Page 156 of 255
à
à
à
à
To shift from
21
32
43
54 Speed range
under 31 mph (50 km/h)
under 63 mph (100 km/h)
under 94 mph (150 km/h)
under 131 mph (210 km/h) When you are in Sequential
SportShif t mode, and the vehicle is
stopped, push f orward on the shif t
lever to shif t to second gear. You will
see ‘‘2’’ in the display. Starting out in
second gear will help to reduce
wheelspin in deep snow or on a
slippery surf ace.
If you exceed the maximum speed
f or the gear you are in, the engine
speed will enter into the
tachometer’s red zone. If this
occurs,youmayfeeltheengine
cut in and out. This is caused by a
limiter in the engine’s computer
controls. The engine will run
normally when you reduce the
rpm below the red zone.
Automatic Transmission
Starting in Second Gear
Engine Speed L imiter
Driving
155
Page 175 of 255

Make sure the API Certif ication Seal
says ‘‘For Gasoline Engines.’’
The oil’s viscosity or weight is
provided on the container’s label.
5W-20 oil is f ormulated f or year-
round protection of your vehicle, to
improve cold weather starting and
f uel economy.
Unscrew and remove the engine oil
fill cap on the valve cover. Pour in
the oil slowly and caref ully so you do
not spill any. Clean up any spills
immediately. Spilled oil could
damage components in the engine
compartment.
Reinstall the engine oil f ill cap, and
tighten it securely. Wait a f ew
minutes, and recheck the oil level on
the engine oil dipstick. Do not f ill
above the upper mark; you could
damage the engine. Oil is major contributor to your
engine’s perf ormance and longevity.
Always use a premium-grade
detergent oil displaying the API
Certif ication Seal. This seal indicates
the oil is energy conserving, and that
it meets the American Petroleum
Institute’s latest requirements. It is
highly recommended that you use
Acura Precision Craf ted motor oil in
your vehicle.
RSX and Premium models
A dding Engine Oil
Recommended Oil
174
ENGINE OIL FILL CAP
API CERTIFICATION SEAL Ambient Temperature
Page 177 of 255
Open the hood, and remove the
engine oil f ill cap. Remove the oil
drain bolt and washer f rom the
bottom of the engine. Drain the oil
into an appropriate container.Refill the engine with the
recommended oil.
Engine oil change capacity
(including f ilter):
Remove the oil f ilter and let the
remaining oil drain. A special
wrench (available from your
dealer) is required. Put a new washer on the drain bolt,
then reinstall the drain bolt.
Tighten the drain bolt to:
Check the oil f ilter to make sure
its gasket did not stick to the
engine block. A stuck gasket could
cause an oil leak.
Install a new oil f ilter according to
the instructions that come with it.
4. 3.
2. (Type-S) (RSX and Premium models)
Type-S RSX and Premium models
5. 6.
7.
Changing the Oil and Filter
176
WASHER
OIL DRAIN BOLT OIL FILTER
33 lbf·ft (44 N·m , 4.5 kgf·m)
29 lbf·ft (39 N·m , 4.0 kgf·m)
5.0 US qt (4.7
)
4.4 US qt (4.2
)
Page 196 of 255

Î
Î
Î
Î
Î
Î
If you check air pressures when the
tires are hot (driven f or several
miles), you will see readings 4 to 6
psi (30 to 40 kPa, 0.3 to 0.4 kgf /cm )
higher than the cold readings. This
is normal. Do not let air out to match
the recommended cold air pressure.
The tire will be underinf lated.
The following charts show the
recommended cold tire pressures f or
most normal driving conditions and
speeds.
Youshouldgetyourowntire
pressure gauge whenever you check
your tire pressures. This will make it
easier f or you to tell if a pressure
loss is due to a tire problem and not
due to a variation between gauges. Thecompactsparetirepressureis:
While tubeless tires have some
ability to self -seal if they are
punctured, you should look closely
for punctures if a tire starts losing
pressure. Type-S
1:
2:
3: Canadian standard model
U.S. base model and Canadian
premium models
CONT INUED
Tire Size Cold Tire Pressure for
Normal Driving
Front:
Rear:
1
2
3
Recommended Tire Pressures
Normal Driving
Tires
Maint enance
195
60 psi (420 kPa , 4.2 kgf/cm)
31 psi (220 kPa , 2.2 kgf/cm
)
31 psi (220 kPa , 2.2 kgf/cm
)
P195/65R15 89H
P205/55R16 89V
P215/45R17 87V
Page 197 of 255

We strongly recommend that you do
not drive f aster than posted speed
limits and conditions allow. If you
decide it is saf e to drive at high
speeds (over 137 mph or 220 km/h)
be sure to adjust the cold pressures
as shown below. If you do not,
excessive heat can build up and
cause sudden tire f ailure.Tire pressure f or high-speed driving
is the same as f or normal driving.
Every time you check inf lation, you
should also examine the tires for
damage, f oreign objects, and wear.
Youshouldlookfor:
Bumps or bulges in the tread or
side of the tire. Replace the tire if
youfindeitherof theseconditions.
Cuts, splits, or cracks in the side
of the tire. Replace the tire if you
can see f abric or cord.
Excessive tread wear.
For convenience the recommended
tire sizes and cold air pressures are
on a label on the driver’s doorjamb.
For additional inf ormation about
your tires, see page . When you return to normal speed
driving, be sure to readjust the tire
pressure f or normal driving. You
should wait until the tires are cold
bef ore adjusting the tire pressure.
(Type-S model) 232
Tire Size Cold Tire Pressure forHigh-Speed Driving
Front:
Rear:
Type-S model Except Type-S model
Tires
High-Speed DrivingTire Inspection
196
34 psi (230 kPa ,
2.3 kgf/cm
)
34 psi (230 kPa , 2.3 kgf/cm
)
P215/45R17 87V
Page 199 of 255

Wheels:
Tires:
If you ever replace a wheel, make
sure that the wheel’s specif ications
match those of the original wheels.
Replacement wheels are available at
your dealer.
Replace your tires with radial tires of
the same size, load range, speed
rating, and maximum cold tire
pressure rating (as shown on the
tire’s sidewall).
Mixing radial and bias-ply tires on
your vehicle can reduce braking
ability, traction, and steering
accuracy. Using tires of a dif f erent
size or construction can cause the
ABS to work inconsistently.
It is best to replace all f our tires at
thesametime.If thatisnotpossible
or necessary, replace the two f ront
tires or two rear tires as a pair.
Replacing just one tire can seriously
af f ect your vehicle’s handling.
See page f or inf ormation about
DOT Tire Quality Grading and pagef or tire size explanation.
(Type-S models)
(Type-S models)
(U.S.: Base model, Canada: Premium
models)
(U.S.: Base model, Canada: Premium
models)
(Canada: Standard model) (Canada: Standard model)
232
234
Tires
Wheel and T ire Specif ications
Replacing T ires and Wheels
198
15x6JJ
P195/65R15 89H 16x61/2JJ
17x7JJ
P205/55R16 89V
P215/45R17 87V
Installing improper tires on your
vehicle can affect handling and
stability. This can cause a crash
in which you can be seriously
hurt or killed.
Always use the size and type of
tires recommended in this
owner’s manual.