²The TPMS does not monitor the temporary spare tire.
²The TPMS should not be used as a tire pressure gauge
while adjusting your tire pressure.
²Driving on a significantly under-inflated tire causes
the tire to overheat and can lead to tire failure.
Under-inflation also reduces fuel efficiency and tire
tread life, and may affect the vehicle's handling and
stopping ability.
²The TPMS is not intended to replace normal tire care
and maintenance, or to provide warning of a tire
failure or condition. It is the driver 's responsibility to
maintain correct tire pressure, even if under-inflation
has not reached the level to trigger illumination of the
Tire Pressure Monitoring Telltale light.
Check TPM System Message
The Tire Pressure Monitoring Telltale Light will
flash on and off for 60 seconds and an audible
chime will sound when a system fault is detected.
The flash cycle will repeat every ten minutes, without an
audible chime until the fault condition no longer exists.The EVIC will display the ªCHECK TPM SYSTEMº
message for 3 seconds. In addition, a graphic will be
displayed indicating which of the Tire Pressure Monitor-
ing Sensor(s) is not being received.
If the ignition key is cycled, this sequence will repeat,
providing the system fault still exists. If the system fault
no longer exists, the Tire Pressure Monitoring Telltale
Light will no longer flash, and the9CHECK TPM SYS-
TEM9text message will no longer display.
Check TPM System Display
208 STARTING AND OPERATING
²Make sure that the radiator and coolant recovery
bottle overflow hoses are not kinked or obstructed.
²Keep the front of the radiator clean. If your vehicle is
equipped with air conditioning, keep the front of the
condenser clean, also.
²Do not change the thermostat for summer or winter
operation. If replacement is ever necessary, install
ONLY the correct type thermostat. Other designs may
result in unsatisfactory coolant performance, poor gas
mileage, and increased emissions.
Hoses And Vacuum/Vapor Harnesses
Inspect surfaces of hoses and nylon tubing for evidence
of heat and mechanical damage. Hard or soft spots,
brittle rubber, cracking, tears, cuts, abrasions, and exces-
sive swelling indicate deterioration of the rubber
Pay particular attention to the hoses nearest to high heat
sources such as the exhaust manifold. Inspect hose rout-
ing to be sure hoses do not touch any heat source or
moving component that may cause heat damage or
mechanical wear.Insure nylon tubing in these areas has not melted or
collapsed
Inspect all hose connections such as clamps and cou-
plings to make sure the are secure and no leaks are
present.
Components should be replaced immediately if there is
any evidence of degradation that could cause failure.
Fuel System Connections
Electronic Fuel Injection high pressure fuel systems are
designed with tubes and special connects, connections
and clamps which have unique material characteristics to
provide adequate sealing and resist attack by deterio-
rated gasoline.
You are urged to use only the manufactures-specified
tubes, connections and clamps, or their equivalent in
material and specification, in any fuel system servicing.
Brake System
In order to assure brake system performance, all brake
system components should be inspected periodically.
Suggested service intervals can be found in the Mainte-
nance Section.
260 MAINTAINING YOUR VEHICLE
NOTE:IfANYof these apply to you then change your
engine oil every 3,000 miles (5 000 km) or 3 months,
whichever comes first and follow schedule ªBº of the
9Maintenance Schedules9section of this manual.
NOTE:IfANYof these apply to you then change your
coolant every 102,000 miles (170 000 km) or 60 months,
whichever comes first and follow schedule ªBº of the
9Maintenance Schedules9section of this manual.
Second is ScheduleªAº. It is for vehicles that are not
operated under any of the conditions listed under Sched-
ule9B9.
Use the schedule that best describes your driving condi-
tions. Where time and mileage are listed, follow the
interval that occurs first.
NOTE:Under no circumstances should oil change
intervals exceed 6000 miles (10 000 km) or 6 months
whichever comes first.
CAUTION!
Failure to perform the required maintenance items
may result in damage to the vehicle.
At Each Stop for Fuel
²
Check the engine oil level about 5 minutes after a fully
warmed engine is shut off. Checking the oil level while
the vehicle is on level ground will improve the accu-
racy of the oil level reading. Add oil only when the
level is at or below the ADD or MIN mark.
²Check the windshield washer solvent and add, if
required.
Once a Month
²
Check tire pressure and look for unusual wear or
damage.
²Inspect the battery and clean and tighten the terminals
as required.
