2006 Alfa Romeo 147 service reset

GETTING TO KNOW YOUR CAR
24
POWER WINDOWS
The power windows are fitted with a safe-
ty system with crush-prevention seals. The
electronic control unit that operates the sys-
tem is capable of detecting the presence of
an obstacle during the window closing mo-
tion through the special seals. Should this
occur, the system stops the movement of
the window and reverses it immediately.
IMPORTANTIf the crush-prevention
function is operated for 3 times in 1 minute,
the system automatically sets to the recov-
ery mode (self-protection). To reset the cor-
rect system operating logic, use the control
button. The window will rise in predefined
steps until closing completely. The logic is
reset and if there are no faults, the window
winder automatically resumes normal op-
eration; if not, contact Alfa Romeo Autho-
rised Services.
IMPORTANTWith the ignition key at
STOPor removed, the power windows re-
main activated for about 3 minutes and are
deactivated immediately the moment a door
is opened.
fig. 33
A0A0043m
fig. 34
A0A0044m
Passenger’s side (fig. 34)
The button (A) controls the passenger’s
side window.
IMPORTANTThe passenger side pow-
er window is provided with an “automatic
continuous operation” device both to low-
er and to raise the window. A brief push on
the upper or lower part of the button is suf-
ficient to start the run which continues au-
tomatically: the window stops at the re-
quired position by pushing once again in-
differently the upper or lower part of the but-
ton. Driver’s side (fig. 33)
The driver’s door panel contains the but-
tons that control the following windows,
with the ignition key at MAR:
A- left front window
B- right front window.
Press the button to lower the window. Pull
to raise it.
IMPORTANTThe driver’s power window
is fitted with the “continuous automatic op-
eration” device for both lowering and raising
the window. A brief press on the upper or
lower part of the button will cause it to move
and continue automatically: the window
stops in the required position by pressing ei-
ther the upper or lower part of the button
again.

GETTING TO KNOW YOUR CAR
49
The device may only be engaged in 4th,
5th or 6th gear, depending on the speed
of the car. Travelling downhill with the de-
vice engaged the car speed may increase
more than the memorised one, due to the
change in the engine load.
The ring (A) may be left constantly at ON
without damaging the device. You are, how-
ever, advised to switch the device off when
not in use, turning the ring to OFF, to avoid
memorising speeds by accident. It is advisable to engage the cruise control
only when the conditions of the traffic or
road so permit under completely safe con-
ditions, i.e.: straight and dry roads, dual car-
riageways or motorways, flowing traffic and
smooth road surface. Do not engage the de-
vice in town or in heavy traffic conditions.TO REDUCE
THE MEMORISED SPEED
The speed memorised can be reduced in
two ways:
1) disengaging the device (for instance
pressing the brake pedal) and then memo-
rising the new speed (turning the ring (B)
to (+) for at least three seconds);
2) keeping the ring pressed (B) at (–)
until reaching the new speed which will be
memorised automatically.
Cruise Control can only be
engaged at speeds above
30 km/h. The max. speed at which
the Cruise Control can be engaged
is 190 km/h, at speeds higher than
190 km/h it will not be engaged.
WARNING
When travelling with the
cruise control on, do not
move the gearshift lever to neu-
tral.
WARNING
If the device is faulty or
not working, turn the ring
(A) to OFF and contact Alfa Romeo
Authorised Services after checking
that the protection fuse is intact.
WARNING
RESETTING THE MEMORISED
SPEED
The memorised speed is automatically re-
set turning off the engine or moving the ring
(A) to OFF.

GETTING TO KNOW YOUR CAR
70
SERVICE
With the SERVICE function it is possible to
receive information connected with correct
vehicle maintenance. To consult this func-
tion, proceed as follows:
Menu screen
Return to menu screen
Return
to standard screen
WARNING
The programmed Mainte-
nance Schedule includes ve-
hicle maintenance every
20,000 km; this is shown
automatically, with the ignition key at MAR, start-
ing from 2,000 km (or miles) from this deadline and
it is shown again every 200 km. This display can on-
ly be reset by Authorised Alfa Romeo Services.
Q
QR
â
ã
â
ã
â
ã
â
ãâ
ãâ
ã
â
ã
â
ã
See INITIAL CHECK and ACCESS
TO THE MENU SCREEN

GETTING TO KNOW YOUR CAR
140
RADIO PRESETTING
SYSTEM
(for versions/markets where
applicable)
The car, if not delivered with sound sys-
tem, is fitted with a glove compartment on
the instrument panel (fig. 136a).
Sound system presetting system includes
the following:
– sound system power cables;
– front and rear speaker power cables;
– aerial power cable;
– sound system housing;
– aerial on car roof.The sound system shall be installed in the
proper housing occupied by the glove com-
partment that can be removed by pressing
the two retaining tabs fitted in the glove
compartment: here are the power cables.
If after buying the car you
want to install the sound
system, contact first Alfa
Romeo Authorised Services whose
qualified personnel, in addition to
suggesting the most suitable de-
vices, will evaluate the overall
electric absorption to safeguard the
battery. Excessive loadless ab-
sorption could damage the battery
and lose warranty.
The wiring diagram is the following (fig.
136b):Connector A
A1 N.C.
A2 N.C.
A3 N.C.
A4 + 30 (battery-powered)
A5 Aerial power supply
A6 Light
A7 + 15 (key-powered)
A8 Ground
Connector B
B1 RH rear speaker
B2 RH rear speaker
B3 RH front speaker
B4 RH front speaker
B5 LH front speaker
B6 LH front speaker
B7 LH rear speaker
B8 LH rear speaker
fig. 136a
A0A0715m
fig. 136b
A0A0709m

RIGHT HAND DRIVE VERSION
264
Driver’s side (fig. 8)
The driver’s door panel contains the but-
tons that control the following windows,
with the ignition key at MAR:
A- left window
B- right window.
Press the button to lower the window. Pull
to raise it.
IMPORTANTThe driver’s power window
is fitted with the “continuous automatic op-
eration” device for both lowering and raising
the window. A brief press on the upper or
lower part of the button will cause it to move
and continue automatically: the window
stops in the required position by pressing ei-
ther the upper or lower part of the button
again.
fig. 8
A0A0309m
WING MIRROR
ADJUSTMENT
Electric adjustment (fig. 7)
– use the switch (A) to select the mirror
required (right or left);
– pressing the button (B), in one of the
four directions, move the mirror selected pre-
viously;
– Position the switch (A) in the interme-
diate locking position.
IMPORTANTAdjustment is possible on-
ly with the ignition key at MAR.
fig. 7
A0A0308m
POWER WINDOWS
For some versions, the power windows are
fitted with a safety system with crush-pre-
vention seals. The electronic control unit that
operates the system is capable of detect-
ing the presence of an obstacle during the
window closing motion through the special
seals. Should this occur, the system stops
the movement of the window and reverses
it immediately.
IMPORTANTIf the crush-prevention
function is operated for 3 times in 1 minute,
the system automatically sets to the recov-
ery mode (self-protection). To reset the cor-
rect system operating logic, use the control
button. The window will rise in predefined
steps until closing completely. The logic is re-
set and if there are no faults, the window
winder automatically resumes normal oper-
ation; if not, contact Alfa Romeo Authorised
Services.
With the ignition key at STOPor removed,
the power windows remain activated for
about 3 minutes and are deactivated im-
mediately the moment a door is opened.