2006 DODGE VIPER bulb

REPLACEMENT BULBS
Interior Light Bulbs
Message Center Indicators.................. 103
Cluster................................ 103
Gauge Pack............................ 103
Heater Control........................... 37
Interior Light..........................212–2
Courtesy Footwell Lights................... 194
Exterior Light Bulbs — Convertible Models
Headlight-Low/High Beam.... Servicedatdealer only
Aux. Headlight-High Beam......... (HB3A) 9005XS
Front Park/Turn......................3157AK
Fog Light....................... (H10U)9145
Front Sidemarker.......................2886X
Center Stop Light.......... 16LED(notserviceable)
Rear Tail/Stop..........................3157
Rear Tail Light.......................... 194
Rear Marker Light........................ 194
Back up Light..........................3157
Rear Turn Light.......................3457AK
License................................ 168
NOTE:You will note that upon turning the (HID) High
Intensity Discharge Headlamp Bulbs on, there is a blue
hue to the lamps. This diminishes and becomes more
white after approximately 10 seconds as the system
charges.
MAINTAINING YOUR VEHICLE 211
7

Exterior Light Bulbs — Coupe Models
Headlight-Low/High Beam.... Servicedatdealer only
Aux. Headlight-High Beam.........(HB3A) 9005XS
Front Park/Turn......................3157AK
Fog Light.......................(H10 U) 9145
Front Sidemarker.......................2886X
Center Stop Light.......... 16LED(not serviceable)
Rear Tail/Stop/Turn.....................3157
Rear Marker Light........................ 194
Back up Light..........................3157
License................................ 168
Rear Compartment Light................... 168
NOTE:You will note that upon turning the (HID) High
Intensity Discharge Headlamp Bulbs on, there is a blue
hue to the lamps. This diminishes and becomes more
white after approximately 10 seconds as the system
charges.
EXTERIOR LIGHT BULB SERVICE
Headlight, Parking, Front Park, Turn Signal, Front
Sidemarker and Front Fog Light Removal
1. Remove the splash shield.
212 MAINTAINING YOUR VEHICLE

2. Twist off sockets counter-clockwise and pull out bulbs
from the socket, install the new bulbs, and reinstall the
bulb and socket assembly. Replace the splash shield.
NOTE:On vehicles equipped with High Intensity Dis-
charge Headlights (HID), when the headlights are turned
on there is a blue hue to the lights. This diminishes and
becomes more white after approximately 10 seconds, as
the system charges.
MAINTAINING YOUR VEHICLE 213
7

High Intensity Discharge Headlights (HID)
The headlights are a type of high voltage discharge tube.
High voltage can remain in the circuit even with the
headlight switch off and the key removed.Because of
this, you should not attempt to service a headlight bulb
yourself. If a headlight bulb fails, take your vehicle to
an authorized dealer for service.
WARNING!
A transient high tension occurs at the bulb sockets of
High Intensity Discharge (HID) headlights when the
headlight switch is turned ON. It may cause serious
electrical shock or electrocution if not serviced prop-
erly. See your authorized dealer for service.
NOTE:If High Intensity Discharge (HID) lights are not
working, recycle the headlight switch 4 times to see if it
will restrike.
Tail, Tail/Stop, and Marker Lamp Bulb
Replacement
1. Open the trunk. Remove two access panel fasteners.
Remove the access panel.
214 MAINTAINING YOUR VEHICLE

2. Twist sockets counter-clockwise to pull out bulbs.
Replace tail, tail/stop, or marker lamp bulb.
3. Reinstall the appropriate bulb and socket assembly.
Replace the access panel. Close the trunk.Backup and Rear Turn Signal Lamp Bulb
Replacement
1. Open the trunk. Remove two access panel fasteners.
Remove the access panel.
MAINTAINING YOUR VEHICLE 215
7

3. Twist sockets of the three bulbs shown counter-
clockwise. Disconnect bulb and socket assemblies from
the upper lamp assembly. Pull the upper lamp assembly
clear in order to access backup and rear turn signal lamp
bulbs.4. Replace the backup or rear turn signal lamp bulb.
Reinstall the appropriate bulb and socket assembly. Re-
install the three bulb and socket assemblies in the upper
lamp assembly. Reinstall the upper lamp assembly. Re-
place the access panel. Close the trunk.
MAINTAINING YOUR VEHICLE 217
7

License Plate Light
Twist off sockets counter-clockwise and pull out bulbs.
Replace as required.
218 MAINTAINING YOUR VEHICLE

Emergency Starting..................... 158
Gas Caution.......................... 181
Jump Starting......................... 158
Keyless Transmitter Replacement............ 20
Bearings.............................. 200
Belt System, Six Point..................... 35
Belts, Drive............................ 176
Belts, Seat.............................. 29
Body Damage.......................... 201
Body Mechanism Lubrication............186,187
Body Mechanisms....................... 188
Boot, Convertible Top...................61,66
B-Pillar Location........................ 134
Brake, Parking.......................... 124
Brake System........................125,195
Anti-Lock........................... 125
Fluid Check.......................197,222
Hoses.............................. 196
Master Cylinder....................... 197Warning Light......................... 95
Break-In Recommendations, New Vehicle.....52,129
Bulb Replacement....................... 212
Bulbs, Light......................... 211,212
Capacities, Antifreeze (Engine Coolant)........ 220
Capacities, Fluid........................ 220
Capacity, Cargo Weight................... 153
Caps, Filler
Power Steering........................ 185
Radiator (Coolant Pressure)............... 192
Car Washes............................ 202
Carbon Monoxide Warning...............53,151
Cargo Compartment
Capacity............................ 153
Carpeting............................. 202
Catalytic Converter...................... 176
CD Player...........................99,102
CD Player Maintenance................... 110
INDEX 251
10