2006 BUICK RANDEZVOUS child seat

If the vehicle has a third row seat and the seatback
is upright, there is an anchor strap located between
the third row seatback and cushion to anchor the
child restraint for the second row center position
bench seat.If the vehicle has a third row seat and the seatback
is folded down, there is an anchor on the back of
the third row seat for the second row center position
bench seat. Second Row Center Position Bench Seat with
Third Row Seat
Second Row Center Position Bench Seat with
Third Row Seat Folded Down
1-61

If you are using a top tether equipped child restraint
in the second row center bench seat and need to
temporarily transport a at tire for repair, move the
child restraint to a rear seat outboard position.
SeeSecuring a Child Restraint in a Rear Outside Seat
Position on page 1-65for more information including
important safety information.
If the vehicle has a third row, there is a top tether
anchor for the third row passenger’s side position.
Locate the anchor symbol on the ap of carpet behind
the seat. Lift up the carpet to access the anchor.Do not secure a child restraint in the right front
passenger’s position or in the third row driver side
position, if equipped, if a national or local law requires
that the top tether be attached, or if the instructions that
come with the child restraint say that the top tether
must be attached. There is no place to attach the top
tether in this position.
Accident statistics show that children are safer if they
are restrained in the rear rather than the front seat.
SeeWhere to Put the Restraint on page 1-54for
additional information.
Third Row
1-62

Securing a Child Restraint Designed for
the LATCH System
{CAUTION:
If a LATCH-type child restraint is not attached
to anchors, the restraint will not be able to
protect the child correctly. In a crash, the child
could be seriously injured or killed. Make sure
that a LATCH-type child restraint is properly
installed using the anchors, or use the
vehicle’s safety belts to secure the restraint,
following the instructions that came with that
restraint, and also the instructions in this
manual.
{CAUTION:
Each top tether anchor and lower anchor in
the vehicle is designed to hold only one child
restraint. Attaching more than one child
restraint to a single anchor could cause the
anchor or attachment to come loose or even
break during a crash. A child or others could
be injured if this happens. To help prevent
injury to people and damage to your vehicle,
attach only one child restraint per anchor.
1. Find the lower anchors, if equipped, for the desired
seating position.
2. If the desired seating position does not have lower
anchors or the child restraint does not have lower
anchorages, seeSecuring a Child Restraint in
a Rear Outside Seat Position on page 1-65,
Securing a Child Restraint in the Center Rear Seat
Position on page 1-67, andSecuring a Child
Restraint in the Right Front Seat Position on
page 1-69for instructions on installing the child
restraint using the safety belts.
3. Put the child restraint on the seat.
1-63

4. Attach and tighten the lower attachments on the
child restraint to the lower anchors, if equipped,
in the vehicle. The child restraint instructions
will show you how.
5. If the child restraint is forward-facing, attach and
tighten the top tether to the top tether anchor.
Refer to the child restraint instructions and
the following steps:
5.1. Find the top tether anchor.
5.2. If the vehicle has the extended rear
convenience center, you need to lift the cover
of the convenience center to access the
anchor for the second row center position
bench seat.
5.3. For the third row bench seat, lift the carpet
to expose the anchor.
5.4. Route and tighten the top tether according
to your child restraint instructions and the
following instructions:
If the position you are
using does not have a
head restraint and you
are using a single tether,
route the tether over
the seatback.If the position you are
using does not have a
head restraint and you
are using a dual tether,
route the tether over
the seatback.
If the position you are
using has an adjustable
head restraint and you
are using a dual tether,
route the tether around
the head restraint.
If the position you are
using has an adjustable
head restraint and you
are using a single tether,
route the tether under
the head restraint and
in between the head
restraint posts.
6. Push and pull the child restraint in different
directions to be sure it is secure.
1-64

Securing a Child Restraint in a
Rear Outside Seat Position
If your child restraint is equipped with the LATCH
system, seeLower Anchors and Tethers for Children
(LATCH) on page 1-55.
There is no top tether anchor in the 3rd row driver’s-side
position. Do not secure a child seat in this position if
a national or local law requires that the top tether
be anchored or if the instructions that come with the
child restraint say that the top tether must be anchored.
SeeLower Anchors and Tethers for Children (LATCH)
on page 1-55if the child restraint has a top tether.
If your child restraint does not have the LATCH system,
you will be using the lap-shoulder belt to secure the
child restraint in this position. Be sure to follow the
instructions that came with the child restraint. Secure
the child in the child restraint when and as the
instructions say.
1. Put the child restraint on the seat.
2. Pick up the latch plate, and run the lap and shoulder
portions of the vehicle’s safety belt through or
around the restraint. The child restraint instructions
will show you how.Tilt the latch plate to adjust the belt if needed.
1-65

