2006 DODGE STRATUS SEDAN adding oil

▫Fuel Requirements....................175
▫Selection Of Engine Oil For Flexible Fuel
Vehicles (E-85) And Gasoline Vehicles.......176
▫Starting............................176
▫Cruising Range.......................176
▫Replacement Parts.....................176
▫Maintenance.........................176

Adding Fuel..........................177
▫Fuel Filler Cap (Gas Cap)...............177

Vehicle Loading.......................178

Trailer Towing........................178
▫Common Towing Definitions.............178
▫Trailer Hitch Classification...............180
▫Trailer Towing Weights (Maximum Trailer
Weight Ratings)......................181
▫Trailer And Tongue Weight..............181
▫Towing Requirements..................182
▫Towing Tips.........................186
STARTING AND OPERATING 139
5

WARNING!
You can be badly injured working on or around a
motor vehicle. Do only that service work for which
you have the knowledge and the proper equipment.
If you have any doubt about your ability to perform
a service job, take your vehicle to a competent
mechanic.
MAINTENANCE PROCEDURES
The pages that follow contain therequiredmaintenance
services determined by the engineers who designed your
vehicle.
Besides the maintenance items for which there are fixed
maintenance intervals, there are other items that should
operate satisfactorily without periodic maintenance.
However, if a malfunction of these items does occur, it
could adversely affect the engine or vehicle performance.
These items should be inspected if a malfunction is
observed or suspected.
Engine Oil
Checking Oil Level
To assure proper lubrication of your vehicle’s engine, the
engine oil must be maintained, at the correct level. Check
the oil level at regular intervals, such as every fuel stop.
The best time to check the oil level is about 5 minutes
after a fully warmed engine is shut off or before starting
the engine after it has sat overnight.
Checking the oil while the vehicle is on level ground will
improve the accuracy of the oil level readings. Maintain
the oil level between the MIN and MAX markings on the
dipstick. Adding one quart of oil when the reading is at
the MIN mark will result in a MAX reading on these
engines.
210 MAINTAINING YOUR VEHICLE

Fluid level should be maintained at the proper level
indicated on the side of the reservoir. If necessary, add
fluid to restore the proper indicated level. With a clean
cloth, wipe any spilled fluid from all surfaces. Refer to
Fluids, Lubricants, and Genuine Parts for correct fluid
type.
Suspension Ball Joints
There are two upper front and rear suspension ball joints.
Inspect these ball joints whenever under vehicle service is
done. If the seals are damaged, the ball joint should be
replaced.
Body Mechanism Lubrication
Locks and all body pivot points, including such items as
seat tracks, doors, liftgate and hood hinges, should be
lubricated periodically to assure quiet, easy operation
and to protect against rust and wear. Prior to the appli-
cation of any lubricant, the parts concerned should be
wiped clean to remove dust and grit; after lubricating
excess oil and grease should be removed. Particular
attention should also be given to hood latching compo-
nents to insure proper function. When performing otherunderhood services, the hood latch, release mechanism
and safety catch should be cleaned and lubricated.
Hood Latch
When performing other under hood services, the hood
latch release mechanism and safety catch should be
inspected, cleaned, and lubricated.
It is important to maintain proper lubrication to insure
that the hood mechanisms work properly and safely.
Multi-Purpose Lubricant, NLGI Grade 2, should be ap-
plied sparingly to all pivot and sliding contact areas.
External Lock Cylinders
Lubricate the external lock cylinders twice a year, prefer-
ably in the fall and spring. Apply a small amount of
lubricant, such as Mopar Lock Cylinder Lubricant or
equivalent directly into the lock cylinder (avoid excess
lubricant). Insert the key into the lock cylinder and rotate
from the unlocked to the locked position; without adding
more lubricant. Repeat this procedure three or four times.
Wipe all the lubricant off the key with a clean cloth, to
avoid soiling clothing.
220 MAINTAINING YOUR VEHICLE

Oil Synthetic......................... 213
Overheating......................... 190
Timing Belt.......................... 216
Engine Oil Viscosity..................... 246
Entry System, Illuminated................. 11
Exhaust Gas Caution...............45,174,223
Exhaust System........................ 223
Exterior Light Service.................... 241
Filters
Air Cleaner.......................... 215
Automatic Transaxle................... 232
Engine Fuel......................... 215
Engine Oil.......................214,247
Engine Oil Disposal................... 214
Flashers
Hazard Warning...................... 190
Turn Signal.......................... 84
Flash-To-Pass........................... 63
Flat Tire Changing...................... 191
Flexible Fuel Vehicles
Cruising Range....................... 176
Engine Oil.......................... 176Fuel Requirements.................... 175
Maintenance......................... 176
Replacement Parts.................... 176
Starting............................ 176
Fluid, Brake........................... 248
Fluid Capacities........................ 246
Fluid Leaks............................ 46
Fluid Level Checks
Automatic Transaxle................... 231
Capacities........................... 246
Cooling System....................... 223
Engine Oil.......................... 210
Power Steering....................... 219
Fluids............................... 247
Fluids, Lubricants and Genuine Parts........ 247
Fog Light Service....................... 244
Fog Lights........................62,85,244
Folding Rear Seat....................... 57
Freeing A Stuck Vehicle.................. 201
Fuel................................. 171
Adding............................. 177
Additives........................... 173
Clean Air........................... 172
282 INDEX

Vanity Mirrors.......................... 54
Vehicle Identification Number (VIN).......... 6
Vehicle Loading.....................157,178
Vehicle Modifications/Alterations............ 6
Vehicle Storage......................... 240
Vehicle Theft Alarm (Security Alarm)......... 19
Vinyl Trim............................ 235
Viscosity, Engine Oil..................... 246
Voltmeter.............................. 84
Warning, Door Ajar...................... 13
Warning Flasher, Hazard................. 190
Warnings and Cautions.................... 6
Warranty Information.................... 272
Washer, Adding Fluid................... 222Washers, Windshield..................63,222
Washing Vehicle........................ 233
Waxing and Polishing................... 233
Wheel Alignment and Balance............. 167
Wind Buffeting.......................22,75
Window Airbag (Side Curtain)............30,35
Window Fogging....................... 126
Windows.............................. 21
Power.............................. 21
Windshield Washers...................63,222
Windshield Wipers.................62,63,221
Wiper Blade Replacement................. 222
Wipers, Intermittent...................... 64
Wood Trim Cleaning.................... 236
INDEX 291
10