2006 Alfa Romeo 166 lock

26
MINISTERIAL
HOMOLOGATIONS
In keeping with the laws in force in
each country on the subject of radio fre-
quency, we point out that:
– the separate homologation numbers
for each market are given on the last
pages of this handbook before the alpha-
betical index (for some countries also ho-
mologation document);
– for markets in which the transmitter
needs to be marked with the homologa-
tion number, this has been stated on the
component.
(Depending on the versions/markets,
the code may also be marked on the
transmitter and/or on the receiver).
REMOTE CONTROL
DOOR LOCKING
SYSTEM
The system comprises a receiver and a
transmitter (remote control) incorporated
in the key (B-fig. 14). To lock/unlock
the locks, point the transmitter towards
the car, press and release the button
(C). If, when pressing the remote control
push-button (C), the led (A) (where re-
quired) issues just a short flash, replace
the batteries as described in the “The Al-
fa Romeo CODE system” paragraph.
IMPORTANT Should it be necessary
to programme additional remote controls,
contact Alfa Romeo Authorized Services.
IGNITION DEVICE
THE SWITCH (fig. 15)
The switch has four positions:
–STOP: engine switched off, key can
be removed, engine lock engaged, steer-
ing lock engaged, all services excluded a-
part from those powered directly (e.g.
hazard warning light I.C.S. system (ex-
cept climate control).
–ACC: position for using the cigar
lighter and of the I.C.S. system (except
climate control).
–MAR: drive position. The engine
lock is deactivated and all electrical de-
vices are powered.
fig. 14
1015PGSm
fig. 15
1004PGSm

27
IMPORTANTNever leave the key in
this position when the engine is station-
ary.
–AV V: starting the engine.
IMPORTANT If the engine does not
start return the ignition key to the STOP
position and repeat the sequence.
The ignition block is fitted with a safety
device preventing it from being moved to
theAVV position when the engine is al-
ready running.If the ignition device is
tampered with (for ex-
ample during an at-
tempted break-in) have it checked
over by Alfa Romeo Authorized
Services, before travelling again.
STEERING LOCK
Engaging lock:
– move the key to the STOPposition
and remove the key lightly turning the
steering wheel to facilitate the locking ac-
tion.
Releasing the lock:
– turn the key to the MARposition
and gently rock the steering wheel in
both directions.
When leaving the vehicle
always remove the key
from the ignition to prevent any
passenger in the car from inadver-
tently activating the controls.
Never leave children unattended in
a car. Remember to engage the
handbrake and if the vehicle is fac-
ing uphill, first gear and if the ve-
hicle is facing downhill, reverse.
WARNING
Never remove the key
with the car on the
move. The steering wheel would
lock automatically the first time
the steering wheel is turned. This
also occurs if the car is towed.
WARNING
It is absolutely forbidden
to carry out whatever af-
ter-market operation involving
steering system or steering column
modifications (e.g.: installation of
anti-theft Device) that could badly
affect performance and safety,
cause the lapse of warranty and
also result in non-compliance of the
car with homologation require-
ments.
WARNING

28 DOORS
AUTOMATIC DOOR LOCKING
The automatic door locking function acti-
vates automatically when the car speed
exceeds 20 km/h.
This function can be deactivated and re-
activated by the following procedure, to
be carried out with the car at a standstill,
key at STOPand doors closed:
- turn the key to MAR
- keep button (A-fig. 20) on the cen-
tral console pressed until completing a full
centralised door locking cycle (opening
and closing or vice versa).IMPORTANTDepending on the ver-
sions/markets the lock for the key may
only be present on the driver’s door.
– To close the door, turn the key in the
opposite direction.
Rear doors
– To open the door, only with the inner
knob (A-fig. 17) raised, pull the open-
ing handle (B-fig. 18).
– To close the door in safety, press the
button (A-fig. 17) also with the door
open, then close it.
OPENING/CLOSING FROM
OUTSIDE
Front doors
– To open the door, turn the key (clock-
wise for the driver’s door, counter-clock-
wise for the passenger’s door) and then
remove the key and pull the handle (A-
fig. 16).
Before opening a door
ensure that this can be
done safely.
WARNING
315PGS1005PGS
fig. 16 fig. 18
318PGS
fig. 17

29
– To open the door pull handle (B).
– To close the door press the knob (A)
even when the door is open, and then
close it.
OPENING/CLOSING
FROM INSIDE
Front doors
– To open the door pull the handle
(A-fig. 19) regardless of the position
of knob (B-fig. 19).
– Pull the door to close; then, to pre-
vent the door from being opened from
CENTRALIZED LOCKING
This permits centralized locking of all
doors, both front and rear.
To operate the centralized locking de-
vice the doors must be perfectly closed
otherwise the system will not work.
IMPORTANT If one of the doors is
not closed properly the led on the relative
“door open” display will come on.
For versions/markets where applicable,
central locking depends on the complete
closing of all the doors and of the boot.
–From outside: when the doors are
closed, insert and turn the key in the lock
of one of the two front doors.
IMPORTANTDepending on the ver-
sions/markets the lock for the key may
only be present on the driver’s door. outside, press the button (A-fig. 20)
on the centre console or the knob (B-
fig. 19).
Rear doors (fig. 21)
The rear doors can only
be opened if the child
safety lock has been released.
WARNING
fig. 19
fig. 20
P4C00057313PGSm
A0D0006m
fig. 21
314PGSm

