2006 DODGE POWER WAGON open hood

▫Exterior Mirrors Folding Feature...........86
▫Electronic Power Mirrors — If Equipped......87
▫Electric Rear Window Defroster And Heated
Sideview Mirrors — If Equipped...........88
▫Trailer Towing Mirrors — If Equipped.......88

Hands–Free Communication (UConnect™)
— If Equipped..........................90
▫Operation............................92
▫Phone Call Features....................98
▫UConnect™ System Features.............101
▫Advanced Phone Connectivity............105
▫Things You Should Know About Your
UConnect™ System....................107

Seats................................113▫40-20-40 Front Seat....................114
▫Reclining Seats.......................115
▫Adjustable Head Restraints..............115
▫Manual Rotary Lumbar Support Adjustment
— If Equipped.......................116
▫Power Seats — If Equipped..............117
▫Heated Seats — If Equipped.............118

To Open And Close The Hood.............119

Lights...............................121
▫Interior Lights.......................121
▫Battery Saver........................122
▫Headlamp Delay......................123
▫Headlights, Parking Lights, Panel Lights.....123
76 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

the switch a third time will turn the heated seats OFF. If
you do not purposefully turn the switch OFF, the seat
heating level will automatically change to the next lower
level, or OFF. The High heat level operates for 45 minutes
(approximate), the Low heat level operates for 60 min-
utes (approximate). The seat heat will also turn OFF
when the ignition is turned OFF. Both of the indicators
ON identifies High heat level. The lower indicator On
only, identifies Low heat level. Flashing indicator lights
on the switch indicate that the Heated Seat System needs
servicing.TO OPEN AND CLOSE THE HOOD
To open the hood, two latches must be released. First pull
the hood release lever located below the steering wheel at
the base of the instrument panel. Once the hood is
Hood Release Lever
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 119
3

released you must reach into the opening beneath the
center of the grille and push up the latch to release the
safety catch before raising the hood.
To prevent possible damage, do not slam the hood to
close it. Use a firm downward push at the front center of
the hood to ensure that both latches engage.WARNING!
If the hood is not fully latched, it could fly up when
the vehicle is moving and block your forward vision.
Be sure all hood latches are latched fully before
driving.
Secondary Latch
120 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

WARNING!
The warning words “DO NOT OPEN HOT” on the
radiator pressure cap are a safety precaution. Heat
causes pressure to build up in the cooling system. To
prevent scalding or injury, do not remove the pres-
sure cap.
Hoses And Vacuum/Vapor Harnesses
Inspect surfaces of hoses and nylon tubing for evidence
of heat and mechanical damage. Hard or soft spots,
brittle rubber, cracking, tears, cuts, abrasions, and exces-
sive swelling indicate deterioration of the rubber.
Pay particular attention to those hoses nearest to high
heat sources such as the exhaust manifold. Inspect hose
routing to be sure hoses do not come in contact with any
heat source or moving component which may cause heat
damage or mechanical wear.Insure nylon tubing in these areas has not melted or
collapsed.
Inspect all hose connections such as clamps and cou-
plings to make sure they are secure and no leaks are
present.
Components should be replaced immediately if there is
any evidence of wear or damage that could cause failure.
Brake System
Power Disc Brakes (front and rear)
Disc brakes do not require adjustment; however, several
hard stops during the break-in period are recommended
to seat the linings and wear off any foreign material.
Brake Master Cylinder
The fluid level of the master cylinder should be checked
when performing under the hood service, or immedi-
ately if the brake system warning lamp indicates system
failure.
MAINTAINING YOUR VEHICLE 389
7

BULB REPLACEMENT
Headlight (Halogen)/Front Park and Turn Lights
CAUTION!
This is a halogen bulb. Avoid touching the glass
with your fingers. Reduced bulb life will result.
1. Open the hood
2. Remove the two (2) bolts from the front of the head-
light housing.
Front Headlight Housing Bolts
MAINTAINING YOUR VEHICLE 407
7

Fluid ............................... 419
Transmission
Automatic........................280,393
Fluid ............................... 419
Maintenance.......................392,393
Manual........................277,285,392
Shifting ..........................280,286
Transmitter, Garage Door Opener............ 142
Tread Wear Indicators..................... 311
Trip Computer.......................... 135
Trip Odometer.......................171,175
Turn Signals...................125,168,407,410
Underhood Fuses........................ 405
Universal Transmitter..................... 142
Variance, Compass....................... 140
Vehicle Identification Number................ 6
Vehicle Loading......................302,324Vehicle Modifications/Alterations.............. 7
Vehicle Storage......................... 405
Voltmeter............................. 168
Warning Lights (Instrument Cluster Description) . 168
Warnings and Cautions..................... 5
Warranty Information..................... 447
Washers, Windshield..................128,383
Washing Vehicle......................... 401
Wheel Alignment and Balance............... 313
Wheel and Wheel Trim.................... 402
Wheel Changing........................ 349
Wheel Flares............................ 82
Wheel Mounting........................ 350
Wheel Nut Torque....................353,355
Wheels................................ 83
Winch .............................. 81,256
Accessories.......................... 260
Operation........................... 261
466 INDEX