Page 183 of 272
182
– Remove and replace the bulb (B-fig.
72) (tubular with bayonet coupling)
pushing gently and turning counter-clock-
wise.
– Refit the roof light firstly hooking the
catch (C-fig. 72) and pressing on the
other side until the catch clicks into place
(D-fig. 72).COURTESY LIGHTS
To replace the bulb (Type C, 5W):
– Remove the light (A-fig. 73) lever-
ing in the point illustrated.
REAR ROOF LIGHTS
To replace the bulbs (Type B, 5W):
– Remove the roof light (A-fig. 71)
levering in the point illustrated.
fig. 73fig. 71
492PGSm494PGSm493PGSm
fig. 72
Page 184 of 272
183
GLOVEBOX LIGHT
To replace the bulb (Type A, 5W):
– Remove the light pushing with a
screwdriver on the tab (A-fig. 76)
– Press the sides of the bulb screen (B-
fig. 77) in correspondence with the two
fastening pins and turn it. – Remove the screen (B-fig. 74) re-
leasing it from the catches (C-fig. 74)
– Remove the bulb (D-fig. 75)
pulling outwards and releasing from the
side contacts.
– Insert the new bulb making sure that
it is positioned correctly and locked be-
tween the contacts.
– Refit the screen (B-fig. 74) insert-
ing it correctly between the catches (C-
fig. 74).– Refit the light unit firstly inserting
from the side (E-fig. 75) and then
pressing on the other side until the catch
clicks into place (F-fig. 75).
P4C00057495PGSm
fig. 74
496PGSm
fig. 75
630PGSm
fig. 76
Page 186 of 272
185
– Fit the new bulb locking it between
the two contacts.
– Lower the protection cover.
– Refit the light by locking it in its seat.LUGGAGE COMPARTMENT
LIGHT
To replace the bulb (Type C, 10W):
– Remove the light levering on point
(A- fig. 80) with a screwdriver.– Lift the protection cover (B- fig.
81).
– Remove the snap-fitted bulb (C- fig.
82).
A0D0085m
fig. 80
A0D0086m
fig. 81
A0D0087m
fig. 82
Page 191 of 272

190
FUSES AND RELAYS IN THE
BOOT
Fuses and relays are housed in the
right-hand side of the boot are housed in
a box, in the recess closed by cover (A-
fig. 92).
To open the cover turn the knob (B).
The devices protected by the fuses in
the boot are listed in the tables on next
pages.IMPORTANTThe arrangement of the
relays may vary depending on the ver-
sions and markets. In the event of a sus-
pected anomaly, contact Alfa Romeo Au-
thorized Services.Circuits operated by relays are the fol-
lowing (fig. 93):
A.Air mixing actuator, climate control
unit, additional heater control (JTD ver-
sions)
B.Rearscreen heating relay
C.Seat warming control, elec-
trochromic driving mirror, sun visor light,
rain sensor, parking sensor control unit,
door mirror control light, remote control
receiver, alarm system control unit, dri-
ver's power window control LOCK warn-
ing light
D.Windscreen heating, door mirror de-
frosting
E.Front seat warming, rear current
socket, front seat electric adjustment,
powered sunroof
F.Direction indicators, trailer presetting
518PGS
fig. 93
A0D0097m
A0D0111m
fig. 92
Page 192 of 272

