2005 YAMAHA T105 brake

5. After adjusting, be sure to tighten the
loosened parts.
Tighten the axle nut at specified
torque.
6. Adjust the free play in the brake pedal.
58
Tightening torque:
Axle nut:
60 Nm (6.0 m•kg)
Sprocket shaft nut:
80 Nm (8.0 m•kg)
5AV-F8199-E1-3 8/1/03 1:48 PM Page 58

EAI30601
Brake lever and pedal
Lubricate the pivoting parts.
EAI30801
Center and sidestand
Lubricate the pivoting parts. Check to see
that the center and sidestand move up and
down smoothly.
60
Recommended lubricant:
Yamalube 4 or SAE 20W40 motor oil
Recommended lubricant:
Yamalube 4 or SAE 20W40 motor oil
5AV-F8199-E1-3 8/1/03 1:48 PM Page 60

EAH20501
Front fork inspection
EUU65700
w
Securely support the motorcycle so there
is no danger of it falling over.
Operation check
Place the motorcycle on a level place.
a. Hold the motorcycle in an upright po-
sition and apply the front brake.
b. Stroke the front forks up and down
several times.
EUU42500
cC
If any damage or unsmooth movement is
found with the front fork, consult a
Yamaha dealer.
61
5AV-F8199-E1-3 8/1/03 1:48 PM Page 61

EAK00000
CLEANING AND
STORAGE
EAK01302*
A. CLEANING
Frequent, thorough cleaning of your mo-
torcycle will not only enhance its appear-
ance but will improve its general perfor-
mance and extend the useful life of many
components.
1. Rinse the dirt and degreaser off with a
garden hose.
EUU34602
cC
Excessive hose pressure may cause water
seepage and deterioration of wheel bear-
ings, front fork, brakes, transmission seals
and electrical parts.
2. After cleaning the motorcycle, dry all
surfaces with a chamois, clean towel,
or soft absorbent cloth.3. Dry the chain and lubricate it to pre-
vent rust.
4. Automotive-type wax may be applied
to all painted and chrome-plated sur-
faces. When finished, start the engine
and let it idle for several minutes.
EAK00700
B. STORAGE
Long term storage (60 days or more) of
your motorcycle will require some preven-
tive procedures to guard against deteriora-
tion. After thoroughly cleaning the motor-
cycle, prepare for storage as follows:
1. Drain the fuel tank, fuel lines, and car-
buretor float bowl(s).
2. Remove the empty fuel tank, pour a
cup of SAE 10W30 or 20W40 motor oil
in the tank, shake the tank to coat the
inner surfaces thoroughly and drain
off the excess oil. Reinstall the tank.
67
5AV-F8199-E1-3 8/1/03 1:48 PM Page 67

72
ModelT105E/T105SE
Chassis:
Frmae type Steel Tube underbone
Caster angle 27°
Trail 78 mm
Tire:
Type With tube
Size – Front 2.25-17 33L
Rear 2.50-17 38L
Brake:
Front brake type Drum brake (T105E)
Disk brake (T105SE)
Operation Right hand operation
Rear brake type Drum brake
Operation Right foot operation
Suspension:
Front Telescopic fork
Rear Swing arm
Shock absorber:
Front Coil spring/oil damper
Rear Coil spring/oil damper
5AV-F8199-E1-3 8/1/03 1:48 PM Page 72

73
ModelT105E/T105SE
Wheel travel:
Front 90 mm
Rear 65 mm
Electrical:
Ignition system C.D.I
Generator system Flywheel magneto
Battery type/capacity 12V5AH
Headlight type: Krypton bulb
Bulb wattage/quantity:
Headlight 12V30W/30W ×1
Tail/brake light 12V/5W/21W ×1
Flasher light 12V10W ×4
Meter light 12V1.7W ×1
Indicator light wattage/quantity:
“NEUTRAL” 12V3.4W ×1
“HIGH BEAM” 12V3.4W ×1
“TURN” 12V3.4W ×1
“TOP” 12V3.4W ×1
5AV-F8199-E1-3 8/1/03 1:48 PM Page 73