Booklet 3.1 and Equipment
Applies to
one of the fig . 78
turn th e fan Th e light in
th e button will go out.
Temperature
There are separate selectors for the left and right sides oft he ve hicle imerior. lected te mperature is displayed above le ctor. is possibl e to select imerior tures from6lo F to 86 oF T hese arc approximate temperatu res and th e temperawre m ay be slightly higher or lower pending on the outsid e conditions.
a temperature below is select e d the di spla y sw itches to
the tempe rature is no t roll ed .
If a temperature F is lected the displny switc he s to
have the fan running at a low selling w
hen dri ving
at lo w speeds to make sure there is
a cons flow of fresh air into th e ve hicle. If the fa n is set to the
to control the air d is tribution. a function is sw itched on.
the bu11on ligh ts up. p ossible to o pen and close som e of the air outlets separate ly .
Switch ing the on/off
The
switching off the cooling system
Use butlon to switc h on th e economy
mode. the buuon lig hts comes on, th e
cooling system switch es ofT to fu el. At low outside temperatu res, heating performance in
Econo my ope ratio n will be less after the e ng in e
i s started.
Air system 81
(a combined and active charcoal
must be replaced
due to
usc in area s w ith very high levels of air pollution , the quemly than specified in your Ma intenance booklet..
system malfunctions
If the coolin g system cannot be switched on. it may be clue to the
the engin e has no t been
the is swit ched off
outside temperature is below F
th e cooling system comp resso r
th ere is some other problem H ave the air-conditionin g syste m checked your authorized Volkswage n dealer or qualified
wo rkshop.
visib ility increases the risk of and other accidents.
make sure windows arc of ic c, snow, and conden sa tion for good vis ibilit y -out the windshield. sid e windows.
heating output and fas t fro stin g w ill only occur
the operation of the heating and ventilation system, including the defog/defros t fealllres you w ill need for good vis ibility.
No te that with plete ly , no outside enters the inte rior. with Climatronicswitched off, open a window or the power to provide adequate fre sh
Note
If yo u suspect that the conditioning
sys te m has been damage d or is not working properly, sw itch over to m ode to preve m
m ore damage and have the system c hecked by
your authorized Volk swage n dealer or a fied workshop.
Repair s to th e a ir conditioning syste m quire specia l knowledge and special tools.
Th ere for e, we recommend that you go to an thorized
Do not smoke w hil e ai r re ci rcu lation mode is on. smoke drawn into the climate-comrol system can leave a residue on the evaporator.
prod ucing permanent unpleasant odor.
Tip s
if the humidity
pool th e veh icle. This is normal and is not
Keep the air in front of the shi eld free of snow, ice and leave s to ensure impai red heatin g and coolin g and preve nt the
w in d ows from fogging over.
The conditioning system works best when the windows and the power roof15l heate d up in the sun,
th e in side air can be coo led faster by opening the wind ows to let the hot ai r
Air Conditioning system 83
Booklet 3.1 Controls and Equipment
Automatic transmission (Direct shift gearbox}
Applies to vehicles: with automatic transmission
Transmission programs
82 into
posit ion D (Dri ve ).
Selecting the sport program
-Move the selector lever into positionS
D Dri ve
If you select the standard program you
88 Driving
drivin g downhill in D. the eng in e docs not brak e
the
{Sport)
If yo u selec t th e spo rt pro gram you be driving in sport mod e. forward shift and down-shift automaticall y higher gine s peeds depending on en gin e load, your dividual driving style and the vehicle speed.
While driving downhill the e ngin e doe s not brak e the
Switching with the rocker switch on the steering
w heel
If yo u pres s the rocker page fig. 86 while in mode or Sport m ode. it
sw itches temporarily to m ode. If yo u would like to exit 'Tiptronic® " mod e again,
press the right rocker switch+ towards the
steering w heel for about one second. mode is also exited if the rocker switches not pressed for approx im atel y lO to seconds.
For the sake of environment
Driving in uses less fuel than driving inS.
Tips
The displa y in the inst rum ent clu ster shows the
gear selected in ad dition to the t ra n smission
pro gram being used. or
3.2 Tips and Advice
refers to the amount of air in a tire that it needs it to do its job and safe ly carry the combined load of the entire
on the d esign and load limit-the greatest amount of we ight that the can carry safel y and the tire size.
Th e proper lire pressure is frequently re ferred to a s the "recommended co ld tire inflation
It is the tion pre ssure in a tire that counts .
respo nsiv e
is being driven at higher speed s, and th e n cially w hen heavily loaded even within the missible load-carrying capacit ies approved for your vehicl e. T
he r
ecommended tire pressures for your d epend on the kind or tires on your h icl e and the number of passengers and/or amount ofluggage you will be t ransporting.
Th e tire
pressure label on the open ed ge of th e
driver's door on your Volk swagen lists the ommended co ld tir e infl ation pressures for the
at th e tim e it was ufactured.
page fig. 15 for the tion of the label on the open edge of the driver's door (colo r of the actual label and exact locat ion on the
flap.
The table below lists the recommended cold tire
i nflatio n pressures for the models covered by your maximum capacit y we igh t and th e tire
sizes on t h e res pective models as inal equipment, or as a factory opti on.
