2006 CHRYSLER PACIFICA boot

WARNING!
Fluid level should be checked on a level surface and
with the engine off to prevent injury from moving
parts and to insure accurate fluid level reading. Do
not overfill. Use only manufacturers recommended
power steering fluid.
If necessary, add fluid to restore to the proper indicated
level. With a clean cloth, wipe any spilled fluid from all
surfaces. Refer to Fluids, Lubricants, and Genuine Parts
for correct fluid type.
Front & Rear Suspension Ball Joints
The suspension ball joints are permanently sealed. No
regular maintenance is required for these components.
Steering Shaft Seal
The steering shaft seal, at the point where the shaft passes
through the bulkhead, is lubricated when it is installed. If
the seal becomes noisy when the steering shaft is turned,
it should be lubricated with a multi-purpose grease.
Mopar multi-purpose lubricant is recommended.
Steering Linkage
The tie rod end ball joints are permanently lubricated and
do not require periodic maintenance.
Drive Shaft Universal Joints
Your vehicle has constant velocity universal joints. Peri-
odic lubrication of these joints is not required. However,
the joint boots should be inspected for external leakage or
damage when other maintenance is performed. If leakage
or damage is evident, the universal joint boot and grease
should be replaced immediately.
MAINTAINING YOUR VEHICLE 355
7

BULB REPLACEMENT
Standard Quad Headlights
1. Remove the two screws securing the headlight mod-
ule to the vehicle and pull the headlight module forward
away from the vehicle, disengaging the assembly from
the lower attachment clip. 2. Remove the rubber boot seals.
3. Disconnect the electrical connector.
4. Rotate the bulb to the left and replace the bulb.
Reinstall the rubber boot seals and then the headlight
module.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with an oily surface, clean the
bulb with rubbing alcohol.
382 MAINTAINING YOUR VEHICLE

Miles 21, 000 24, 000 27, 000 30, 000 33, 000 36, 000
(Kilometers) (35 000) (40 000) (45 000) (50 000) (55 000) (60 000)
Change engine oil and engine oil filter. X X XXXX
Rotate Tires X X X
Inspect the brake linings. X X
Inspect the engine air cleaner filter, replace if nec-
essary. * XXX XX
Replace the engine air cleaner filter. X
Inspect the tie rod ends and boot seals. (Front &
Rear) X
Inspect the PCV valveand replace as necessary.* X
Change the All Wheel Drive (AWD) power trans-
fer unit fluid. (See note at the end of this chart) X
Change the All Wheel Drive (AWD) overrunning
clutch and rear carrier fluid. (See the note at the
end of this chart) X
Replace the air conditioning filter. X X
SCHEDULE “B” 395
8
M A I
N T
E
N A
N C E
S
C
H E
D
U L
E
S

Miles 57, 000 60, 000 63, 000 66, 000 69, 000 72, 000
(Kilometers) (95 000) (100 000) (105 000) (110 000) (115 000) (120 000)
Change engine oil and engine oil filter. XXXXX X
Rotate Tires X X X
Inspect the brake linings. X X
Inspect the engine air cleaner filter, replace if
necessary. * X XXX X
Replace the engine air cleaner filter. X
Inspect the tie rod ends and boot seals. (Front
& Rear) X
Inspect the PCV valveand replace if neces-
sary.* X
Inspect the serpentine drive belt, replace if
necessary. ‡ X
Change the automatic transmission fluid and
filter. X
SCHEDULE “B” 397
8
M
A I
N T
E
N A
N C E
S
C
H E
D
U L
E
S

Miles 75, 000 78, 000 81, 000 84, 000 87, 000 90, 000
(Kilometers) (125 000) (130 000) (135 000) (140 000) (145 000) (150 000)
Change engine oil and engine oil filter. XXXXX X
Rotate Tires X X X
Inspect the brake linings. X X
Inspect the engine air cleaner filter, replace if
necessary. * XXXX
Replace the engine air cleaner filter XX
Replace the spark plugs. X
Inspect the tie rod ends and boot seals. (Front
& Rear) X
Check the PCV valve and replace if necessary.
Not required if previously changed.* X
Inspect the serpentine drive belt, replace if
necessary. ‡ XX
SCHEDULE “B” 399
8
M
A I
N T
E
N A
N C E
S
C
H E
D
U L
E
S

Miles 108, 000 111, 000 114, 000 117, 000 120, 000
(Kilometers) (180 000) (185 000) (190 000) (195 000) (200 000)
Change engine oil and engine oil filter. X X X X X
Rotate Tires X X X
Inspect the brake linings. X X
Inspect the engine air cleaner filter, replace if neces-
sary. * XXXX
Replace the engine air cleaner filter. X
Inspect the tie rod ends and boot seals. (Front &
Rear) X
Inspect the PCV valveand replace as necessary.* X
Inspect the serpentine drive belt, replace if neces-
sary. ‡ X
Change the automatic transmission fluid and filter. X
Change the All Wheel Drive (AWD) power transfer
unit fluid. (See note at the end of this chart) X
Replace the air conditioning filter. X X
402 SCHEDULE “B”
8
M A I
N T
E
N A
N C E
S
C
H E
D
U L
E
S

Miles 138, 000 141, 000 144, 000 147, 000 150, 000
(Kilometers) (230 000) (235 000) (240 000) (245 000) (250 000)
Change engine oil and engine oil filter. X X X X X
Rotate Tires X X X
Inspect the brake linings. X
Inspect the engine air cleaner filter, replace if neces-
sary. * XXXX
Replace the engine air cleaner filter. X
Replace the spark plugs. X
Inspect the serpentine drive belt, replace if neces-
sary. ‡ X
Inspect the tie rod ends and boot seals. (Front &
Rear) X
Inspect the PCV valveand replace as necessary.* X
Change the All Wheel Drive (AWD) power transfer
unit fluid. (See note at the end of this chart) X
404 SCHEDULE “B”
8
M
A I
N T
E
N A
N C E
S
C
H E
D
U L
E
S

SCHEDULE “A”
Miles 6, 000 12, 000 18, 000 24, 000 30, 000 36, 000
(Kilometers) (10 000) (20 000) (30 000) (40 000 ) (50 000) (60 000)
[Months] [6] [12] [18] [24] [30] [36]
Change engine oil and engine oil filter. X XXXXX
Rotate Tires X XXXXX
Inspect the brake linings. X X
Inspect the engine air cleaner filter, replace if
necessary. * X XXX X
Replace the engine air cleaner filter. X
Inspect the tie rod ends and boot seals. (Front
& Rear) X
Replace the air conditioning filter. X X X
406 SCHEDULE “A”
8
M A I
N T
E
N A
N C E
S
C
H E
D
U L
E
S