2006 FIAT STILO oil

217
WARNING
LIGHTS AND
MESSAGES
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
1 Engine oil - 2 Battery - 3 Brake fluid -
4 Windscreen/rear window/headlight
washer fluid - 5 Engine coolant - 6 Sele-
speed transmission oil (where provided)
fig. 3 - 1.816V version
fig. 4 - 2.4
20V version
1 Engine oil - 2 Battery - 3 Brake fluid -
4 Windscreen/rear window/headlight
washer fluid - 5 Engine coolant
F0C0502m
F0C0503m

218
WARNING
LIGHTS AND
MESSAGES
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
1 Engine oil - 2 Battery - 3 Brake fluid -
4 Windscreen/rear window/headlight
washer fluid - 5 Engine coolant
1 Engine oil - 2 Battery - 3 Brake fluid -
4 Windscreen/rear window/headlight
washer fluid - 5 Engine coolant
fig. 6 - 1.9 Multijet 16V versions
F0C0504mfig. 5 - 1.9 Multijet 8V versions
F0C0505m

219
WARNING
LIGHTS AND
MESSAGES
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
ENGINE OIL fig. 7-8-9-10-11-12
Checking engine oil
Check the oil level a few minutes (about
5) after the engine has stopped, with the
car parked on level ground.
Remove the dipstick Aand clean it, put
it back in completely, remove it and check
that the level is within the MINand MAX
marks on the dipstick. The interval be-
tween the MINand MAXmarks corre-
sponds to about one litre of oil.
fig. 7 - 1.416V version F0C0103m
Topping up engine oil
If the oil level is near or even below the
MINmark, add oil through the filler neck
B, until reaching the MAXmark.
Oil level shall never exceed the MAX
mark.IMPORTANT If a routine check reveals
that the oil level is above the MAXmark,
contact Fiat Dealership to have the cor-
rect level restored.
IMPORTANT After adding or changing
the oil, let the engine turn over for a few
seconds and wait a few minutes after turn-
ing it off before you check the level.
fig. 8 - 1.816V version F0C0519mfig. 9 - 1.9 Multijet 8V version F0C0122m

220
WARNING
LIGHTS AND
MESSAGES
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
fig. 10 - 1.616V version F0C0231mfig. 11 - 2.420V version F0C0115mfig. 12 - 1.9 Multijet 16V version F0C0470m
Engine oil consumption
Max engine oil consumption is usually 400
grams every 1000 km.
When the car is new, the engine needs
to run in, therefore the engine oil con-
sumption can only be considered stabilised
after the first 5000 - 6000 km.IMPORTANT The oil consumption de-
pends on driving style and the conditions
under which the car is used.
IMPORTANT Do not add oil with speci-
fications other than that already in the en-
gine.
When the engine is hot, take
care when working inside the
engine compartment to avoid burns.
Remember that when the engine is
hot, the fan may cut in: danger of in-
jury. Scarves, ties and other loose
clothing might be pulled by moving
parts.
WARNING
Used engine oil and filter con-
tain harmful substances for
the environment. Contact Fi-
at Dealership to have the oil
and filter changed.

221
WARNING
LIGHTS AND
MESSAGES
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
❒if the oil is below the MAXmark, top
up to reach the correct level;
❒after refitting the cap, insert the
breather tube firmly on the cap spout
and turn the ignition key to STOP.
IMPORTANT Do not add oil into the cir-
cuit tank having different specifications
from that already existing.
fig. 13F0C0121m
Used gearbox oil contains
dangerous substances for the
environment. For changing
the oil we advise contacting
Fiat Dealership, which is equipped for
disposing of used oil respecting the na-
ture and the law.
HYDRAULIC SYSTEM OIL FOR
ACTUATING SELESPEED
GEARBOX (where provided)
fig. 13
The oil should be checked with the car on
a level surface and with the engine stopped
and cold.
To check the level, proceed as follows:
❒turn the ignition key to MAR;
❒disconnect the breather tube and re-
move the cap Achecking that the lev-
el corresponds with the MAXmark on
the reservoir;

