Page 78 of 274

77
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SUNROOF OPENING/CLOSING
With key without remote control
(where provided)
Opening: turn the key clockwise in the
door revolving plug.
Closing: turn the key counterclockwise in
the door revolving plug.
With key with remote control
Opening: prolonged pressing (for more
than 2 seconds) on button
Ë.
Closing: prolonged pressing (for more
than 2 seconds) on button
Á.
When buttons
Á/Ë, are released, the
above functions are cut-off.
When opening, blades and curtain open at
the same time.
When closing, the curtain closes first and
then are closed the blades.ANTI-CRUSHING SAFETY
SYSTEM
The anti-crushing safety system fitted on
the front curtain outline is active along the
whole closing range of the curtain and cuts
into operation when an obstacle (e.g.: fin-
ger, hand, etc...) is met. This safety device
guarantees the reversal for a short sec-
tion.
In addition, the anti-crushing safety system
is active on the rear border of the first
blade and on the front outline of the sec-
ond blade: in this case it is active on the
whole closing range of the curtain and cuts
into operation when an obstacle (e.g.: fin-
ger, hand, etc...) is met. This safety device
guarantees the reversal for a short sec-
tion.
As concerns the first blade it is active on
the whole rotation range and guarantees
the reversal of the whole stroke.
After anti-crushing system activation, re-
setting can be carried out with the fol-
lowing 2 procedures:
❒pushing knob A-fig. 83upwards (reset
previously stopped movement);
❒turning knob Ato another position.INITIALISATION PROCEDURE
Sunroof shall be re-initialised after dis-
connecting the battery or if the relevant
protection fuse is blown:
❒turn knob A-fig. 81to “0” (fully
closed);
❒keep the knob pressed for over 5 sec-
onds: the sunroof will close jerkily;
❒keep the knob pressed and wait for
complete closing of the sunroof, until
the sun curtain clicks twice.
Sunroof is now initialised and it shall work
regularly. Otherwise, contact Fiat Deal-
ership.
IMPORTANT Carry out the initialisation
procedure with the engine running. If stop-
ping the initialisation procedure before
ending it, repeat it from the beginning.
Page 79 of 274

78
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
ANTI-CRUSHING SYSTEM
INHIBITION
Ice or other foreign matters in the sun-
roof rails could cause anti-crushing re-
peated operation. Therefore make sure
there is no obstacle.
In this case it is possible to inhibit the an-
ti-crushing system by closing the roof
(within 5 seconds from system activation),
turning knob A-fig. 81to 0and keeping
it pressed upwards until closing.
IMPORTANT During this operation do
not release knob A; if releasing the knob
and then pressing it again, it will be nec-
essary to carry out the initialisation pro-
cedure described in the previous para-
graph.
IMPORTANT During this operation the
anti-crushing system is cut-out.EMERGENCY OPERATION
If the electrical control device does not
work, the sunroof can be operated man-
ually as follows:
❒remove the front ceiling light A-
fig. 82pressing on the sides of the plas-
tic shape as shown by the arrow;
❒insert the proper emergency key B-
fig. 83(located inside the ceiling light)
into the seat C-fig. 84;
❒turn the key to open or close (accord-
ing to the rotation direction) the glass
blades.Then, carry out the initialisation proce-
dure described on previous page.
fig. 82F0C0253mfig. 83F0C0400m
fig. 84F0C0399m
Page 94 of 274

93
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
ROOF RACK/
SKI RACK
The roof rack bars shall be secured to the
roof in points shown A. Lift tabs B-
fig. 120using the screwdriver provided
in the kit to access the seats Cfor secur-
ing the roof rack/ski rack.
A roof rack/ski rack specially designed for
the car is available at Lineaccessori Fiat.
After few kilometers, check that fastening
screws are firmly tightened.
IMPORTANT Never exceed the max.
permissible loads (see section “Technical
specifications”).Multi Wagon versions
The car is fitted with two longitudinal bars
which can be used, by adding specific ac-
cessories, to carry various objects (e.g.
skis, windsurf, etc…).
IMPORTANT Putting cross bars on lon-
gitudinal bars fig. 121inhibits use of the
sunroof (Skywindow) (where provided),
since its opening interferes with the bars.
fig. 120F0C0169mfig. 121F0C0349m
Open the tailgate with care
when carrying objects on the
roof rack bars to prevent impacts.
WARNING
IMPORTANT Never exceed the max.
permissible loads (see section “Technical
specifications”).
Page 193 of 274
192
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
IINDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
IF AN INTERIOR LIGHT
BURNS OUT
For the type of bulb and power rating, see
“When needing to change a bulb”.
FRONT CEILING LIGHT
Versions without Skywindow
sunroof
To change the bulb, proceed as follows:
❒press the catches A-fig. 41and with-
draw the plastic cover B;
❒slacken the 2 fastening screws A-
fig. 42, then turn the 2 bulb holders B
counterclockwise;
❒remove the bulbs and replace them. To
replace bulb C-fig. 42, release it from
the side contacts making sure that the
new bulb is correctly clamped between
the contacts.
Versions with Skywindow sunroof
To change the bulbs, proceed as follows:
❒remove the front ceiling light A-
fig. 43pressing the plastic cover as
shown by the arrows
❒disconnect electric connectors B-
fig. 44and C;
fig. 41F0C0201m
fig. 42F0C0202m
fig. 43F0C0253m
fig. 44F0C0398m
Page 194 of 274

