2006 CHRYSLER SEBRING CONVERTIBLE instrument panel

Summer Operation
Air conditioned vehicles must be protected with a high-
quality antifreeze coolant to provide proper corrosion
protection and to raise the boiling point of the coolant for
protection against overheating. A 50 % concentration is
recommended.
Winter Operation
The blower air will heat faster in cold weather if you use
only the low blower speeds for the first 10 minutes of
operation. During engine warm up in cold weather, use
the Defrost mode to direct any cold air away from vehicle
occupants. Use of the Recirculate-Air Conditioning Mode
during winter months is not recommended due to the
possibility of window fogging.
NOTE:See Operating Tips chart (for Manual A/C
Control) at the end of this section for suggested control
settings in different weather conditions.
140 UNDERSTANDING YOUR INSTRUMENT PANEL

Operating Tips (Manual A/C Control Only)
UNDERSTANDING YOUR INSTRUMENT PANEL 141
4

Outside Air Intake
Make sure the air intake, directly in front of the wind-
shield, is free of ice, slush, snow or other obstructions
such as leaves. Leaves collected in the air-intake plenum
may reduce air flow and plug the plenum water drains.
Air Intake
142 UNDERSTANDING YOUR INSTRUMENT PANEL

You should not increase the gloss level, especially on top
of the instrument panel top surface. Higher gloss levels
will increase the reflectivity in the windshield that could
decrease visibility under bright light driving conditions.
WARNING!
Do not use volatile solvents for cleaning purposes.
Many are potentially flammable, and if used in
closed areas they may cause respiratory harm.
Leather Seat Care and Cleaning
CAUTION!
Never use polishes, oils, cleaning fluids, solvents,
detergents, or ammonia based cleaners to clean the
leather. The leather has already been pretreated. The
application of any leather conditioner may damage
the factory applied top coat.
Leather is best preserved by regular cleaning with a
damp soft cloth. Small particles of dirt can act as an
abrasive and damage the leather surface and should be
removed immediately with a damp cloth. Stubborn soils
can be removed easily with a soft cloth and Mopar Total
Clean or equivalent. Care should be taken to avoid
soaking the leather with any liquid.
Cleaning Headlights
Your vehicle has plastic headlights that are lighter and
less susceptible to stone breakage than glass headlights.
Plastic is not as scratch resistant as glass and therefore
different lens cleaning procedures must be followed.
To minimize the possibility of scratching the lenses and
reducing light output, avoid wiping with a dry cloth. To
remove road dirt, wash with a mild soap solution fol-
lowed by rinsing.
Do not use abrasive cleaning components, solvents, steel
wool or other aggressive material to clean the lenses.
244 MAINTAINING YOUR VEHICLE

Glass Surfaces
All glass surfaces should be cleaned on a regular basis
with any commercial household-type glass cleaner.
Never use an abrasive type cleaner. Use caution when
cleaning inside rear windows equipped with electric
defrosters. Do not use scrapers or other sharp instru-
ments which may scratch the elements.
Instrument Panel Cover
The instrument panel cover has a low glare surface which
minimizes reflections in the windshield. Do not use
protectants or other products which may cause undesir-
able reflections. Use soap and warm water to restore the
low glare surface.
Cleaning Wood Trim
Your vehicle’s wood trim requires no specific mainte-
nance. Your wood trim can be cleaned as needed using
regularly available automotive interior cleaning and pro-
tecting products. Using a mild soap and water solution is
also acceptable. Excess cleaning materials should be
wiped dry with a soft terry cloth. Any harsh detergents,
abrasives, abrasive cleaners, cleansers, or chemicals
should be avoided, as these will damage the wood trim.
Cleaning Plastic Instrument Cluster Lenses
The lenses in front of the instruments in this vehicle are
molded in clear plastic. When cleaning the lenses, care
must be taken to avoid scratching the plastic.
•Clean with a wet soft rag. A mild soap solution may be
used, but do not use high alcohol content or abrasive
cleaners. If soap is used, wipe clean with a clean damp
rag.
•Dry with a soft tissue.
Seat Belt Maintenance
Do not bleach, dye or clean the belts with chemical
solvents or abrasive cleaners. This will weaken the fabric.
Sun damage will also weaken the fabric.
If the belts need cleaning, use a mild soap solution or
lukewarm water. Do not remove the belts from the
vehicle to wash them.
Replace the belts if they appear frayed or worn or if the
buckles do not work properly.
MAINTAINING YOUR VEHICLE 245
7

