2005 YAMAHA VX110 length

8-19
E
HULL
HOOD
SERVICE POINTS
Cooling water pilot outlet installation
1. Install:
Cooling water pilot outlet 1

Seal 2

Nut 3

NOTE:
When installing the cooling water pilot outlet,
face the discharge hole toward the stern and
downward at a 30° angle from the horizontal
line as shown in the illustration.
Tighten the nut while holding the cooling
water pilot outlet in place.
30˚
FWD3
12
Grommet installation
1. Install:
Ventilation hose 1

Grommet 2

NOTE:
Install the grommet on the ventilation hose,
making sure that the end of the hose protrudes
the specified length a from the groove around
the outside of the grommet as shown in the
illustration.
Specified length a:
30–40 mm (1.18–1.57 in)
1
2
a
Ventilation hose assembly installation
1. Install:
Ventilation hose assembly
NOTE:
When installing the ventilation hose assembly,
make sure that the grommet is properly seated
in the hole in the inner hull as shown in the
illustration.
HOSES
ProCarManuals.com

8-26
E
HULL
HOOD
REMOTE CONTROL CABLES AND
SPEED SENSOR LEAD
SERVICE POINTS
WARNING
When routing the cables, do not grasp the
cable by the outer crimped sheath or steel
end. This could deform or loosen the cable
end due to extreme angles and or pressure.
Always hold the cables by the outer cover
below the crimp.
If a cable becomes damaged replace it.
Never attempt to repair a damaged cable.
Remote control cables inspection
1. Inspect:
Steering cable
Shift cable (Deluxe model only)
Frays/kinks/rough movement →

Replace.
Steering cable (jet pump end) installation
1. Install:
Steering cable
WARNING
The steering cable must be screwed in at
least 8 mm (0.31 in).
Steering cable set length
a
(jet pump end):
14.5 mm (0.57 in)
Steering cable stopper installation
1. Install:
Steering cable stopper
WARNING
Be sure to the steering cable stopper into
the groove in the outer cable as shown in
the illustration.
ProCarManuals.com

8-27
E
HULL
HOOD
REMOTE CONTROL CABLES AND
SPEED SENSOR LEAD
Shift cable (jet pump end) installation
(Deluxe model only)
1. Install:
Shift cable (jet pump end)
WARNING
The shift cable must be screwed in more
than 8 mm (0.31 in).
Shift cable set length
a
(jet pump end):
13.6 mm (0.54 in)
Shift cable (shift lever end) installation
(Deluxe model only)
1. Install:
Shift cable (shift lever end)
NOTE:
Install the shift cable 1
before securing the
shift lever assembly 2
to the deck.12
Remote control cables adjustment
Refer to “CONTROL SYSTEM” in Chap-
ter 3.
ProCarManuals.com