5. If your child restraint has a top tether and the
position that you are using has a top tether anchor,
attach and tighten the top tether to the top tether
anchor. Refer to the instructions that came with the
child restraint and to step 5 underLower Anchors
and Tethers for Children (LATCH) on page 1-55.
6. Push and pull the child restraint in different
directions to be sure it is secure.
To remove the child restraint, if the top tether is attached
to the top tether anchor, disconnect it. Unbuckle the
vehicle’s safety belt and let it go back all the way.
The safety belt will move freely again and be ready to
work for an adult or larger child passenger.Securing a Child Restraint in the
Center Rear Seat Position
If your child restraint is equipped with the LATCH
system, seeLower Anchors and Tethers for Children
(LATCH) on page 1-55.
If your child restraint does not have the LATCH system,
you will be using the lap-shoulder belt to secure the
child restraint in the center rear seating position.
To secure a child restraint in this position, you will use
only the lap part of the belt. Disconnect the shoulder
part of the belt and store it before securing child
restraint. SeeCenter Rear Passenger Position
on page 1-40.
If you are using a top tether-equipped child restraint in
the center rear seat and need to temporarily transport
a at tire for repair, move the child restraint to a
rear seat outboard position. SeeSecuring a Child
Restraint in a Rear Outside Seat Position on page 1-65
for more on this, including important safety information.
1-67

Be sure to follow the instructions that came with the
child restraint. Secure the child in the child restraint
when and as the instructions say.
1. Make the belt as long as possible by tilting the
latch plate and pulling it along the belt.
2. Put the child restraint on the seat.
3. Run the vehicle’s safety belt through or around the
restraint. The child restraint instructions will show
you how.4. Buckle the belt. Make sure the release button is
positioned so you would be able to unbuckle the
safety belt quickly if you ever had to.
5. To tighten the belt, pull its free end while you push
down on the child restraint. If you are using a
forward-facing child restraint, you may nd it helpful
to use your knee to push the child restraint as
you tighten the belt.
6. If your child restraint has a top tether, attach and
tighten the top tether to the top tether anchor.
Refer to the instructions that came with the child
restraint and to step ve underLower Anchors and
Tethers for Children (LATCH) on page 1-55.
7. Push and pull the child restraint in different
directions to be sure it is secure.
1-68

To remove the child restraint, if the top tether is attached
to the top tether anchor, disconnect it. Unbuckle the
vehicle’s safety belt. When you remove the child
restraint, be sure to reconnect the lap and shoulder
parts of the belt so they will be ready to work for an
adult or larger child passenger.
Securing a Child Restraint in the
Right Front Seat Position
Your vehicle has a right front passenger airbag. A rear
seat is a safer place to secure a forward-facing child
restraint. SeeWhere to Put the Restraint on page 1-54.
In addition, your vehicle has the passenger sensing
system. The passenger sensing system is designed to
turn off the right front passenger’s frontal airbag
when an infant in a rear-facing infant seat or a small
child in a forward-facing child restraint or booster seat is
detected. SeePassenger Sensing System on page 1-81
andPassenger Airbag Status Indicator on page 3-42
for more information on this including important
safety information.
A label on your sun visor says, “Never put a rear-facing
child seat in the front.” This is because the risk to the
rear-facing child is so great, if the airbag deploys.
{CAUTION:
A child in a rear-facing child restraint can be
seriously injured or killed if the right front
passenger’s airbag inates. This is because
the back of the rear-facing child restraint
would be very close to the inating airbag.
Even though the passenger sensing system is
designed to turn off the passenger’s frontal
airbag if the system detects a rear-facing child
restraint, no system is fail-safe, and no one
can guarantee that an airbag will not deploy
under some unusual circumstance, even
though it is turned off. We recommend that
rear-facing child restraints be secured in the
rear seat, even if the airbag is off.
If you need to secure a forward-facing child restraint
in the right front seat position, move the seat as far back
as it will go before securing the forward-facing child
restraint. SeeManual Seats on page 1-3orSix-Way
Power Seats on page 1-4.
If your child restraint is equipped with the LATCH
system, seeLower Anchors and Tethers for
Children (LATCH) on page 1-55.
1-69