FUSES
Underhood Fuses (Power Distribution Center)A Power Distribution Center is located in the engine
compartment, near the air cleaner. This information ap-
plies to vehicles built without the fuse and relay num-
bering embossed on the Power Distribution Center Top
Cover.
Interior Fuses
The fuse access panel is behind the end cover at the left
side of the instrument panel. To remove the panel, pull it
out, as shown.
Power Distribution Center
Fuse Panel Cover
248 MAINTAINING YOUR VEHICLE

Changing A Flat Tire.................... 199
Charging System Light................... 90
Chart, Tire Sizing....................... 160
Check Engine Light
(Malfunction Indicator Light).............. 216
Checking Your Vehicle For Safety............ 43
Child Restraint...................34,36,39,40
Child Restraint Tether Anchors............. 39
Cigar Lighter........................... 99
Circuit Breakers........................ 248
Clean Air Gasoline...................... 178
Cleaning
Glass.............................. 245
Headlights.......................... 244
Instrument Panel..................... 245
WoodTrim .......................... 245
Climate Control........................ 129
Clock................................. 99
Coin Holder........................... 55
Compact Disc (CD) Changer.............. 120
Compact Disc (CD) Maintenance........... 128
Compact Disc (CD) Player.............100,105
Compact Spare Tire..................... 170Compass.............................. 95
Compass Calibration..................... 96
Console............................... 55
Console, Floor.......................... 55
Contract, Service....................... 282
Convertible............................ 47
Convertible Boot........................ 50
Convertible Top......................... 47
Convertible Top Maintenance.............. 246
Coolant Pressure Cap.................... 234
Cooling System........................ 232
Adding Coolant (Antifreeze)............. 233
Coolant Capacity..................... 257
Coolant Level.....................232,235
Disposal of Used Coolant............... 234
Drain, Flush, and Refill................. 232
Inspection........................... 232
Points to Remember................... 235
Pressure Cap........................ 234
Radiator Cap........................ 234
Rubber and Plastic Components.......... 236
Selection of Coolant (Antifreeze)....233,257,258
Corrosion Protection.................... 241
290 INDEX

Cleaning............................ 244
High Beam.........................69,90
High Beam/Low Beam Select Switch....... 69
Passing............................. 69
Switch.............................. 67
Time Delay........................68,69
Heater............................129,136
Heater, Engine Block.................... 148
High Beam Indicator..................... 90
Hitches
Trailer Towing....................... 187
HomeLink(Garage Door Opener) Transmitter . 75
Hood Prop............................ 64
Hood Release.......................... 63
Hoses............................236,239
Ignition
Key ................................. 9
Lock................................ 9
Illuminated Entry....................... 12
Immobilizer (Sentry Key).................. 10
Infant Restraint......................... 35
Inside Rearview Mirror................... 56Instrument Cluster..................86,87,88
Instrument Panel and Controls.............. 85
Instrument Panel Cover.................. 245
Instrument Panel Lens Cleaning............ 245
Interior Fuses.......................... 248
Interior Lighting........................ 65
Interior Lights........................65,66
Introduction............................ 4
Jack Location.......................... 200
Jack Operation......................... 200
Jump Starting......................... 204
Key, Programming....................... 11
Key, Replacement........................ 11
Key, Sentry (Immobilizer).................. 10
Key-In Reminder......................... 9
Keyless Entry System..................... 15
Keys.................................. 9
Lap/Shoulder Belts...................... 23
LATCH (Lower Anchors and
Tether for CHildren)...................37,39
294 INDEX