2005 YAMAHA VX110 lock

7-59
E
–+ELEC
REMOTE CONTROL SYSTEM
(DELUXE MODEL ONLY)
REMOTE CONTROL SYSTEM
Yamaha Security System indicator
1. Check:
Yamaha Security System indicator
Check that the “SECURITY” indicator
light 1 comes on when the Yamaha
Security System is deactivated (i.e., the
engine can be started).
Does not come on → Measure the
remote control unit output voltage.
2. Measure:
Remote control unit output voltage
Within specification → Replace the mul-
tifunction meter.
Out of specification → Replace the
remote control unit.
Remote control unit output
voltage:
Blue/yellow (L/Y) – ground
11–13 V
Measurement steps:
Disconnect the remote control unit 1
coupler from the multifunction meter.
Measure the remote control unit output
voltage while pushing the unlock button
of the remote control transmitter.
1
1
L/Y
1
Low-rpm mode indicator
1. Check:
Low-rpm mode indicator
Does not come on → Replace the multi-
function meter.
Checking steps:
Press the unlock button 1 of the remote
control transmitter for more than 4 sec-
onds to select the low-rpm mode.
Check that the beeper sounds three
times and that the “L-MODE” indicator
light 2 comes on.
1
ProCarManuals.com

7-60
E
–+ELEC
REMOTE CONTROL SYSTEM
(DELUXE MODEL ONLY)
Checking the remote control transmitter
1. Check:
Remote control transmitter
Does not operate → Replace the remote
control transmitter.
Checking steps:
CAUTION:
If the buttons on the remote control
transmitter are pushed but the transmit-
ter does not operate, the battery may be
low.
Press the lock button 1 of the remote
control transmitter. The beeper sounds
once.
Check that the “SECURITY” indicator
light goes off and that the engine cannot
be started.
Press the unlock button 2 of the remote
control transmitter for a short time. The
beeper sounds two or three times.
Check that the “SECURITY” indicator
light comes on and that the engine can
be started.
Press the unlock button for more than 4
seconds to select the low-rpm mode.
Check that the beeper sounds three
times and that the “L-MODE” indicator
light comes on.
Number of
beepsYamaha
Security
System modeEngine
startability
1 beep Lock Unable
2 beepsUnlock
(normal mode)Able
3 beepsUnlock
(low-rpm
mode)Able
12
ProCarManuals.com

7-61
E
–+ELEC
REMOTE CONTROL SYSTEM
(DELUXE MODEL ONLY)
NOTE:
If the start switch or the remote control
transmitter is not operated for more than
25 seconds, the multifunction meter dis-
play and the “L-MODE” indicator light will
go off. To change the modes again, press
the lock button for a short time, and then
start the procedures from the lock mode.
While the engine is running, input is not
received from the remote control transmit-
ter.
ProCarManuals.com

E
HULL
HOOD
1
2
3
4
5
6
7
8
9
REMOTE CONTROL CABLES AND SPEED SENSOR LEAD .................... 8-23
EXPLODED DIAGRAM ........................................................................... 8-23
REMOVAL AND INSTALLATION CHART .............................................. 8-23
SERVICE POINTS .................................................................................. 8-26
Remote control cables inspection ..................................................... 8-26
Steering cable (jet pump end) installation ......................................... 8-26
Steering cable stopper installation .................................................... 8-26
Shift cable (jet pump end) installation (Deluxe model only) .............. 8-27
Shift cable (shift lever end) installation (Deluxe model only)............. 8-27
Remote control cables adjustment .................................................... 8-27
SEAT AND HAND GRIP................................................................................ 8-28
EXPLODED DIAGRAM ........................................................................... 8-28
REMOVAL AND INSTALLATION CHART .............................................. 8-28
SERVICE POINTS .................................................................................. 8-30
Seat lock assembly inspection .......................................................... 8-30
EXHAUST SYSTEM ...................................................................................... 8-31
EXPLODED DIAGRAM ........................................................................... 8-31
REMOVAL AND INSTALLATION CHART .............................................. 8-31
SERVICE POINTS .................................................................................. 8-34
Exhaust system inspection................................................................ 8-34
Exhaust component parts sub-assembly .......................................... 8-34
Exhaust system installation ............................................................... 8-35
DECK AND HULL.......................................................................................... 8-36
EXPLODED DIAGRAM ........................................................................... 8-36
REMOVAL AND INSTALLATION CHART .............................................. 8-36
ENGINE MOUNT ........................................................................................... 8-38
EXPLODED DIAGRAM ........................................................................... 8-38
REMOVAL AND INSTALLATION CHART .............................................. 8-38
ProCarManuals.com

