2006 Acura RSX light

However, if the brake pedal does not
f eel normal, you should take
immediate action. A problem in one
part of the system’s dual circuit
design will still give you braking at
two wheels. You will f eel the brake
pedal go down much f arther bef ore
the vehicle begins to slow down, and
you will have to press harder on the
pedal.Slow down by shif ting to a lower
gear, and pull to the side of the road
when it is saf e. Because of the long
distance needed to stop, it is
hazardous to drive the vehicle. You
should have it towed and repaired as
soon as possible (see
on page ).
If you must drive the vehicle a short
distance in this condition, drive
slowly and caref ully.
If the f luid level is low, take the
vehicle to your dealer and have the
brake system inspected f or leaks or
worn brake pads. If the brake system indicator comes
on while driving, the brake f luid level
is probably low in the reservoir.
Press lightly on the brake pedal to
see if it f eels normal. If it does,
check the brake f luid level the next
time you stop at a service station
(see page ). The brake system
indicator normally
comes on when
you turn the ignition switch to the
ON (II) position, and as a reminder
to check the parking brake. It will
stay on if you do not f ully release the
parking brake. 225
181
Brake System Indicator
Emergency
Towing
218
Canada
U.S.

The vehicle’s f uses are located in
two fuse boxes. The interior fuse
box is underneath the steering
column.The under-hood f use box is in the
engine compartment next to the
battery.If something electrical in your
vehicle stops working, the first thing
youshouldcheckforisablownfuse.
Determine f rom the chart on pages
and , or the diagram on the
f use box lid, which f use or f uses
control that device. Check those
f uses f irst, but check all the f uses
bef ore deciding that a blown f use is
the cause. Replace any blown f uses,
and check if the device works.
Turn the ignition switch to the
LOCK (0) position. Make sure the
headlights and all other
accessories are of f .
Remove the cover f rom the f use
box.
1.
2. 223 224
Fuses
Checking and Replacing Fuses
220
INTERIOR
UNDER-HOOD
TAB

Î
Î
Î
Î Î
µ
µ
µ
µ Î
Î
Î
CONT INUED
Circuits Protected
Amps.
No.
No. Circuits Protected
Amps.
Daytime Running Lights
SRS
Power Mirror
Bass Speaker
Heated Seats
Fuel Pump
Accessory Power Socket
Turn Signal
Front Wiper
Not Used
Front Passenger’s Power Window
Driver’s Power Window
Not Used
Not Used
7.5A
10A
10A
20A
20A
15A
15A
7.5A 20A
20A
20A
12
13
14
15
16
17
18
19
20
21
22
23
24
25
1
2
3
4
5
6
7
8
9
10
11 Ignition Coil
Laf Heater
Daytime Running Lights
Rear Accessory Power Socket
ACG (IG)
Not Used
Power Window Relay
Moonroof
Radio
Rear Wiper
Gauge panel
ABS
15A
20A
10A
10A
7.5A 20A
7.5A 10A
7.5A
7.5A 1:
2:
3:
Canadian models only
U. S. models only
Type-S only1
3
1
1 2
Fuse Locations
T aking Care of t he Unexpect ed
223
INTERIOR FUSE BOX

µ
µ
µ
Î
Î
Î
Î
Amps. Circuits Protected
No.
30 A
10 A
7.5 A 20 A
10 A
20 A
15 A
20 A
7.5 A 30 A
40 A
40 A
40 A
30 A
20 A
15 A
20 A
100 A 40 A
50 A Condenser fan
Small Light
Interior Light
Cooling Fan
Hazard
FI ECU (ECM/PCM)
Horn, Stop
ABS (F/S)
Back Up
ABS Motor
Rear Demister
Heater Motor
Power Window
Option
Left Headlight
Door Lock
Right Headlight
Not Used
Main Fuse Battery
Main Fuse Ignition
Spare Fuse
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21 25 1:
2: U.S. models
Canadian models
1
2
Fuse Locations
224
UNDER HOOD FUSE BOX

