2005 TOYOTA YARIS head light

2042005 ECHO HATCHBACK from Jul. ’04Prod. (OM52624U)
Replacing light bulbs—
The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION

To prevent burning yourself, do not
replace the light bulbs while they
are hot.

Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter if
scratched or dropped. Hold a bulb
only by its plastic or metal case.
Do not touch the glass part of a
bulb with bare hands.
NOTICE
Only use a bulb of the listed type.
The inside of the lens of exterior lights
such as headlights may temporarily fog up
when the lens becomes wet in the rain or
in a car wash. This is not a problem
because the fogging is caused by the
temperature difference between the outside
and inside of the lens, just like the
windshield fogs up in the rain. However, if
there is a large drop of water on the
inside of the lens, or if there is water
pooled inside the light, contact your
Toyota dealer.Light bulbsBulb
No.WTy p e
HeadlightsHB260/55A
Parking lightsW5W5C
Front side marker
lights1943.8C
Front turn signal
lights744321D
Side turn signal
lightsW5W5C∗
Rear turn signal
lightsPY21W21B
Stop/tail and rear
side marker lights744321/5C
Back −up lights744021C
License plate lightsW5W5C
High mounted
stoplight92118C
Interior light—8E
Personal light—8C
Luggage
compartment light—5E
04 04.06

2052005 ECHO HATCHBACK from Jul. ’04Prod. (OM52624U)
∗: Side turn signal lights should be re-
placed as an assembly.
A: HB2 halogen bulbs
B: Single end bulbs (amber)
C: Wedge base bulbs
D: Wedge base bulbs (amber)
E: Double end bulbs
—Headlights
SH73015
1. Open the hood. Unplug the connec- tor. Remove the rubber cover.
If the connector is tight, wiggle it.
SH73016
2. Release the bulb retaining spring and remove the bulb. Install a new
bulb and the bulb retaining spring.
To install a bulb, align the tabs of the
bulb with the cutouts of the mounting
hole.
04 04.06

2062005 ECHO HATCHBACK from Jul. ’04Prod. (OM52624U)
SU73057
3. Install the rubber cover as shownand fit it securely on the boss. Plug
in the connector.
Make sure the rubber cover fits securely
on the connector and the headlight body.
Aiming is not necessary after replacing
the bulb. When aiming adjustment is nec-
essary, contact your Toyota dealer.
—Parking lights
SH73024
Use a Phillips −head screwdriver.
SH73050
—Front side marker lights
SH73024
Use a Phillips −head screwdriver.
SU73064a
04 04.06

2172005 ECHO HATCHBACK from Jul. ’04Prod. (OM52624U)
Tires
Tire size and cold tire inflation
pressure:Tire size kPa (kgf/cm
2 or bar, psi)
Standard P175/65R14 81S 220 (2.2, 32)
Spare T115/70D14 420 (4.2, 60)
Wheel size: Standard14 x 5 1/2J, 14 x 5 1/2JJ
S par e 14 x 4T
Wheel nut torque, N·m (kgf·m,
ft·Ibf): 103 (10.5, 76)
N O T E : Fo r a co m p l e t e in f o r m a t i o n on tires (e.g. replacing tires or
replacing wheels), see
“Checking tire inflation
pressure” through
“Aluminum wheel
precautions”, page 191
through 198 in Section 7 −2.
Fuses
SU81005
Engine compartment
Fuses (type A)
1. P/POINT 15 A: No circuit
2. H −LP RH/H −LP LO RH 10 A: Right−
hand headlight
3. H −LP LH/H −LP LO LH 10 A: Left−
hand headlight
4. ST 30 A: Starter system
5. AM2 15 A: Starter system, SRS airbag
system, multiport fuel injection sys-
tem/sequential multiport fuel injection
system, discharge warning system
6. HORN 15 A: Horn
SU81006
Instrument panel
7. EFI 15 A: Multiport fuel injection sys-
tem/sequential multiport fuel injection
system
8. DOME 15 A: Interior light, gauges of
meters
9. SPARE 15 A: Spare
10. SPARE 30 A: Spare
11. GAUGE 10 A: Back−up lights, charging
system, air c onditioning system,
gauges of meters
12. ACC 15 A: Cigarette lighter
13. A.C 7.5 A: Air conditioning system
04 04.06