2006 CHEVROLET TAHOE roof

[x] Cancel search: roof

Page 174 of 540

CHEVROLET TAHOE 2006 2.G Owners Manual Auxiliary Roof Mounted Lamp
If your vehicle has this feature, this button includes
wiring provisions for a dealer or a quali�ed service
center to install an auxiliary roof lamp.
This button is located

Page 289 of 540

CHEVROLET TAHOE 2006 2.G Owners Manual Do not touch the bottom side of a CD while handling
it; this could damage the surface. Pick up CDs by
grasping the outer edges or the edge of the hole and
the outer edge.
Care of the CD and DVD Player

Page 310 of 540

CHEVROLET TAHOE 2006 2.G Owners Manual Loading Your Vehicle for Off-Road
Driving
{CAUTION:
Cargo on the load �oor piled higher than
the seatbacks can be thrown forward
during a sudden stop. You or your
passengers could be injured. Keep ca

Page 347 of 540

CHEVROLET TAHOE 2006 2.G Owners Manual Q:What is total vehicle reserve capacity?
A:This is the difference between your GVWR and the
weight of your vehicle with full fuel and passengers.
It is the amount of weight you can add to your
vehicl

Page 371 of 540

CHEVROLET TAHOE 2006 2.G Owners Manual Service............................................................5-3
Accessories and Modi�cations..........................5-3
California Proposition 65 Warning.....................5-3
Doing Your Ow

Page 424 of 540

CHEVROLET TAHOE 2006 2.G Owners Manual Side Identi�cation Marker Lamps
To replace a side identi�cation marker bulb, do
the following:
1. Locate the lamp gasket near the rear wheel to
expose the service slot and pull back the edge.
2. Using

Page 425 of 540

CHEVROLET TAHOE 2006 2.G Owners Manual 2. Install a new bulb into
the socket and turn
clockwise until it locks
into place.
3. Reinstall the lens and tighten the screws.To replace a center roof marker lamp bulb, do the
following:
1. Remove

Page 427 of 540

CHEVROLET TAHOE 2006 2.G Owners Manual 4. Pull the old bulb
straight out from
the socket.
5. Press a new bulb into the socket, insert the socket
into the taillamp housing and turn the socket
clockwise into the taillamp housing until it cli
Page:   < prev 1-8 9-16 17-24 next >