µ
µ
Î
Î
Î
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
Î
Î
Î
ÎÎ
Î
Specif ications
Technical Inf ormation
231
Capacities
Fuses
Alignment
Battery Tires
Lights
0.0in(0mm)
0.08 in (2.0 mm) 0°30’
1.8 US qt (1.7
)
1.6 US qt (1.5)
2.9 US qt (2.7
)
6.9 US qt (6.5)
2.6 US qt (2.5)
4.8 US qt (4.5)
1°00’
2°53’
P205/55R16 89V
P195/65R15 89H
Manual
transmission
fluid
Interior
Under-hood
Toe-in
Camber
Caster
12 V
12 V
12 V 12 V
5W 65 W
21 W 55 W
60 psi (420 kPa , 4.2 kgf/cm
)
31 psi (220 kPa , 2.2 kgf/cm)
31 psi (220 kPa , 2.2 kgf/cm)
T125/70D16 96M
T135/70D15 99M
Capacity 12 V 36 AH/5 HR12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
3.4 W
8W
5W
8W
5W
18 W
5W
21 W
21 W/5 W
21 W
12 V 5 W
Size
Pressure P215/45R17 87V
Headlights
Front turn signal lights
Front parking lights
Front side marker lights
Rear turn signal lights
Brake/Taillights
High-mount brake light
Rear side marker lights
Back-up lights
License plate lights
Ceiling light
Cargo area light
Spotlights
Glove box light See page223or the fuse label
attached to the inside of the fuse
box door under the dashboard.
See page224or the fuse box
cover.
High
Low Front
Rear
Front
Rear
Front
Type-S
Change
Total
Change
Total
U.S. vehicles
Canadian
vehicles
1:
2:
3:Front/Rear
Spare
Front
Rear
Spare
(HB3)
(Amber)
(Amber)
Canadian standard model
U.S. base model and Canadian Premium models
Automatic trans-
mission fluid
Windshield
washer reservoir
1
2
3
1, 2
3

ÎÎ
The burning of gasoline in your
vehicle’s engine produces several by-
products. Some of these are carbon
monoxide (CO), oxides of nitrogen
(NOx), and hydrocarbons (HC).
Gasoline evaporating f rom the tank
also produces hydrocarbons. Con-
trolling the production of NOx, CO,
and HC is important to the environ-
ment. Under certain conditions of
sunlight and climate, NOx and HC
react to f orm photochemical ‘‘smog.’’
Carbon monoxide does not contri-
bute to smog creation, but it is a
poisonous gas.
In Canada, Acura vehicles comply
with the Canadian emission
requirements, as specif ied in an
agreement with Environment
Canada, at the time they are
manuf actured. Your vehicle has a positive
crankcase ventilation system. This
keeps gasses that build up in the
engine’s crankcase f rom going into
the atmosphere. The positive
crankcase ventilation valve routes
them from the crankcase back to the
intake manif old. They are then
drawn into the engine and burned.
As gasoline evaporates in the f uel
tank, an evaporative emissions
control canister f illed with charcoal
adsorbs the vapor. It is stored in this
canister while the engine is of f . Af ter
the engine is started and warmed up,
the vapor is drawn into the engine
and burned during driving.
The United States Clean Air Act
sets standards f or automobile
emissions. It also requires that
automobile manufacturers explain to
owners how their emissions controls
workandwhattodotomaintain
them. This section summarizes how
the emissions controls work.
Scheduled maintenance is on pages
and .170
169
Emissions Cont rols
Crankcase Emissions Control
System
Evaporative Emissions Control
System
The Clean Air Act
Technical Inf ormation
235