MAINTENANCE SCHEDULES 283
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S
ABS (Anti-Lock Brake System)............. 186
Adding Engine Coolant (Antifreeze)......... 257
Adding Fuel.......................... 214
Adding Washer Fluid..................82,102
Additives, Fuel........................ 212
Air Cleaner, Engine (Engine Air Cleaner Filter) . 251
Air Conditioner Maintenance.............. 253
Air Conditioning Controls................ 164
Air Conditioning, Operating Tips........... 168
Air Conditioning Refrigerant.............. 253
Air Conditioning System..............164,253
Air Pressure, Tires...................... 199
Airbag................................ 39
Airbag Deployment...................... 48
Airbag Light......................50,61,112
Airbag Maintenance...................... 50
Airbag, Side........................... 47
Alarm System (Security Alarm)..........24,112
Alignment and Balance.................. 205
All Wheel Drive (AWD).................. 183
Alterations/Modifications, Vehicle............ 6
Antenna, Satellite Radio.................. 161
Antifreeze (Engine Coolant).........256,278,279Capacities........................... 278
Disposal............................ 258
Anti-Lock Brake System (ABS)...........86,186
Anti-Theft Security Alarm (Theft Alarm)...... 24
Appearance Care....................... 265
Automatic Door Locks..................16,17
Automatic Transaxle...........9,174,176,229,263
Fluid Level Check..................... 263
Interlock System....................14,177
Overheating......................... 229
Selection Of Lubricant................. 263
Shifting............................ 177
Special Additives..................... 264
Autostick............................. 179
Ball Joints............................ 254
Battery............................... 251
Keyless Transmitter Replacement (RKE)..... 23
Belts, Drive........................... 249
Beverage Cooler........................ 103
Body Mechanism Lubrication.............. 254
B-Pillar Location....................... 194
Brake Assist System...................... 87
308 INDEX
Latches
Hood............................... 76
Lead Free Gasoline...................... 211
Life of Tires........................... 204
Liftgate (Sedan)......................... 26
Liftgate Window Wiper/Washer............ 101
Light Bulbs........................... 272
Lights..............................61,77
Airbag.........................50,61,112
Back-Up............................ 274
Brake Warning....................... 117
Bulb Replacement..................... 273
Cargo ............................... 96
Center Mounted Stop.................. 277
Daytime Running...................... 78
Dimmer Switch, Headlight............... 77
Electronic Stability Program (ESP) Indicator . . 88
Engine Temperature Warning............ 113
Fog ...........................79,116,273
Headlight Switch...................... 78
Headlights........................... 78
High Beam Indicator................... 117
Instrument Cluster..................... 78License............................. 276
Lights On Reminder.................... 79
Low Fuel........................... 112
Malfunction Indicator (Check Engine)...... 114
Map Reading......................... 77
Oil Pressure......................... 112
Rear Fog............................ 119
Seat Belt Reminder.................... 112
Security Alarm (Theft Alarm)............. 25
Theft Alarm (Security Alarm)............ 112
Traction Control....................... 88
Turn Signal...................77,79,116,274
Voltage............................. 112
Warning (Instrument Cluster Description) . . . 111
Loading Vehicle........................ 217
Tires ............................... 194
Locks
Child Protection....................... 18
Door............................... 14
Power Door.......................... 15
Steering Wheel........................ 13
Lubrication, Body....................... 254
Luggage Rack (Roof Rack)................ 102
314 INDEX
Lumbar Support........................ 71
Maintenance Free Battery................. 251
Maintenance, General.................... 245
Maintenance Procedures.................. 245
Maintenance Schedule................... 282
Schedule ªAº........................ 294
Schedule ªBº........................ 285
Malfunction Indicator Light
(Check Engine)...................... 114,243
Manual, Service........................ 303
Manual Transaxle.................174,180,264
Downshifting........................ 182
Fluid Level Check..................264,265
Frequency of Fluid Change...........264,265
Lubricant Selection.................264,265
Map/Reading Lights..................... 77
Master Cylinder (Brakes)................. 262
Mirrors............................... 66
Electric Powered....................... 67
Outside............................. 66
Rearview............................ 66
Vanity.............................. 69Modifications/Alterations, Vehicle............ 6
Monitor, Tire Pressure System............. 206
Mopar Parts........................244,302
Multi-Function Control Lever............... 77
New Vehicle Break-In Period............... 59
Occupant Classification System (OCS)........ 43
Occupant Restraints (Sedan)................ 29
Octane Rating, Gasoline (Fuel)............. 211
Odometer............................. 114
Trip ............................. 114,115
Oil, Engine......................245,248,278
Capacity............................ 278
Change Interval...................... 246
Checking........................245,248
Disposal............................ 248
Filter.............................. 248
Materials Added to.................... 248
Recommendation..................247,278
Synthetic........................... 247
Viscosity............................ 247
Oil Pressure Light...................... 112
INDEX 315
10