2006 Alfa Romeo GT steering

VEHICLE MAINTENANCE
253
1Engine oil - 2Battery - 3Brake fluid -4
Windscreen/rearscreen/headlamp
washer fluid - 5Engine coolant fluid -
6Power steering fluid - 7Selespeed
transmission oil (2.0 JTS Selespeed ver-
sions)
CHECKING LEVELS
Never smoke while
working in the engine
compartment; gas and
inflammable vapours may be pre-
sent, with the risk of fire.
When topping up take
care not to confuse the
various types of fluids:
they are incompatible with one
another and could seriously dam-
age the vehicle.fig. 1 - 1.8 T. SPARK version
A0A0736b
A0A0681b
fig. 1a - 2.0 JTS version

VEHICLE MAINTENANCE
254fig. 3 - JTD 16Vversion1Engine oil - 2Battery - 3Brake fluid -4
Windscreen/rearscreen/headlamp
washer fluid - 5Engine coolant fluid -
6Power steering fluid
A0A0396b A0A0683b
fig. 2 - 3.2 V6version
1Engine oil - 2Battery - 3Brake fluid -4
Windscreen/rearscreen/headlamp
washer fluid - 5Engine coolant fluid -
6Power steering fluid

Oil consumption is very
low; if topping up again is
needed shortly after-
wards, have the system checked
for possible leaks by Alfa Romeo
Authorised Services.
VEHICLE MAINTENANCE
258
When loosening the
reservoir cap do not
allow the fluid to come
into contact with painted parts. If
it does, wash it off immediately
with water. Do not allow the power
steering fluid to touch hot
parts of the engine: it is
inflammable.
fig. 10
A0A0217b
fig. 9
A0A0400b
BRAKE AND HYDRAULIC
CLUTCH FLUID
(fig. 10)
Slacken the cap (A) and check that the
fluid contained in the reservoir reaches the
maximum mark.
POWER STEERING FLUID
(fig. 9)
Check that the level of the oil in the
reservoir is at maximum.
This operation should be carried out with
the vehicle on a level surface and the
engine switched off and cold.
Check that the level reaches the MAX
mark on the reservoir or coincides with the
upper notch (maximum level) on the dip-
stick (A) integral with the reservoir cap.
If the oil level in the reservoir is below
the specified one, top up only with one of
the products listed in the “Fluid and lubri-
cant Specification” table in the “Technical
Specifications” chapter proceeding as fol-
lows:– Start the engine and wait for the oil
level in the reservoir to stabilise.
– With the engine running, turn the
steering wheel lock to lock a few times.
– Top up to the MAXlevel notch, then
refit the cap.

VEHICLE MAINTENANCE
265
Alloy rim painting
involving temperatures
exceeding 150 °C should
be avoided since wheel mechani-
cal characteristics could be
impaired.Do not cross switch the
tyres, moving them from
the right of the car to the
left and vice versa.Excessive low pressure
causes overheating of the
tyre with the possibility
of serious damage to it.Remember that vehicle
road holding also depends
on correct tyre inflation
pressure.
RUBBER HOSES
As far as the brake system and fuel sup-
ply rubber hoses are concerned, carefully
follow the Scheduled Maintenance
Programme. Indeed, ozone, high temper-
atures and the prolonged lack of fluid in
the system may cause hardening and
cracking of the hoses, with possible leaks.
Careful control is therefore necessary. IMPORTANTS
– Where possible, avoid sudden brak-
ing, tyre squealing starts, violent bumps
against kerbs, potholes or obstacles of var-
ious kinds. Prolonged driving on rough
roads may damage the tyres;
– Routinely check the tyres for cuts on
the sides, swellings or uneven tread wear.
If necessary contact Alfa Romeo
Authorised Services;
– Avoid overloading the vehicle when
travelling: this may cause serious damage
to the wheels and tyres;
– If a tyre is punctured, stop immedi-
ately and change it to avoid damage to
the tyre itself, the rim, suspensions and
steering system;
– Tyres age even if they are not used
much. Cracks in the tread rubber are a
sign of aging. In any case, if the tyres
have been on the vehicle for over 6 years,
they should be checked by specialised per-
sonnel, to see if they can still be used.
Also remember to check the compact
spare wheel;
– In case of replacement, always fit new
tyres, avoiding those of dubious origin;