If you take your vehicle f or a state
emissions test shortly af ter the
battery has been disconnected or
gone dead, it may not pass the test.
This is because of certain ‘‘readiness
codes’’ that must be set in the on-
board diagnostics f or the emissions
systems. These codes are erased
when the battery is disconnected,
and set again only after several days
of driving under a variety of
conditions.
If the testing f acility determines that
the readiness codes are not set, you
will be requested to return at a later
date to complete the test. If you must
get the vehicle retested within the
next two or three days, you can
condition the vehicle f or retesting by
doing the f ollowing.Make sure the gas tank is nearly,
but not completely f ull (around
3/4). Make sure the vehicle has been
parked with the engine of f f or 8
hours or more.
Make sure the ambient
temperature is between 20° and
95°F.
Without touching the accelerator
pedal, start the engine, and let it
idle f or 20 seconds.
Select a nearby lightly traveled
major highway where you can
maintain a speed of 50 to 60 mph
(80to97km/h)foratleast20
minutes. Drive on the highway in
D (A/T) or 5th (M/T). Do not usethecruisecontrol.Whentraffic
allows, drive f or 90 seconds
without moving the accelerator
pedal. (Vehicle speed may vary
slightly; this is okay.) If you cannot
do this f or a continuous 90
seconds because of traf f ic
conditions, drive f or at least 30
seconds, then repeat it two more
times (for a total of 90 seconds).
Then drive in city/suburban
traffic for at least 10 minutes.
When traffic conditions allow, let
the vehicle coast f or several
seconds without using the
accelerator pedal or the brake
pedal.
If the testing f acility determines the
readiness codes are still not set, see
your dealer.
Keep the vehicle in Park
(automatic transmission) or
neutral (manual transmission).
Increase the engine speed to 2,000
rpm,andholditthereuntilthe
temperature gauge rises to at least
1/4of thescale(about3minutes).
State Emissions T esting
T esting of Readiness Codes
238

CONT INUED
....................................
Accessories .139
ACCESSORY (Ignition Key .......................................
Position) .66
..............
Accessory Power Sockets .83
....................
Additives, Engine Oil .174
.............................
Airbag (SRS) .11,22
...
Airbags, Additional Information .22
...
Additional Safety Precautions .27
.............................
Airbag Service .27
How the Side Airbag Of f ......................
Indicator Works .27
..
How the SRS Indicator Works .26
How Your Front Airbags
.........................................
Work .23
...
How Your Side Airbags Work .25
........................
SRS Components .22
................
Air Conditioning System .88
.......................
Air Pressure, Tires .194
......................................
Antif reeze .177
Anti-lock Brakes (ABS) ...............................
Indicator .53,159
...................................
Operation .159
Anti-thef t Steering Column ..............................................
Lock .66..................................
Audio System .92
...
Automatic Seat Belt Tensioners .20
.............
Automatic Speed Control .127
..............
Automatic Transmission .151
..........................
Capacity, Fluid .231
...............
Checking Fluid Level .179
.......................................
Shif ting .151
.
Shif t Lever Position Indicator .151
................
Shif t Lever Positions .151
....................
Shif t Lock Release .156
Battery Charging System ...........................
Indicator .53,216
............................
Jump Starting .212
..............................
Maintenance .200
............................
Specif ications .231
..............................
Bef ore Driving .131
..................................
Belts, Seat .10,19
...........................
Beverage Holders .83
..................................
Booster Seats .42
Brakes ...........
Anti-lock System (ABS) .159
.............
Break-in, New Linings .133 ....................
Bulb Replacement .189
...........................................
Fluid .181
.................
System Indicator . 53,218
........................
Wear Indicators .158
.............................
Braking System .158
.................
Break-in, New Vehicle . 133
..
Brightness Control, Instruments . 62
........................
Brights, Headlights .61
Bulb Replacement ..........................
Back-up Lights .189
..............................
Brake Lights .189
................
Front Parking Lights . 187
....................
Front Side Marker . 188
.........
Front Turn Signal Lights . 186
.................................
Headlights .184
.........
High-mount Brake Light . 189
.........
Rear Side Marker Lights . 190
............................
Specif ications .231
..............................
Bulbs, Halogen .184
Index
A
B
INDEX
I