For additional assistance, the winched vehicle can be
slowly driven while being pulled by the winch. Continue
pulling until the vehicle is on stable ground. If you are
able to drive the vehicle, the winching operation is
complete.NOTE:Avoid overheating the winch motor. For ex-
tended winching, stop at reasonable intervals to allow
the winch motor to cool down.
NOTE: What to look for under load:The wire rope
must always spool onto the drum as indicated by the
drum rotation decal on the winch. As you power-in,
make sure the wire rope winds evenly and tightly on the
drum. This prevents the outer wire wraps from drawing
into the inner wraps, binding and damaging the wire
rope. Avoid shock loads by using the control switch
intermittently to take up wire rope slack. Shock loads can
momentarily far exceed the winch and wire rope ratings.
During side pulls the wire rope tends to stack up at one
end of the drum. This stack can become large enough to
cause serious damage to the winch. So, line up pulls as
straight ahead as possible and stop winching if the wire
rope comes close to the tie rods or mounting plate. To fix
Using The Remote Control
270 STARTING AND OPERATING
NOTE: How to spool under no load:Arrange the
remote control lead so it cannot be caught in the winch.
Arrange the wire rope so it will not kink or tangle when
spooled. Be sure any wire rope already on the spooling
drum is wound tightly and evenly layered. Tighten and
straighten the layer if necessary. Keep the wire rope
under light tension and spool the wire rope back and
onto the winch drum in even layers. Stop frequently to
tighten and straighten the layers as necessary. Repeat this
process until the winch hook is the same distance as the
full length of the remote control from the winch. Pinch
the hook between your thumb and forefinger and attach
the hook strap. Hold the hook strap between the thumb
and forefinger to keep tension on the wire rope. Walk the
wire rope towards the fairlead, carefully spooling in the
remaining wire rope. By pulsing the remote control
switch.
19. Store the hook on the most outboard loop of the tow
hook.20. Disconnect remote control. Disconnect the remote
control cord from the control box and store in a clean and
dry place. Winching operations are now complete. Put
the cap on the solenoid plug-in.
NOTE:Always store the remote control in a protected,
clean, dry area.
272 STARTING AND OPERATING
Programming Transmitters..............143,147
Radial Ply Tires......................... 308
Radiator Cap (Coolant Pressure Cap).......385,388
Radio Operation...................177,182,195
Radio Remote Controls.................... 210
Radio, Satellite.......................... 209
Radio (Sound Systems)..............177,182,195
Ramp Travel Index....................... 236
Rear Axle............................. 391
Rear Wheel Bearings..................... 396
Reclining Front Seats..................... 115
Recorder, Event Data...................... 56
Recreational Towing...................... 341
Shifting into Transfer Case Neutral (N)....... 342
Shifting out of Transfer Case Neutral (N)..... 343
Reformulated Gasoline.................... 317
Refrigerant............................ 380
Relays and Flashers...................... 405Reminder, Seat Belt....................... 43
Remote Keyless Entry..................... 22
Remote Sound System Controls.............. 210
Replacement Tires....................... 312
Reporting Safety Defects................... 447
Restraint, Head......................... 115
Restraints, Child....................... 57,64
RideHeight ............................ 81
Rotation, Tires.......................... 316
Safety Checks Inside Vehicle................. 72
Safety Checks Outside Vehicle............... 72
Safety Defects, Reporting.................. 447
Safety Information, Tire................... 296
Safety Tips............................. 70
Satellite Radio.......................... 209
Schedule, Maintenance.................... 422
Seat Belt Maintenance.................... 404
Seat Belt Reminder....................... 43
462 INDEX