Page 62 of 398
4-1
EBU00040
1-CONTROL FUNCTIONS
EBU00942
Main switch
Functions of the respective switch positions are as
follows:
ON:
The engine can be started only at this position and
the headlights and taillight come on when the light
switch is on.
OFF:
All electrical circuits are switched off. The key can
be removed in this position.
U1C160.book Page 1 Wednesday, May 12, 2004 4:55 PM
Page 76 of 398
4-15
EBU12040
Light switch “/ /OFF”
Set the switch to “” to turn on the low beam and
the taillight.
Set the switch to “” to turn on the high beam
and the taillight.
Set the switch to “OFF” to turn off all the lights.CAUTION:_ Do not use the headlights with the engine
turned off for more than thirty minutes. The
battery may discharge to the point that the
starter motor will not operate properly. If this
should happen, remove the battery and re-
charge it. _
EBU00059
Horn switch “”
Press the switch to sound the horn.
U1C160.book Page 15 Wednesday, May 12, 2004 4:55 PM
Page 106 of 398
4-45
CAUTION:_
Do not use accessories requiring more
than the above maximum capacity. This
may overload the circuit and cause the
fuse to blow.
If accessories are used without the engine
running or with the headlights turned on,
the battery will lose its charge and engine
starting may become difficult.
Do not use an automotive cigarette lighter
or other accessories with a plug that gets
hot because the jack can be damaged.
_
U1C160.book Page 45 Wednesday, May 12, 2004 4:55 PM
Page 124 of 398
5-17
EBU11620
Fittings and fasteners
Always check the tightness of chassis fittings and
fasteners before a ride. Take the machine to a
Yamaha dealer or refer to the Service Manual for
correct tightening torque.
EBU01003
Lights
Check the headlights and tail/brake light to make
sure they are in working condition. Repair as nec-
essary for proper operation.
EBU11700
Switches
Check the operation of all switches. Have a
Yamaha dealer repair as necessary for proper op-
eration.
U1C160.book Page 17 Wednesday, May 12, 2004 4:55 PM
