2005 YAMAHA BANSHEE 350 low beam

Cooling system ...................................8-23
Spark plug inspection .........................8-39
Air filter element cleaning ...................8-43
Carburetor settings .............................8-51
Idle speed adjustment ........................8-67
Throttle lever adjustment ....................8-71
Front and rear brake pad
inspection .........................................8-73
Brake fluid level check ........................8-75
Brake fluid replacement ......................8-79
Front brake lever free play .................8-81
Brake pedal height adjustment ...........8-83
Parking brake adjustment ...................8-85
Adjusting the rear brake light switch ...8-89
Clutch adjustment ...............................8-91
Drive chain slack check ......................8-91
Drive chain slack adjustment ..............8-93
Lubricating the drive chain .................8-95
Cable inspection and lubrication ........8-99Brake and shift pedal/brake and
clutch lever lubrication ....................8-101
Lubricating the front upper and
lower arm pivots .............................8-101
Rear arm pivot lubrication ................8-103
Wheel removal .................................8-105
Wheel installation .............................8-105
Replacing the headlight bulb ............8-107
Headlight beam adjustment ..............8-111
Tail/brake light bulb replacement .....8-113
Troubleshooting ................................8-115
Troubleshooting chart .......................8-119
CLEANING AND STORAGE ...................9-1
A. Cleaning ...........................................9-1
B. Storage ............................................9-7
SPECIFICATIONS .................................10-1
10
9
5FK-9-66-01 12/3/04 6:36 PM Page 14

4-3
EBU00053
Handlebar switches
EBU11580
Engine stop switch “ENG. STOP”
Make sure that the engine stop switch is in the
“RUN” position before starting the engine. The
engine stop switch controls ignition and can be
used at all times to stop the engine, especially in
an emergency. The engine will not start or run
when the engine stop switch is turned to “OFF”.
EBU13741
Light switch “LIGHTS”
Set the switch to the “LO” position to turn on the
low beam and the taillight.
Set the switch to the “HI” position to turn on the
high beam and the taillight.
Set the switch to the “OFF” position to turn off all
the lights.
NOTE:
The headlights and the taillight can be turned on
only when the engine is started.
q
w
1. Light switch “LIGHTS” 2. Engine stop switch
“ENG. STOP”
1. Contacteur d’éclairage 2. Coupe-circuit du moteur
“LIGHTS” “ENG. STOP”
1. Interruptor de luces 2. Interruptor de paro del
“LIGHTS” motor “ENG. STOP”
5FK-9-66-02 12/3/04 6:36 PM Page 4

8-111
EBU01089
Headlight beam adjustment
cC
It is advisable to have a Yamaha dealer make
this adjustment.
To raise the beam, turn the adjusting screw in
direction a.
To lower the beam, turn the adjusting screw in
direction b.b
1
a
1. Adjusting screw1. Vis de réglage1. Tornillo de ajuste
cC
Make sure the bulb holder cover is securely
fitted over the bulb holder and seated
against the reflector.
6. Install the headlight unit assembly.
7. Adjust the headlight beam if necessary.
5FK-9-66-05 12/3/04 7:54 PM Page 112