8-18
E
HULL
HOODHOSES
EXPLODED DIAGRAM
Step Procedure/Part name Q’ty Service points
3 Ventilation hose 2
4 Fuel tank breather hose 2
5Clamp 1
6 Cooling water hose 1
7Nut 1
8 Cooling water pilot outlet 1
9 Seal 1
Reverse the removal steps for installation.
4
1 7
9
8
5
6
1
11
3
1
1
2
3
21
1
4
4.2 N • m (0.42 kgf • m, 3.0 ft • Ib)
(VENT)
(VENT)
FWD
ProCarManuals.com
8-19
E
HULL
HOOD
SERVICE POINTS
Cooling water pilot outlet installation
1. Install:
Cooling water pilot outlet 1
Seal 2
Nut 3
NOTE:
When installing the cooling water pilot outlet,
face the discharge hole toward the stern and
downward at a 30° angle from the horizontal
line as shown in the illustration.
Tighten the nut while holding the cooling
water pilot outlet in place.
30˚
FWD3
12
Grommet installation
1. Install:
Ventilation hose 1
Grommet 2
NOTE:
Install the grommet on the ventilation hose,
making sure that the end of the hose protrudes
the specified length a from the groove around
the outside of the grommet as shown in the
illustration.
Specified length a:
30–40 mm (1.18–1.57 in)
1
2
a
Ventilation hose assembly installation
1. Install:
Ventilation hose assembly
NOTE:
When installing the ventilation hose assembly,
make sure that the grommet is properly seated
in the hole in the inner hull as shown in the
illustration.
HOSES
ProCarManuals.com
