Windscreen
A. Windscreen
B. Bevelled Notch in Carpeted Seatback Bumper
C. Protective Cap on Carpeted Seatback Bumper
The vehicle may have a windscreen (A) installed to the
rear of each seat to lessen wind noise while the
convertible roof is retracted. The convertible roof can be
opened or closed with the windscreen installed. The
vehicle must have the correct seatback bumpers
to install the windscreen.The correct seatback bumpers have a bevelled
notch (B) above the seat’s inboard protective cap (C).
The notch allows the bumper to fit over the windscreen
bracket which mounts to the inboard mounting studs.
Install the windscreen by following these steps:
1. Before installing the windscreen, the convertible top
must be fully retracted and the seats moved forward.
2. Remove the windscreen from its protective bag.
3. Locate the carpeted seatback bumper behind
each seat.
4. Remove protective caps from the bumpers.
5. Loosen the four seatback bumper nuts from
each seat. It is not necessary to remove the
bumpers completely.
6. With the seatback bumpers loosened, slide the
windscreen mounting brackets behind the
seatback bumpers. The angled portion of the
mounting brackets should rest tightly into the bevels
of the seatback bumpers.
7. Tighten the bumper nuts and reinstall the protective
molding caps.
When not using the windscreen, store it in its protective
bag. To remove the windscreen, reverse the steps
listed previously. Rear View of Seatback
2-46
