2005 YAMAHA MAJESTY 180 turn signal

ECA10600
CAUTION
If the breather hose is positioned in
such a way that the frame is expo-
sed to electrolyte or gas expelled
from the battery, the frame could
suffer structural and external
damages.
EAUS1180
Replacing the fuse
1. Main fuse
The fuse holder is located beside the
battery case.
If the fuse is blown, replace it as
follows.1. Turn the key to “OFF” and turn off
all electrical circuits.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage.
ECA10640
CAUTION
Do not use a fuse of a higher ampe-
rage rating than recommended to
avoid causing extensive damage to
the electrical system and possibly a
fire.
3. Turn the key to “ON” and turn on
the electrical circuits to check if
the devices operate.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
EAUS1110
Replacing the headlight bulb
or a front turn signal light
bulb
If a bulb burns out, replace it as
follows.
ECA10670
CAUTION
It is advisable to have a Yamaha
dealer perform this job.
Headlight bulb
1. Remove the front panel by remo-
ving the screws.
EWA10790
s s
WARNING
Headlight bulbs get very hot. The-
refore, keep flammable products
away from a lit headlight bulb, and
do not touch the bulb until it has
cooled down.
2. Remove the defective bulb from
the socket.
3. Insert a new bulb into the socket.
Specified fuse:
20 A
1
6
PERIODIC MAINTENANCE AND MINOR REPAIR
6-20
5XL-F8199-E3.qxd 19/09/2005 16:26 Página 49

4. Install the panel by installing the
screws.
5. Have a Yamaha dealer adjust the
headlight beam if necessary.
Front turn signal light bulb
1. Remove the front panel by remo-
ving the screws.
2. Remove the defective bulb from
the socket.
3. Insert a new bulb into the socket.
4. Install the panel by installing the
screws.
EAU24250
Replacing a front turn signal
light bulb
1. Lens front turn signal
2. Light bulb
1. Remove the front turn signal light
lens by removing the screw.
2. Remove the defective bulb by
pushing it in and turning it coun-
terclockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screw.
ECA11190
CAUTION
Do not overtighten the screw,
otherwise the lens may break.
EAU24310
Replacing the license plate
light bulb
1. License plate light
1. Remove the license plate light
unit by removing the screws.
2. Remove the socket (together
with the bulb) by pulling it out.
3. Remove the defective bulb by
pulling it out.
4. Insert a new bulb into the socket.
5. Install the socket (together with
the bulb) by pushing it in.
6. Install the license plate light unit
by installing the screws.
1
1
2
6
PERIODIC MAINTENANCE AND MINOR REPAIR
6-21
5XL-F8199-E3.qxd 19/09/2005 16:26 Página 50

EAUS1130
Replacing the tail/brake light
bulb or a rear turn signal
light bulb
1. Screw (x2)
Tail/brake light bulb
1. Remove the tail/brake light bulb
lens by removing the screws.
2. Remove the defective bulb by
pushing it in and turning it coun-
terclockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screws.Rear turn signal light bulb
1. Remove the tail/brake light lens
by removing the screws.
2. Remove the left or right turn sig-
nal light bulb lens by pulling it
backwards.
3. Remove the defective bulb by
pushing it in and turning it coun-
terclockwise.
4. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
5. Install the turn signal light bulb
lens.
6. Install the tail/brake light bulb
lens by installing the screws.ECA10680
CAUTION
Do not overtighten the screws,
otherwise the lens may break.
11
6
PERIODIC MAINTENANCE AND MINOR REPAIR
6-22
5XL-F8199-E3.qxd 19/09/2005 16:26 Página 51

