▫Body Lubrication.....................186
▫Front And Rear Suspension Ball Joints......186
▫Steering Linkage......................187
▫Body Mechanism Lubrication.............187
▫Windshield Washers...................189
▫Exhaust System......................189
▫Cooling System.......................190
▫Hoses And Vacuum/Vapor Harnesses.......195
▫Brake System........................195
▫Brake, Power Steering, And Fuel System
Hoses.............................196
▫Brake And Clutch Fluid.................197
▫Master Cylinder......................197▫Hydraulic Clutch.....................198
▫Transmission........................198
▫Rear Axle...........................199
▫Wheel Bearings.......................200
▫Appearance Care.....................200
Fuses — Power Distribution Center..........203
Vehicle Storage........................208
Replacement Bulbs......................211
▫Interior Light Bulbs....................211
▫Exterior Light Bulbs — Convertible Models . . . 211
▫Exterior Light Bulbs — Coupe Models......212
Exterior Light Bulb Service................212
166 MAINTAINING YOUR VEHICLE
Refrigerant Recovery and Recycling
R-134a Air Conditioning Refrigerant is a hydrofluorocar-
bon (HFC) that is endorsed by the Environmental Pro-
tection Agency and is an ozone-saving product. How-
ever, the manufacturer recommends that air conditioning
service be performed by dealers or other service facilities
using recovery and recycling equipment.
NOTE:Use only manufacturer approved A/C System
Sealers, Stop Leak Products, Seal Conditioners, Compres-
sor Oil, or Refrigerants.
Power Steering (Pump and Reservoir)
WARNING!
Fluid level should be checked with the engine off to
prevent injury from moving parts. Do not overfill.
Use only the manufacturer’s recommended fluid.
Refer to Recommended Fluids, Lubricants and
Genuine Parts for correct fluid type.
Check power steering fluid level at intervals as specified
in the maintenance schedules.
During scheduled maintenance, check the power steering
fluid level at the power steering fluid reservoir.
The fluid should be checked HOT with the engine OFF.
MAINTAINING YOUR VEHICLE 185
7
Before removing the reservoir cap, wipe the outside of
the cap and reservoir so that no dirt can fall into the
reservoir.
All power steering pumps have a dipstick. Fluid level
should be maintained at the proper level indicated on the
dipstick. If necessary, add fluid to restore to the proper
indicated level. With a clean cloth, wipe any spilled fluid
from all surfaces. Only petroleum fluids specially formu-
lated for minimum effect on the rubber hoses should be
used. Use only the manufacturer’s recommended fluid.
Refer to Recommended Fluids, Lubricants and Genuine
Parts for the correct fluid type.
Body Lubrication
Locks and all body pivot points, including such items as
seat tracks, doors, liftgate and hood hinges, should be
lubricated periodically to assure quiet, easy operation
and to protect against rust and wear. Prior to the appli-
cation of any lubricant, the parts concerned should bewiped clean to remove dust and grit; after lubricating
excess oil and grease should be removed. Particular
attention should also be given to hood latching compo-
nents to insure proper function. When performing other
underhood services, the hood latch, release mechanism
and safety catch should be cleaned and lubricated.
The external lock cylinders should be lubricated twice a
year, preferably in the fall and spring. Apply a small
amount of a high quality lubricant such as MoparLock
Cylinder Lubricant or equivalent directly into the lock
cylinder.
Front and Rear Suspension Ball Joints
Your vehicle has suspension ball joints that require
periodic servicing. These ball joints should be inspected
whenever servicing a vehicle for other reasons.
186 MAINTAINING YOUR VEHICLE
Brake, Power Steering, and Fuel System Hoses
When servicing the vehicle for scheduled maintenance,
inspect surface of hoses and nylon tubing for evidence of
heat and mechanical damage. Hard and brittle rubber,
cracking, checking, tears, cuts, abrasion, and excessive
swelling suggest deterioration of the rubber. Particular
attention should be made to examining those hose sur-
faces nearest to high heat sources, such as the exhaust
manifold.
Inspect all hose clamps and couplings to make sure they
are secure and no leaks are present.
Insure nylon tubing in these areas has not melted or
collapsed.
NOTE:Often, fluids are used during assembly plant
operations to ease the assembly of hoses to couplings.
Therefore, oil wetness at the hose-coupling area is not
necessarily an indication of leakage. Actual dripping ofhot fluid when systems are under pressure (during
vehicle operation) should be noted before hose is re-
placed based on leakage.
High pressure fuel system hoses have unique material
characteristics that provide adequate sealing and resist
attack by deteriorated gasoline.