VEHICLE MAINTENANCE
270
Do not keep aerosol cans
in the car. They might
explode. Aerosol cans
must never be exposed to a tem-
perature above 50°C. The tem-
perature inside the car exposed
to the sun may go well beyond
that figure.
CLEANING LEATHER SEATS
– Remove dried on dirt with a lightly
moistened chamois leather or cloth with-
out pressing too hard.
– Remove liquid and grease stains with
a dry absorbent cloth without rubbing.
Then wipe with a soft cloth or chamois
leather with water and neutral soap. If the
stain persists, use specific products, care-
fully following the instructions for use.
IMPORTANTNever use alcohol. Make
sure that cleaning products do not contain
alcohol and alcohol derivatives even at
low strength.
STEERING WHEEL/GEAR LEVER
KNOB WITH GENUINE
LEATHER COVERING
These components shall only be cleaned
with water and neutral soap. Never use spir-
it or alcohol-based products.
Before using special products for cleaning
interiors, read carefully label instructions and
indications to make sure they are free from
spirit and/or alcohol-based substances.
If when cleaning the windscreen with spe-
cial glass products, some drops fall on the
leather covering of the steering wheel/gear
lever knob remove them immediately and
then clean with water and neutral soap.
IMPORTANTTake the utmost care
when engaging the steering lock to prevent
scratching the leather covering.
INTERIOR PLASTIC PARTS
Clean plastic parts with a cloth
mositened with water and non-abrasive
neutral detergent. To remove grease or
hard stains, use appropriate products
designed to preserve the appearance of
components.
IMPORTANTNever use spirit or petro-
leum to clean the instrument panel or
other plastic parts.
Upholstery of your car has
been designed to withstand
wear deriving from com-
mon use of the car. You are how-
ever recommended to avoid strong
and/or continuous scratching with
clothing accessories such as metal-
lic buckles, studs, Velcro fastenings
and the like, since these items cause
circumscribed stress of the cover
fabric that could lead to yarn break-
ing, and damage the cover as a con-
sequence.

TECHNICAL SPECIFICATIONS
275
Service brakes:– front
– rear
Parking brake
BRAKES
Front
Rear
Type
Turning radius
(between pavements) m1.8 T. SPARK - 2.0 JTS - 3.2
V6 - JTD16V
rack and pinion with hydraulic power steering
11.5
SUSPENSIONS
STEERING SYSTEM
1.8 T. SPARK - 2.0 JTS - 3.2 V6- JTD16V
Disk
Disk
Controlled by hand lever, acting on the rear brakes
1.8 T. SPARK - 2.0 JTS - 3.2
V6 - JTD16V
quadrilateral system with stabiliser bar
Mc Pherson type

TECHNICAL SPECIFICATIONS
282
REFILLING
2.0JTS
Selespeed
63
7
7.2
–
4.4
2.0
0.6
1.2
0.52
2.5
4.2
3.2V6
63
7
7.2
–
5.9
2.0
–
1.2
0.52
2.5
4.2
1.8 T. SPARK
63
7
7.2
4.4
–
2.0
–
1.2
0.52
2.5
4.2
2.0JTS
63
7
7.2
–
4.4
2.0
–
1.2
0.52
2.5
4.2
Fuel tank: litres– including a reserve of litres
Engine cooling
system litres
Oil sump and filter litres
litres
Mechanical transmission/
differential litres
Selespeed transmission litres
Hydraulic power steering litres
Hydraulic brake circuit with
ABS device litres
Windscreen
washer reservoir: litres
– with headlamp washer litresSpecified fuels
and original lubricants
Unleaded Premium petrol with no
less than 95 R.O.N
Mixture of distilled water
andPARAFLU UP at 50%
SELENIA 20 K Alfa Romeo
SELENIA RACING
TUTELA CAR TECHNYX
TUTELA CAR CS SPEED
TUTELA GI/A
TUTELA TOP 4
for Alfa Romeo
Mixture of water and fluid
TUTELA
PROFESSIONAL SC 35

TECHNICAL SPECIFICATIONS
283
JTD16V
63
7
7.2
4.5
2.0
1.2
0.52
2.5
4.2
Fuel tank: litres– including a reserve of litres
Engine cooling
system litres
Oil sump and filter litres
Mechanical transmission/
differential litres
Hydraulic power steering litres
Hydraulic brake circuit with
ABS device litres
Windscreen
washer reservoir: litres
– with headlamp washer litresSpecified fuels
and original lubricants
Diesel fuel for motor vehicles
(Specification EN590)
Mixture of distilled water and
PARAFLU UP at 50%
SELENIA WR
TUTELA CAR TECHNYX
TUTELA GI/A
TUTELA TOP 4
for Alfa Romeo
Mixture of water and fluid
TUTELA PROFESSIONAL SC 35