2006 Alfa Romeo 156 service

IN AN EMERGENCY
216
Drive carefully to the nearest Alfa Romeo
Authorized Service to check the tyre condi-
tions, then have it fixed or replaced.
It is absolutely necessary to communicate
that the tyre has been fixed with the quick
repairing kit.
fig. 18
A0B0339m
fig. 19
A0B0391m
fig. 17
A0B0338m
If, during the pressure
restoring operation, it is
not possible to reach at least 1,8
bars, do not drive any further be-
cause the tyre is too much dam-
aged and the quick repairing kit
cannot guarantee proper hold. Con-
tact Alfa Romeo Authorized Ser-
vices.
WARNING
Tyres fixed with the quick
repairing kit must be used
only temporarily.
WARNING

IN AN EMERGENCY
217
WHEN NEEDING TO CHANGE A BULB
Alterations or repairs to
the electric system not car-
ried out correctly and without tak-
ing into account the specifications
of the system may cause malfunc-
tioning and the risk of fire.
WARNING
Where possible the bulbs
should be replaced by Alfa
Romeo Authorized Services. The
correct operation and positioning
of the external lights are vital to
the safety of the vehicle and its
passengers and the subject of spe-
cific laws.
WARNING
Halogen bulbs must be
handled touching only the
metallic part. If the transparent
bulb is touched with the fingers its
lighting intensity is reduced and the
life of the bulb may be compro-
mised. If touched accidentally, rub
the bulb with a cloth moistened
with methylated spirits and allow
to dry.
WARNING
Halogen bulbs contain
pressurised gas, in the case
of breakage they may burst.
WARNING
Possible replacement of a
light on vehicles equipped
with Xeno lamps must be carried
out by Alfa Romeo Authorized Ser-
vices.
WARNING

IN AN EMERGENCY
221
REPLACEMENT OF XENON
LIGHTS
(optional for versions/
markets where applicable)
Xenon lights have a very long life, there-
fore breakdowns are unlikely.
Hereafter you find the description of the
correct procedure to replace a Xenon light.– Rotate the connector (B-fig. 24) of
the Xenon lamp by a quarter of a turn
counter-clockwise, as indicated in fig. 25,
and remove it.
Dipped-beam headlamps
To replace the bulb proceed as follows:
– Unscrew the three locking screw (B-
fig. 23) and remove the protective (A)
cover.
fig. 23
A0B0348m
fig. 25
A0B0351m
fig. 24
A0B0349m
If necessary, have the sys-
tem checked and repaired
only by Alfa Romeo Authorized
Services.
WARNING
Any operation regarding
the front light units must
be carried out with the lights
turned off and the ignition key re-
moved from the ignition switch:
risk of electric discharges.
WARNING

IN AN EMERGENCY
225
To adjust the front fog-
lights contact Alfa Romeo
Authorized Services.
FRONT FOG LIGHTS(where required)
To replace the bulb proceed under the car
as follows:
– Disconnect the connector (A-fig. 33)
from the light unit.
– Turn the cover counter-clockwise (B-
fig. 33) and remove it.
– Withdraw the supply cable terminal
(C-fig. 34).
– Release the bulb stopper (D-fig. 34)
and remove the bulb.– Fit a new bulb making the tabs of the
metallic part coincide with the grooves in
the lamp lens and hook the bulb stopper
(D-fig. 34).
– Re-connect the supply cable terminal
(C-fig. 34).
– refit the cover (B-fig. 33) and con-
nect the connector (A-fig. 33) to the light
unit.fig. 33
A0B0215m
fig. 34
A0B0216m
The efficiency of the lights
will be decreased and may
inconvenience other road users if the
light units are not correctly adjust-
ed. If in doubt contact Alfa Romeo
Authorized Services to have them
checked and adjusted if necessary.
WARNING