193
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
❒slacken the 2 fastening screws A-
fig. 45, then turn the 2 bulb holders B
counterclockwise, remove the bulbs
and replace them. To replace bulb C,
release it from the side contacts mak-
ing sure that the new bulb is correctly
clamped between the contacts.REAR CEILING LIGHT
(where provided)
Versions without Skywindow
sunroof
To change the bulb, proceed as follows:
❒remove the light unit A-fig. 46lever-
ing in the points shown by the arrows
(on retaining tabs);
❒replace the bulbs Breleasing them from
the side contacts making sure that the
new bulb is correctly clamped between
the contacts.Versions with Skywindow sunroof
Versions with Skywindow sunroof are fit-
ted with two rear ceiling lights.
To replace the bulbs proceed as follows:
❒using the screwdriver provided in the
kit, remove the cover A-fig. 47in the
point shown by the arrow;
❒replace the bulb B-fig. 48releasing it
from the side contacts making sure that
the new bulb is correctly clamped be-
tween the contacts.
fig. 45F0C0202m
fig. 46F0C0204m
fig. 47F0C0227mfig. 48F0C0229m
Page 205 of 274

204
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
IINDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
COMPONENTS
Electronic injection system/Selespeed system
(2.4 20Vversions)/Radiator fan control unit(2.4 20Vversions) (key-operated positive)
Skywindow sunroof curtain
Skywindow sunroof
Additional heater (Multijet versions)
Glow plug warming (Multijet versions)
Free
Electronic injection primary services (Multijet versions)
+30 Selespeed
Electric power steering (key-operated positive)
Radio external amplifier
Driver’s seat warming
Front passenger’s seat warming
Steering wheel controls, Connect/Navigator, Parking sensors,
Rain/daylight sensor, Central console control panel,
Heating/climate control unit, Bluetooth system control unit,
Ideograph lighting, Set of switches for light control and
menu access-setting, Volumetric and antiraising sensor deactivation
buttons, Front ceiling light,
Sunroof controls (key-operated positive)
FUSE
F16
F45
F46
F73 (MIDI-FUSE)
F04 (MAXI-FUSE)
F20
F22
F23
F24
F54
F57
F67
F49
AMPERE
7.5
20
20
50
50
–
20
15
7.5
25
10
10
7.5
FIGURE
59
57
57
61
59
59
59
59
59
65
65
65
57
Page 255 of 274

254
WARNING
LIGHTS AND
MESSAGES
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
1.416V1.616V1.816V
WEIGHTS
Weights (kg)(Saloon versions)
Weight empty
(including fluids, 90% fuel
in the tank and no optional)
Payload (*) including the driver:
Maximum admitted loads (**)
– front axle:
– rear axle:
– total:
Towable loads
– trailer with brakes:
– trailer without brakes:
Maximum load on roof (***):
Maximum load on tow hitch
(trailer with brakes):
(*) If special equipment is fitted (sunroof, tow hitch, etc.) the unladen car weight increases thus reducing the specified payload.
(**) Loads not to be exceeded. The driver is responsible for arranging the loads in the boot an/or on the roof so that they com-
ply with these limits.
(***) Lineaccessori Fiat roof rack, max capacity: 50 kg.
(
❍) “DYNAMIC” versions.
(
❒) For specific markets.3-door
1090
1135 (
❍)
510
900
830
1600
1645 (
❍)
1000/500 (
❒)
500
80
605-door
1145
1190 (
❍)
510
900
860
1655
1700 (
❍)
1000/500 (
❒)
500
80
603-door
1150
1195 (
❍)
510
950
830
1660
1705 (
❍)
1100/500 (
❒)
500
80
605-door
1205
1250 (
❍)
510
950
860
1715
1760 (
❍)
1100/500 (
❒)
500
80
603-door
1240
510
990
830
1750
1200/500 (❒)
500
80
605-door
1295
510
990
860
1805
1200/500 (❒)
500
80
60
Page 256 of 274

255
WARNING
LIGHTS AND
MESSAGES
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
2.420V1.9 Multijet 8V1.9 Multijet 16VWeights (kg)(Saloon versions)
Weight empty
(including fluids, 90% fuel
in the tank and no optional)
Payload (*) including the driver:
Maximum admitted loads (**)
– front axle:
– rear axle:
– total:
Towable loads
– trailer with brakes:
– trailer without brakes:
Maximum load on roof (***):
Maximum load on tow hitch
(trailer with brakes):
(*) If special equipment is fitted (sunroof, tow hitch, etc.) the unladen car weight increases thus reducing the specified payload.
(**) Loads not to be exceeded. The driver is responsible for arranging the loads in the boot an/or on the roof so that they com-
ply with these limits.
(***) Lineaccessori Fiat roof rack, max capacity: 50 kg.
(
❒) For specific markets.3-door
1265
510
1030
830
1775
1300/500 (
❒)
500
80
603-door
1320
510
1030
830
1830
1300/500 (❒)
500
80
603-door
1265
510
1020
830
1775
1300/500 (❒)
500
80
603-door
1320
510
1020
860
1830
1300/500 (❒)
500
80
603-door
1285
510
1030
830
1795
1300/500 (❒)
500
80
603-door
1340
510
1030
860
1850
1300/500 (❒)
500
80
60