Rear tireType
Tubeless
Size
130/70-12 51L
Manufacturer/model
MICHELIN
GHENG SING
PIRELLI
LoadingMaximum load
183 kg
183 kg
Tire air pressure (measured on cold
tires)
Front
190 kPa
Rear
220 kPa
Front wheelWheel type
Cast wheel
Rim size
12 x MT3.50
Rear wheelWheel type
Cast wheel
Rim size
12 x MT3.50
Front brakeType
Single disc brake
Operation
Right hand operationRecommended fluid
DOT 4
Rear brakeType
Single disc brake
Operation
Left hand operation
Recommended fluid
DOT 4
Front suspensionType
Telescopic fork
Spring/shock absorber type
Coil spring/oil damper
Wheel travel
90.0 mm
Rear suspensionType
Unit swing
Spring/shock absorber type
Coil spring/oil damper
Wheel travel
90 mm
Electrical systemIgnition system
CDI
Charging system
AC magneto
BatteryModel
CB7L-B2
Voltage, capacity
12 V, 8 Ah
Bulb voltage, wattage x quantityHeadlight
12 V, 35 W / 35 W x 2
Tail/brake light
12 V, 21 W / 5 W x 2
Front turn signal light
12 V, 21 W x 2
Rear turn signal light
12 V, 10 W x 2
Meter lighting
12 V, 1.2 W x 2
High beam indicator light
12 V, 1.2 W x 1
Oil level warning light
LED
Fuel level warning light
NONE
FusesMain fuse
20 A
Radiator fan fuse
4 A
Reserve fuse
20 A
Reserve fuse
4 A
8
SPECIFICATIONS
8-2
5XL-F8199-E3.qxd 19/09/2005 16:26 Página 59

AAcceleration and deceleration ...................5-2
Adjusting the brake lever free play ..........6-15
Adjusting the carburetor ..........................6-12
Adjusting the rear shock absorber
assemblies ...............................................3-8
Air filter and V-belt case air filter
elements ................................................6-11
BBattery......................................................6-18
Battery voltage/fuel gauge .........................3-3
Braking .......................................................5-2
CCare............................................................7-1
Clock ..........................................................3-4
Controls and Instruments ..........................2-3
Coolant.....................................................6-10
Changing the brake fluid..........................6-16
Checking and lubricating the cables .......6-16
Checking and lubricating the centerstand
and sidestand ........................................6-17
Checking the brake fluid level .................6-15
Checking the front and rear brake pads..6-15
Checking the front fork ............................6-17
Checking the spark plug ............................6-6
Checking the steering ..............................6-17
Checking the throttle cable free play.......6-12
Checking the wheel bearings ..................6-18
EEngine oil ...................................................6-7
FFinal gear oil...............................................6-9
Front brake lever ........................................3-5
Front storage compartment .......................3-7Fuel ............................................................3-6
Fuel tank cap .............................................3-6
HHandlebar switches ...................................3-4
IIdentification numbers ...............................9-1
Indicator lights ...........................................3-1
LLeft view .....................................................2-1
MMain switch ................................................3-1
Model label ................................................9-2
OOwner’s tool kit ..........................................6-1
PParking .......................................................5-3
Periodic maintenance and lubrication
chart .........................................................6-2
Pre-operation check list .............................4-2
RRear brake lever .........................................3-6
Removing and installing cowlings and
panels ......................................................6-5
Replacing a front turn signal light bulb....6-21
Replacing the fuse ...................................6-20
Replacing the headlight bulb or a front
turn signal light bulb ..............................6-20
Replacing the license plate light bulb......6-21
Replacing the tail/brake light bulb or a
rear turn signal light bulb.......................6-22
Right view ..................................................2-2
SSeat ............................................................3-7
Sidestand ...................................................3-8Sidestand switch operation check ............3-9
Speedometer unit ......................................3-3
Starting a cold engine ................................5-1
Starting off .................................................5-2
Storage.......................................................7-3
Storage compartment ................................3-7
TTires .........................................................6-13
Troubleshooting .......................................6-23
Troubleshooting chart ..............................6-24
INDEX
5XL-F8199-E3.qxd 19/09/2005 16:26 Página 62