving 1 to 2 mph
(1.6 to 3.2 km/h).
• Wait for the indicator lamp to stop
flashing and remain illuminated; then
shift your transmission into gear.
Shift into NEUTRAL (N)
• Place the transfer case in Neutral
only when towing your vehicle. See
Section 4 of your Owner Manual for
towing information.
See Sections 2, 4 and 5 of your Owner Manual.
StabiliTrak®– Stability Control
System
StabiliTrak combines antilock brake,
traction control, and stability control sys
tems that help the driver maintain direc
tional control of the vehicle in most driv
ing conditions. The system is designed
to help keep the vehicle on the driver’s
intended path by using throttle and
brake intervention.
When activated, the system will apply
braking to individual wheels and may
reduce engine power as necessary to
help you maintain directional control of
the vehicle. You may also hear a noise
or vibration, or feel a reduction in accel
eration, while the system is active. This
is normal.
StabiliTrak is automatically turned on
when the vehicle is started and does not
require any driver input. It is recom
mended to leave the system on at all
times for normal driving. It may be nec
essary to turn off the system if the vehi
cle is stuck in sand, mud or snow.
To turn off StabiliTrak, press and hold
the (StabiliTrak) button on the trans
mission shift handle for five seconds.
STABILITRAK OFF will be displayed on
the DIC. Press the button again to turn
the system back on.
See Section 4 of your Owner Manual.