IN AN EMERGENCY
234
GENERALITIES The fuse is (fig. 66) a protective element
of the electrical system: basically it operates
(i.e. it gets disconnected) in case of break-
down or wrong operation on the system.
When an electrical devices ceases to func-
tion, make sure it has not fused. The fila-
ment must not be broken: if so, replace the
burnt fuse with another of the same value
(same colour).(A) - Intact fuse
(B) - Fuse with broken filament.
Extract the fuse to be replaced using the
pincers (C)situated on the fuse box.IN THE EVENT OF A BURNT FUSEfig. 66
A0B0189m
Never replace a broken
fuse with anything other
than a new fuse. Use al-
ways an intact fuse of the same
colour.Never replace a fuse with
another with a higher amp
rating, DANGER OF FIRE!
WARNING
If a main protective fuse
(MAXI-FUSE o MEGA-FUSE)
intervenes, do not fix it but contact
an Alfa Romeo Authorized Services.
WARNING
Before replacing a fuse
check that the key has
been removed from the ignition
and that all the services are
switched off and/or disengaged.
WARNING
If a fuse blows again con-
tact Alfa Romeo Autho-
rized Services.
WARNING

IN AN EMERGENCY
236
FUSES ABOVE THE MAIN
FUSEBOX
(fig. 71)
The protection fuses of certain devices are
grouped together on three containers locat-
ed above the main fusebox to which access
is gained removing the panel (A-fig. 69).
FUSES AND RELAYS ACCESSIBLE
FROM THE GLOVEBOX Some fuses and relays for services supplied
on request or only for certain specific mar-
ket versions are located on a bracket behind
the glovebox.To gain access to the fuses remove (A-
fig. 72) the pressure-fitted lid.
Access to the relays is gained by removing
the glovebox: contact Alfa Romeo Autho-
rized Services.
A. Fog light relay (where required).
B. Headlamp washer timer (where re-
quired).
FUSES AND RELAYS IN ENGINE
BAYIn the engine compartment, housed on a
bracket in front of the battery and protect-
ed by a special cover, there is a variable
number of fuses and relays depending on
the versions.
WARNINGThe arrangement of the fus-
es and relays may vary depending on the
versions and markets. In the event of a sus-
pected anomaly, contact Alfa Romeo Au-
thorized Services.fig. 73
A0B0154m
fig. 71
A0B0141m
fig. 72
A0B0184m

IN AN EMERGENCY
237
Remove the cover (A-fig. 73) to
gain access to the following relays/fuses
(fig. 74):
A.Engine radiator cooling fan 2
ndspeed
relay (T.SPARK versions).
B.Engine radiator cooling fan 1
stspeed re-
lay.
C.Fuel pump relay
D.Electronic injection relay
E.Climate control compressor relay
F.Timing variator relay (1.6 T.SPARK on-
ly) or engine radiator fan 2
ndspeed relay
(only 2.5 V6 24V, JTD and JTD 16V Multi-
jet versions).
G.Fuel oil heater relay (only Diesel ver-
sions).For JTD 20v Multijet version refer to
fig. 75For Diesel versions, depending on the op-
tions installed, there is a second bracket fas-
tened to the engine compartment rear bulk-
head for the following fuses (fig. 76):
A.MAXI-FUSE 30A: additional passenger
compartment heater 2
ndlevel relay.
B.MAXI-FUSE 30A: additional passenger
compartment heater 1stlevel relay.
WARNINGStrictly observe the specified
fuse ampere value: in case of doubt, con-
tact Alfa Romeo Authorized Services.
fig. 74
A0B0183m
fig. 76
A0B0619m
fig. 75
A0B0618m

IN AN EMERGENCY
239
69
69
69
69
71
71
69
71
69
69
69
69
72
69
69
69
69
69
69
71 10
11
13
5
4
5
3
7
15
13
15
9
1
4
12
2
15
12
12
10
SERVICES FUSE AMPERES FIGUREWindscreen wiper, windscreen washer/Rearscreen wiper/Rain sensor (optional)HornsGSM Box for Connect/Navigator-electronic warning systemFront power windowsLeft rear power windowRight rear power windowDoor locking system - Boot lightBoot electric openingRearscreen heatingWing mirror adjustmentWing mirror defrostingCigar lighter/Odour sensorHeadlamp washerHeadlamp aiming deviceInstrument clusterMain-beam headlamp warning lightRearscreen heating warning lightSound system/Diagnosis socketElectronic alarm system Supplementary electrical socket in the boot (Sportwagon versions)20A
20A
10A
30A
20A
20A
20A
30A
30A
10A
30A
15A
20A
10A
10A
10A
30A
10A
10A
20A