191
System/Component Fuse no. Ampere Location
ABI control unit 13 10A fig. 86
ABI control unit – Central locking 19 20A fig. 93
ABI control unit – Front LH power window 18 20Afig. 93
ABI control unit – Front RH power window 3 20A fig. 93
ABI control unit – Rear LH power window 14 20Afig. 93
ABI control unit – Rear RH power window 17 20Afig. 93
ABS control unit 9 5A fig. 86
7 40A fig. 89
3 40A fig. 89
Additional heater (JTD versions) 17 20A fig. 89
13 10A fig. 93
Alarm system (control unit) 12 10A fig. 93
15 10A fig. 93
Alfa Romeo Code System 20 5A fig. 86
16 5A fig. 86
Cell phone (handset) 18 5A fig. 86
5 10A fig. 86
Central locking (ABI control unit) 19 20A fig. 93
Cigar lighter 7 20A fig. 86
Climate control fan 2 30A fig. 89
Climate control unit 19 5A fig. 86
External lights Fuse no. Ampere Location
Brake lights (switch) 9 5A fig. 861 15A fig. 86
Direction indicators 12 10A fig. 93
External lights (control) 5 10A fig. 86
Front fog lights 16 15A fig. 89
Headlights and headlight position
sensor (gas discharge headlights) 6 7.5A fig. 86
IGE control unit:
- brake light switch 1 15A fig. 86
- brake lights 9 5A fig. 86
- headlight spot 11 15A fig. 86
- left side lights 17 10A fig. 86
- rear light units 15 10A fig. 86
- right side lights 8 10A fig. 86
Left dipped beam headlight 12 15A fig. 89
Reversing lights (only versions with
manual gearbox) 13 10A fig. 86
Right dipped beam headlight 10 15A fig. 89
Internal lights Fuse no. Ampere Location
Dashboard light dimmer 5 10A fig. 86
Door mirror control light 15 10A fig. 93
Glovebox light 5 10A fig. 86
Seat warming control light 15 10A fig. 93
Sun visor lights 15 10A fig. 93
Page 194 of 272
193
System/Component Fuse no. Ampere Location
Rearscreen heating 1 30A fig. 93
Relay coil T21, T22, T23 (boot box) 3 5A fig. 86
Relay coil T24 (boot box) 5 10A fig. 86
Remote control receiver 15 10A fig. 93
Sound amplifier 20 25A fig. 93
Sound system 4 15A fig. 86
Sound system controls on steering wheel 5 10Afig. 86
Starter motor 1 30A fig. 89
Trailer presetting 12 10A fig. 93
Windscreen heating 7 15A fig. 93
Windscreen wiper 14 25A fig. 86
System/Component Fuse no. Ampere Location
Navigator 18 5A fig. 86
Parking sensors (control unit) 15 10A fig. 93
Power windows (driver's control
LOCK warning light) 15 10A fig. 93
Powered sunroof 10 20A fig. 93
Presetting 4 – fig. 93
11 – fig. 93
Rain sensor 15 10A fig. 93
Rear current socket 16 20A fig. 93
Rear LH power window (ABI control unit) 14 20Afig. 93
Rear RH power window (ABI control unit) 17 20Afig. 93
Page 195 of 272

194 IN THE EVENT
OF A FLAT BATTERY
STARTING WITH AN
AUXILIARY BATTERY
If the battery is flat, it is possible to start the
engine using an auxiliary battery (B-fig.
96) with the same electrical characteristics
as the original battery (A-fig. 96) (see
chapter “Technical specifications”).
The battery is housed on the left-hand
side of the boot, protected by a cover.
If the battery is low, the servocontrol
operating when the luggage compart-
ment opens from inside or by the key
does not work. However, it is always pos-
sible to open the luggage compartmentto reach the battery. Just rotate the key
wider simultaneously pressing on the bon-
net edge by the hand.
IMPORTANTApply a moderate pres-
sure only on the bonnet edge, immediate-
ly above the lock.
On versions without navigation system and
without CD player, access to the battery is
gained by slackening the knob (A-fig. 94)
and removing the battery cover.
On versions with navigation system and
/or CD player, access to the battery is
gained by slackening the knobs (A-fig.
95) and removing the cover (B).
Starting with an auxiliary battery does
not damages the Alfa Romeo CODE sys-
tem and must be carried out as follows:– Switch off all the not strictly neces-
sary electric devices.
– Connect a jump lead to the positive
terminals (1-fig. 96) of the two batter-
ies (+ sign next to the terminal).
– Connect another jump lead to the
negative terminals (2) of both batteries
(– sign next to the terminal).
– Start the engine.
– When the engine has started, remove
the cables reversing the sequence de-
scribed for connecting them.
– If after a few attempts, the engine
fails to start, do not insist pointlessly and
contact the nearest Authorized Alfa
Romeo Services.
fig. 96
A
B
fig. 94
A0D0107m3052CAm
fig. 95
341PGSm
Page 198 of 272

197 IF THE VEHICLE
IS TO BE LIFTED
USING THE JACK
See paragraph “In the event of a punc-
ture” of this chapter.
You are informed that.
– the jack mass is 2.100 kg;
– the jack requires no adjustment;
– the jack cannot be repaired and in
case of breakage it must be replaced by
another original one.
– no tool other than its cranking lever
may be installed on the jack.
Before beginning to tow
the car, turn the ignition
key to MAR and then to STOP, do
not remove it. Removing the key
automatically engages the steering
lock resulting in the impossibility
to steer the wheels. When towing
remember that without the help of
the servobrake and power steer-
ing, it is necessary to exert more
effort on the brake pedal and for
steering. Do not use flexible cables
for towing and avoid jerks. During
towing operations make sure that
fastening the joint to the car does
not damage the components in
contact with it. When towing the
car it is compulsory to comply with
the specific traffic regulations con-
cerning both the towing device and
behaviour on the road.
WARNING
The car may fall if the
jack is not positioned cor-
rectly. Never use the jack for
higher capacities than the one
stated on its label.
The purpose of the jack is
only for replacing wheels
on the car with which it is provided
or on cars of the same model. It
must never be used for other pur-
poses such as for example raising
cars of other models. In no case
must it be used for repairs under
the car.
WARNING
WARNING