236
WARNING
LIGHTS AND
MESSAGES
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
INTERIOR PLASTIC PARTS
For routine cleaning of interior plastic
parts use a soft cloth moistened with wa-
ter and neutral soap. Remove grease or
persisting stains using appropriate solvent-
free products designed to preserve ap-
pearance and colour of plastic compo-
nents.
IMPORTANT Never use spirit or petro-
leum to clean the instrument panel.STEERING WHEEL/GEAR LEVER
KNOB WITH GENUINE
LEATHER COVERING
These components shall only be cleaned
with water and neutral soap. Never use
spirit or alcohol-based products.
Before using special products for clean-
ing interiors, read carefully label instruc-
tions and indications to make sure they
are free from spirit and/or alcohol-based
substances.
If when cleaning the windscreen with spe-
cial glass products, some drops fall on the
leather covering of the steering wheel/gear
lever knob remove them immediately and
then clean with water and neutral soap.
IMPORTANT Take the utmost care when
engaging the steering lock to prevent
scratching the leather covering.
Do not keep aerosol cans in
the car: they might explode.
Aerosol cans must never be exposed
to a temperature above 50°C. The
temperature inside the car exposed
to the sun may go well beyond that
figure.
WARNING
Never use flammable prod-
ucts like oil ether or rectified
petrol for cleaning car interiors. Elec-
trostatic discharges generated by rub-
bing during cleaning operations could
cause fire.
WARNING

259
WARNING
LIGHTS AND
MESSAGES
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
FLUIDS AND LUBRICANTS
RECOMMENDED PRODUCTS AND THEIR SPECIFICATIONS
Use Fluid and lubricant specifications Genuine fluids Change
for correct car operation and lubricants intervals
Lubricants for
petrol engines
Lubricants for
diesel engines
As per Service
Schedule
As per Service
Schedule
As per Service
Schedule Synthetic-based oil, grade SAE 5W-40, that pass
FIAT 9.55535-M2 specification.
Synthetic-based oil, grade SAE 10W-60
Synthetic-based oil, grade SAE 5W- 40
that pass FIAT 9.55535- M2 specificationSELENIA K (❒)
SELENIA RACING (
❍)
SELENIA WR
(
❒) 1.416V, 1.616Vand 1.816V versions
(
❍) 2.420V versions
For regular operation of Multijet versions fitted with DPF, use the genuine lubricant only. In the event of an emergency, lacking the
genuine lubricant, top up just once with max. 0.5 l and go to Fiat Dealership as soon as possible.
Should non-genuine SAE 5W-40 products be used, lubricants with minimum ACEA A3 properties for petrol engines and ACEA B4
for Diesel engines are tolerated; in this event top engine performance is not guaranteed.
Using low-quality products, not compliant with ACEA A3 and ACEA B4 properties and specifications could cause engine damages
not covered by warranty.
For very cold temperatures, consult Fiat Dealership for the proper Seleniaproduct to use.

Lubricants
and greases for
transmissions
260
WARNING
LIGHTS AND
MESSAGES
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
Use Fluid and lubricant specifications Genuine fluids Applicationsfor correct car operation and lubricants
(●) Do not add or mix fluids having different specifications from that already existing.Synthetic-based oil, grade SAE 75W-85
that passes API GL-4 PLUS, FIAT 9.55550
MIL-L- 2105 D LEV specifications.
Specific fluid with “ATF DEXRON III”
Lithium soap based grease. NLGI 0 consistency
Poly-urea oil synthetic-based grease suitable for high temperatures.
NLGI 2 consistency
Molibdenum disulphide, lithium soap based grease.
NLGI 2 consistency
Synthetic fluid, FMVSS n° 116 DOT 4, ISO 4925
SAE J1704, CUNA NC 956-01
Protective with antifreeze action, red colour
based on inhibited monoethylen glycol and organic formula,
O.A.T technology, that passes CUNA NC 956-16,
ASTM D 3306 specifications.
Additive for diesel fuels with protective action for Diesel engines
Mixture of alcohol and surfactants CUNA NC 956-IITUTELA CAR
TECHNYX
TUTELA CAR
CS SPEED
TUTELA
MRM ZERO
TUTELA STAR 325
TUTELA STAR 500
TUTELA TOP 4
PARAFLU UP (●)
DIESEL MIX
TUTELA
PROFESSIONAL
SC 35Mechanical gearbox
and differential
Selespeed transmission
electrically-operated
electrohydraulic actuator
CV joints on differential
side (excluding
version 1.8
16V)
CV joints on differential
side submitted to high
temperatures
(only versions 1.6
16V)
CV joint on
wheel side
(excluding version 1.8
16V)
Brake and clutch hydraulic
controls
Cooling circuits. Proportion:
50% down to –35° C.
Not to be mixed with
other products.
To be mixed with diesel fuel
(25 cc per 10 litres)
To be used diluted or
undiluted
Windscreen/
rear window/
headlight
washer fluid Additive for
diesel fuel Protective
agent
for radiators Brake
fluid