8-8
E
HULL
HOODFRONT HOOD
FRONT HOOD
EXPLODED DIAGRAM
REMOVAL AND INSTALLATION CHART
Step Procedure/Part name Q’ty Service points
FRONT HOOD REMOVAL
Follow the left “Step” for removal.
1 Bolt/washer/nut 2/2/2
2 Front hood assembly 1
3Bolt 2
4 Hood lock assembly 1
5 Hinge assembly 1
6Bolt 4
7 Nut/washer 4/4 Deluxe model only
8 Left mirror/seal 1/1 Deluxe model only
4
31011
13
8 7 1
9
52
12
6
5 × 20 mm
1.9 N • m (0.19 kgf • m, 1.4 ft • Ib)
6 × 18 mm
6.9 N • m (0.69 kgf • m, 5.0 ft • Ib)
LT
242
LT
6 × 18 mm
6.9 N • m (0.69 kgf • m, 5.0 ft • Ib)LT
242
LT
15 N • m (1.5 kgf • m, 11 ft • Ib)
LT
572
LT
6 × 95 mm
6.9 N • m (0.69 kgf • m, 5.0 ft • Ib)
1
ProCarManuals.com

8-9
E
HULL
HOODFRONT HOOD
EXPLODED DIAGRAM
Step Procedure/Part name Q’ty Service points
9 Right mirror/seal 1/1 Deluxe model only
10 Rivet 4
11 Storage compartment panel 1
12 Bolt 2
13 Lid lock hook 1
Reverse the removal steps for installation.
4
31011
13
8 7 1
9
52
12
6
5 × 20 mm
1.9 N • m (0.19 kgf • m, 1.4 ft • Ib)
6 × 18 mm
6.9 N • m (0.69 kgf • m, 5.0 ft • Ib)
LT
242
LT
6 × 18 mm
6.9 N • m (0.69 kgf • m, 5.0 ft • Ib)LT
242
LT
15 N • m (1.5 kgf • m, 11 ft • Ib)
LT
572
LT
6 × 95 mm
6.9 N • m (0.69 kgf • m, 5.0 ft • Ib)
1
ProCarManuals.com

8-28
E
HULL
HOODSEAT AND HAND GRIP
SEAT AND HAND GRIP
EXPLODED DIAGRAM
REMOVAL AND INSTALLATION CHART
Step Procedure/Part name Q’ty Service points
SEAT AND HAND GRIP
REMOVALFollow the left “Step” for removal.
1 Seat assembly 1
2Bolt 2
3 Seat lock assembly 1
4 Nut/washer 4/4
5Bolt 4
6 Hand grip 1
7Bolt 1
10
11 10
12
8
4
2
3
9
7
5
6
1
6 × 40 mm
6.4 N • m (0.64 kgf • m, 4.6 ft • Ib)
2
6 × 30 mm
6.9 N • m (0.69 kgf • m, 5.0 ft • Ib)
6 × 23 mm
6.9 N • m (0.69 kgf • m, 5.0 ft • Ib)
15 N • m (1.5 kgf • m, 11 ft • Ib)
10 × 20 mm
26 N • m (2.6 kgf • m, 19 ft • Ib)
LT
271
LT
271
LT
271
ProCarManuals.com

8-30
E
HULL
HOODSEAT AND HAND GRIP
SERVICE POINTS
Seat lock assembly inspection
1. Inspect:
Seat lock assembly
Damage/wear →
Replace.
ProCarManuals.com