Page 75 of 120

CAUTION:
Check local regulations regarding the use of snow chains before installing.
Always follow the chain manufacturer's installation instructions carefully. Install chains as tightly as possible and
retighten periodically.
Never exceed the chain manufacturer's specified maximum speed limit. (Under no circumstances should you exceed
31 mph (50 km/h)).
Avoid bumps, holes or sharp turns when driving with snow chains.
The handling of the vehicle can be adversely affected when driving with chains. Avoid fast or sharp turns as well as
locked wheel braking.
Snow tires, studded tires
1
Tires for winter use:
Owners who live in or regularly commute through areas with sustained periods of snow or icy driving conditions are
strongly advised to fit suitable winter tires to help retain the highest degree of traction.
It is important to install winter tires on all four wheels to help retain traction during cornering, braking, and
accelerating. Failure to do so could reduce traction to an unsafe level or adversely affect handling.
Do not mix tires of different design as this could also negatively affect overall tire road grip.
Winter tires wear more quickly on dry roads in warm weather. They should be removed when the winter driving
season has ended.
Studded tires should be run-in 300-600 miles (500-1000 km) during which the car should be driven as smoothly as
possible to give the studs the opportunity to seat properly in the tires. The tires should have the same rotational
direction throughout their entire lifetime.
NOTE: Please consult state or provincial regulations restricting the use of studded winter tires before installing such
tires.
1 Where permitted
pg. 125 Wheels and tires
Temporary Spare
The spare tire in your car is called a "Temporary Spare".
Recommended tire pressure (see the placard on the B-pillar or on the fuel filler door) should be maintained irrespective
of which position on the car the temporary spare tire is used on.
In the event of damage to this tire, a new one can be purchased from your Volvo retailer.
WARNING!
Current legislation prohibits the use of the "Temporary Spare" tire other than as a temporary replacement for a
punctured tire. It must be replaced as soon as possible by a standard tire. Road holding and handling may be affected
with the "Temporary Spare" in use. Do not exceed 50 mph (80 km/h). Do not drive farther than 50 miles (80 km) on
a temporary spare tire.
CAUTION:
The car must not be driven with wheels of different dimensions or with a spare tire other than the one that came with
the car. The use of different size wheels can seriously damage your car's transmission.
ProCarManuals.com
Page 76 of 120

pg. 126 Wheels and tires
Changing wheels
Insert flat end of lug wrench and turn/pull straight out
Changing wheels
The spare wheel is located under the carpet on the trunk floor. The jack and crank are secured in the wheel recess.
There are two jack attachment points on each side of the car (see illustration on next page).
To change a wheel:
Engage the parking brake.
Put the gear selector in (P)ark (automatic transmission) or reverse (manual transmission).
Loosen the wheel bolts
Remove the wheel cap (where applicable) using the lug wrench in the tool bag.
With the car still on the ground, use the lug wrench to loosen the wheel bolts 1/2 - 1 turn. Turn the bolts
counterclockwise to loosen.
CAUTION:
The car must not be driven with wheels of different dimensions or with a spare tire other than the one that came with
the car. The use of different size wheels can seriously damage your car's transmission.
Correct tightening torque on wheel bolts must be observed. The wheel bolts should never be greased or lubricated. The
extended, chromed wheel bolts must not be used with steel rims, as they make it impossible to fit the hub caps.
ProCarManuals.com
Page 77 of 120

pg. 127 Wheels and tires
Attaching the jack
Position the jack correctly on the bar in the attachment (see illustration above) and crank while simultaneously
guiding the base of the jack to the ground. The base of the jack must be flat on a level, firm, non-slippery surface.
Before raising the car, check that the jack is still correctly positioned in the attachment.
Raise the vehicle until the wheel to be changed is lifted off the ground.
Unscrew the wheel bolts completely and carefully remove the wheel so as not to damage the threads on the studs.
NOTE: To avoid excessive wear and the necessity of rebalancing, mark and reinstall wheels in the same location and
position as before removal. To lessen the chance of imbalance, each wheel hub is equipped with a guide stud to ensure
that a removed wheel can be reinstalled in its original position (as when changing over to winter tires/wheels).
Installing the wheel
Clean the contact surfaces on the wheel and hub.
Lift the wheel and place it on the hub.
Install the wheel bolts and tighten hand -tight. Using the lug wrench, tighten crosswise until all bolts are snug.
Lower the vehicle to the ground and alternately tighten the bolts crosswise to 102 ft. lbs. (140 Nm).
Install the wheel cap (where applicable).
WARNING!
The jack must correctly engage the bar in the jack attachment. The car's weight must not rest on the jack attachment.
See illustration "Attaching the jack" above.
Be sure the jack is on a firm, level, non-slippery surface.
Never allow any part of your body to be extended under a car supported by a jack. Use the jack intended for the car
when replacing a wheel. For any other job, use stands to support the side of the car being worked on.
Apply the parking brake and put the gear selector in the ( P)ark position (or reverse on manual transmissions).
Block the wheels standing on the ground, use rigid wooden blocks or large stones. The jack should be kept well-
ProCarManuals.com
Page 115 of 120
Rear park assist112
Rear seat, folding backrests69
Rear suspension168
Rear window defroster38 , 57
Rearview mirror/door mirrors45
Recirculation54 , 58
REDUCE SPEED30
Refrigerant (A/C system)50
Refueling83, 86
Remote control - central locking system75
Replacing the battery147
Reporting safety defects24
Roadholding90
Roof racks (load carriers)109
Run flat tires119
S
Safety1
Safety defects - reporting24
Safety system warning light6
Seat belt2
Seat belt maintenance24
Seat belt reminder45
Seat belts (keeping child seats in place)23
SEE MANUAL30
Self supporting run flat tires119
Service136
Service key74
Service reminder29
SERVICE REQUIRED30
SERVICE URGENT30
Shiftlockii , 87
Side airbags12
Side marker lamp153
Side marker light, changing152
SIPS airbags12
Ski hatch70
Snow chains124, 126
Snow tires124
Spare wheel70
Spark plugs170
Specifications161
Speedometer26
Sport mode95
SRS4
ProCarManuals.com
Page 116 of 120

Stability systems100
Stability Traction Control (STC)100
Start inhibitor (immobilizer)74
Starting the car87
STC31
Steering wheel adjustment33
Steering wheel lock88
Stone chips, touching up133
STOP ENGINE30
Storage compartments67
Studded tires124
Sun visor47
Supplemental Restraint System (SRS)4
Supplemental Restraint System (SRS) - warning light29
Suspension168
Switches in the center console31
T
Tachometer26
Temperature control53
Temperature gauge26
Text window - messages30
TIME FOR REGULAR SERVICE30
Tire designations120
Tires economy - improving114
Tires inflation115
Tire inflation pressure tables117
Tire inflation pressure, checking116
Tire pressure monitoring system29
Tire Pressure Monitoring System (TPMS)118
Tire terminology, glossary of121
Tires - tread wear indicators126
Towing - cars with All Wheel Drive103
Towing a trailer105
Towing the car102
Trailer indicator lamp29
Trailer towing105
Transmission - automatic92
Transmission - Geartronic94
Transmission - manual91
Tread wear indicator114
Trip computer39
Trip odometer26
Trunk69
Trunk - opening from the inside78
ProCarManuals.com
Page:
< prev 1-8 9-16 17-24