Use only manufacturer specified hoses or their equiva-
lent in material and specification, in any fuel system
servicing. It is mandatory to replace all clamps that have
been loosened or removed during service.
NOTE:Inspection of brake hoses should be done when-
ever the brake system is serviced and at every engine oil
change. If there is any evidence of cracking, scuffing, or
worn spots, the hose should be replaced immediately!
Eventual deterioration of the hose can take place with
possible burst failure.
196 MAINTAINING YOUR VEHICLE
Chassis
Component Fluid, Lubricant, or Genuine Part
Transmission Mopar Synthetic Manual Transmission Lubricant SAE 75W-85 (Castrol Syn-
torq LT 75W/85)
Rear Axle Mopar Synthetic Gear and Axle Lubricant SAE 75W-140 or equivalent, with
Limited Slip Additive Friction Modifier
Brake Master Cylinder MoparBrake & Clutch Fluid DOT 4 Motor Vehicle or equivalent.
Power Steering Reservoir MoparATF+4 Automatic Transmission Fluid or equivalent.
222 MAINTAINING YOUR VEHICLE
At Each Stop for Fuel
•Check the engine oil level about 5 minutes after a fully
warmed engine is shut off. Checking the oil level while
the vehicle is on level ground will improve the accu-
racy of the oil level reading. Add oil only when the
level is at or below the ADD or MIN mark.
•Check the windshield washer solvent and add if
required.
Once a Month
•Check tire pressure and look for unusual wear or
damage.
•Inspect the battery and clean and tighten the terminals
as required.
•Check the fluid levels of coolant reservoir, brake
master cylinder, power steering and transmission and
add as needed.
•Check all lights and all other electrical items for correct
operation.
At Each Oil Change
•Change the engine oil filter.
•Inspect the exhaust system.
NOTE:Also inspect the exhaust system if you notice a
change in the sound of the exhaust system, or if the
exhaust fumes can be detected inside the vehicle.
•Inspect the brake hoses.
•Inspect the suspension components.
•Lubricate door hinges and check springs.
•Check the engine coolant level, hoses, and clamps.
•Check power steering fluid level.
228 MAINTENANCE SCHEDULES
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S
Emergency Starting..................... 158
Gas Caution.......................... 181
Jump Starting......................... 158
Keyless Transmitter Replacement............ 20
Bearings.............................. 200
Belt System, Six Point..................... 35
Belts, Drive............................ 176
Belts, Seat.............................. 29
Body Damage.......................... 201
Body Mechanism Lubrication............186,187
Body Mechanisms....................... 188
Boot, Convertible Top...................61,66
B-Pillar Location........................ 134
Brake, Parking.......................... 124
Brake System........................125,195
Anti-Lock........................... 125
Fluid Check.......................197,222
Hoses.............................. 196
Master Cylinder....................... 197Warning Light......................... 95
Break-In Recommendations, New Vehicle.....52,129
Bulb Replacement....................... 212
Bulbs, Light......................... 211,212
Capacities, Antifreeze (Engine Coolant)........ 220
Capacities, Fluid........................ 220
Capacity, Cargo Weight................... 153
Caps, Filler
Power Steering........................ 185
Radiator (Coolant Pressure)............... 192
Car Washes............................ 202
Carbon Monoxide Warning...............53,151
Cargo Compartment
Capacity............................ 153
Carpeting............................. 202
Catalytic Converter...................... 176
CD Player...........................99,102
CD Player Maintenance................... 110
INDEX 251
10
Engine Oil Viscosity...................174,220
Engine Oil Viscosity Chart................. 174
Exhaust Gas Caution..............26,53,151,189
Exhaust System......................... 189
Exterior Lights....................... 211,212
Fan .................................. 112
Filters
Air Cleaner.......................... 179
Engine Oil........................... 221
Flashers
Hazard Warning.....................91,156
Turn Signal........................... 91
Flash-To-Pass........................... 80
Floor Console........................... 68
Fluid Capacities......................... 220
Fluid Leaks............................. 54
Fluid Level Checks
Brake............................197,222Capacities........................... 220
Cooling System....................... 190
Engine Oil........................... 172
Manual Transmission................... 199
Power Steering.....................185,222
Fluids................................ 221
Fluids, Lubricants and Genuine Parts.......... 221
Fog Lights.........................78,79,94
Four-Way Hazard Flasher.................. 156
Freeing A Stuck Vehicle................... 163
Fuel................................. 148
Adding............................. 152
Additives............................ 150
Clean Air............................ 149
Gasoline............................ 148
Gauge............................... 97
Octane Rating........................ 221
Requirements......................148,220
Tank Capacity........................ 220
254 INDEX