T ir e Tire
pres-Tire pres-
s ur e front sure rear
kPa
17 91 35 245 35 245
6
1
to the USA models
The tire pressure monitoring system helps the driver to keep track of tire pressures.
Fig. 16 Section of the center console: button for tire
p ressure monitoring disploy
T he tir e pressure monitoring system keep s
track
of air pressure at the four wheels
w hil e yo u
are driving using sen so rs on th e
tir
es and alerts the dri ver if th ere is a lo ss of
pressure with a visual or audibl e warning.
Status inquiry
-
play the status (partial or full load) for
m
onito ring tir e press ures in the
ment clu ster display.
Adjusting
the fig. 16 for more than
two seconds to inform th e system of
hicle load condition.
Switching on
-the fig. 16 for about two
seconds to switch the tire press ure
tori ng syste m on. The system is in
after it is switched o n. The
system
switches on autom atic ally as soon
as a sig nal is receive d from a sensor.
Switching off
-page 65, fig. 16 for
lo nger than te n seconds to switch th e ti re
pressure monito ring system off. The
system switches off automatically if no
sensor sig na l i s received aft e r th e vehicle
has been statio nary for about twenty
th e a id of se nso rs at t h e w heels . The tir e pressure monitoring syste m
rece ives a wireless transmissio n of these sage from the senso rs. In the event of a rapid or severe loss of pressu re wh ile yo u are driving, you are immediately given a visual and/or acoust ic
warning .
65
Booklet 3.2 Tips and Advice
Changing
Light bulbs should be changed by a qualified technician
m an y cases changing a light bul b
invol ves remov in g other pa ns of the car to
recommen d light bulbs o nl y be chan ge d
b y an authorized Volkswage n dea le r or qual ified workshop.
Before changin g a light bulb. yo u must sw itch ofT the light (lig ht switch in
tical light bulbs w ith sam e s pecificati o ns. The
s p ecifi catio ns arc prime d on the lig h t bulb . ther on the glass bulb or o n th e m eta l base.
is advi sable to alw ay s carry a box of
for traffi c safe ty. swage n dealer for re comm ended light bulbs.
Additional light specificati o ns
light bulbs in the headli gh ts or in verse lights can hav e fac tory-set s pecifi cntion s that diffe r fro m conventi onnllight bulbs. Th e corresp onding model identifi cation is either on the bulb bas e or on th e bulb itself.
LL = LongLife bulbs w ith a lo nger life compared to con ve ntional light bulb s.
Blue =
Light bulbs w ith blui sh -w hite abl e for di scharge light s (Xenon/Bi-Xcno n light s).
Stop! Before workin g in the engine always read and heed all
94 What do
(cont inued)
page 39. The engine compartment of any motor vehicl e is a p otentiall y dangerous area and can cause serious personal injury.
Gas discharge la m ps (Xen on) get power from a high voltage source that can cause rious personal injury and even death if dled improperly.
bulbs arc under hi gh pressure and can exp lode if handled improperly.
Always have a qualified technician r eplace burnt-out light bulbs, especially gas discharge
lamp s (Xenon) and bulbs.
Neve r remove the headlight unless you know exactly how to carry out the job and have the correct tool and li ght bulbs.
yo u arc uncertain about what to do, have the work performed by an auth orize d swagen d ealer or a qualified workshop. rious personal injury m ay result from erly performe d work.
There arc parts w ith sh arp edges on the headlight h ousin g in the en gi ne compartment and on the rear light h o usings.
Do not touc h glass bulb with bare hands. can clo ud the o uter surface of the bul b when thus afTccting the refle ction , and th us reducing the power of illuminat ion.
A bulb can only be re placed b y a bulb of the sam e ty pe . The m odel identifica tion is either o n the bulb base or on the bulb itself.
-Place the flat blade of th e screwdri ver
into the fig. 42
the cover off care full y in the dir ec
tio n of the a rrow.
Replacing
th e ig nit ion off and remove th e
key fr
om the ig nitio n lock.
- T
urn the lamp holder upwards and pull
the lamp holder out alo ng w ith the lig ht
bulb.
- Rep l
ace th e light bulb.
- Install
the lamp h o lder w ith the new
light bulb.
-
Turn t h e lamp hold er against the direc
tio n of th e a rrow back to its o rigina l posi
tion until it e n gages.
Booklet 3.2 Tips and Advice
-Press on the cove r until it engages
firmly.
There are parts with sharp ed ges on the opening and on the lamp holder. h and protection when yo u replace bulbs .
authorized Volk
s w age n dealer or a qu alifi ed workshop. rious person al injury may
Do not touch glass bulb with hands. Fingerprints can cloud the outer s u rface of the bulb
w hen heated. thus affect ing th e reflection, th us reducing the power of illumin at io n .
A bulb can o nly be rep laced by a bulb of the sam e type. The model identificat io n i s ei ther on the bulb base or on the bulb
cables must h ave sufficient wire cross section.
the engine does not is
disch arged, your vehicle's can be connected the batt ery of another vehicle to start the engine.
Jumpe r cables
T he wi re cross section mu st be in2
(25 1111112
) fo r g asoli ne e ngines.
Do no t let the ve hicles each other, o therwise current could flow as soon as th e plus(+) terminals areconnected.lf necessary.use longer jumpe r cables.
T he discharged battery must be p roperly connected to th e ve hicle's
What do