30
–From inside: with the doors closed,
press the button (A-fig. 20) on the
centre console or one of the knobs
(B-fig. 19) on the front doors to en-
gage (lock) central locking.
By pressing the knob (A-fig. 21) on
one of the rear doors only that particular
door will be locked.
To unlock central locking press the button
again (A-fig. 20).
IMPORTANT For the front doors it is
not possible to keep the knob (B-
fig. 19) down if the door has not been
shut properly.
IMPORTANT If the power supply is
interrupted (burnt fuse, battery discon-
nected etc.) each door can be opened
manually from both inside and outside
the vehicle.
IMPORTANT The centralized locking
system can be deactivated, thus unlock-
ing all doors, by lifting the door opening
lever on one of the two front doors.CHILD SAFETY LOCK (fig. 22)
The rear doors are equipped with a spe-
cial device which prevents the door being
opened from inside.
The device can be engaged when the
door is open by acting on the relative con-
trol using the ignition key.
Position1= Device inactive
Position2= Device engaged.
This device should be used when chil-
dren are in the back seat to prevent them
from opening the door whilst the car is
moving.IMPORTANT Do not overlook child
safety; the following recommendations
should be heeded:
– Engage the child safety device.
– Do not leave a child alone in the vehi-
cle.
– Follow the current laws regarding
child restraint and safety systems.
After activating the safety
device check that it is
working correctly by pulling on the
inner lever used to open the door.
WARNING
fig. 22
1006PGSm

31
SEATS
FRONT SEATS
Manual adjustment controls
Moving the seat backwards or
forwards
Lift lever (A-fig. 23) and push the
seat backwards or forwards. IMPORTANTOnce you have let go
of the lever, check that the seat is firmly
locked in the runners by trying to move it
back and forth. If the seat is not locked
properly, in the case of collision it might
move unexpectedly with clearly danger-
ous consequences.
Adjusting the height of the
driver’s seat
To raise the seat, pull the lever (B-
fig. 23) taking it upwards, then contin-
ue operating the lever (up and down) un-
til reaching the required height. To lower
the seat, push the lever (B) downwards,
then operate the lever (up and down) un-
til reaching the height required.
IMPORTANT Adjustment must only
be carried out when seated in the driver’s
seat.Seat inclination power adjustment
The adjustment is performed by apply-
ing pressure on the front or back part of
the two-position switch (C-fig. 23).
Seat warming(fig. 24)
(optional for versions/markets where
applicable)
The seat warming pad can be switched
on and off using switch (A) on the outer
side of the seat.
When the warming pad is on, the led
on the switch turns on.
Adjustments may be
made solely with the car
stationary.
WARNING
fig. 23
674PGSm
fig. 24
672PGSm
Upholstery of your car
has been designed to
withstand wear deriv-
ing from common use of the car.
You are however recommended
to avoid strong and/or continu-
ous scratching with clothing ac-
cessories such as metallic buck-
les, studs, Velcro fastenings and
the like, since these items cause
circumscribed stress of the cover
fabric that could lead to yarn
breaking, and damage the cover
as a consequence.

33
Adjusting the headrests (fig. 30)
Front headrests are adjustable in height
and rake: to adjust the height, move the
headrest up or down, then release it and
make sure that it is locked on one of the
positions provided. To adjust the rake,
turn the headrest forwards to the required
position.
IMPORTANT The shape of the head-
rest may vary depending on the version
and/or market. The example shown is
used only to demonstrate the methods by
which it can be adjusted. When memorising a new position of the
seat the previous one memorised with
the same button is cleared automatically.
Keeping the corresponding button (1),
(2), or (3) pressed the positions memo-
rised can be called even if the ignition
key is in the STOPposition or removed.
IMPORTANTMemorising the posi-
tions of the seat does not include turning
on the heating.
Remember that the head
restraints must be posi-
tioned so that they are supporting
the back of the head and not the
neck. They will only be able to pro-
vide effective protection in the
event of a collision if they are in
this position.
WARNING
fig. 28
373PGSm
fig. 30
A0D0064m
fig. 29
660PGSm

34
Centre armrest (fig. 32-33)
To raise/lower the armrest, lower it as il-
lustrated. To lower/raise the armrest keep
the lock button pressed (A-fig. 32).
To use the armrest, lower it as illustrated.There is a compartment inside the arm-
rest: to open, lift the cover (fig. 33). Rear pockets (fig. 31)
The front seats are provided with a
pocket in the rear of the seat back.
568PGSm
fig. 33
561PGSm
fig. 32
337PGSm
fig. 31