2005 TOYOTA SIENNA instrument panel

05 SIENNA_U (L/O 0409)
338
2005 SIENNA from Sep. ’04 Prod. (OM45431U)
To reset the hour: Push the “H” button.
To reset the minutes: Push the “M” button.
The key must be in the “ACC” or “ON”
position.
If the electrical power source has been
disconnected from the clock, the time dis-
play will automatically be set to 1:00.
When the instrument panel lights are
turned on, the brightness of the time in-
dication will be reduced.The conversation mirror is designed for
the driver and front passenger to be
able to look at the rear passengers
without turning around.
CAUTION
Do not adjust the mirror while the
vehicle is moving. Be sure to adjust
the mirror only when the vehicle is
stopped.
To use the mirror, push it down.
Conversation mirror

05 SIENNA_U (L/O 0409)
351
2005 SIENNA from Sep. ’04 Prod. (OM45431U)
Beside second seat
Beside third seat
The power outlets (115 VAC) are de-
signed for use as a power supply for
electric appliances in the vehicle.
The key must be in the “ON” position for
the power outlet to be used.
The maximum capacity for this power out-
let is 115 VAC/100W. If you attempt to
use an appliance that requires more than
115 VAC or 100W, the protection circuit
will activate and cut the power supply.
The power supply will restart automatically
when you use an appliance that operates
within the 115 VAC/100W limits.
To use the power outlet, push the main
switch on the instrument panel.
An indicator light will illuminate to indicate
that the power outlet is ready for use.
Push the main switch once again to turn
the power outlet off. When the power out-
let is not in use, make sure that the main
switch is turned off.
Power outlets (115 VAC)

05 SIENNA_U (L/O 0409)
356
2005 SIENNA from Sep. ’04 Prod. (OM45431U)
NOTICE
Type A and L—During hot weather,
the interior of the vehicle becomes
very hot. Do not leave anything
flammable or deformable such as a
lighter, glasses, etc. inside.
 Type L—To prevent damage to the
auxiliary box, do not place any ob-
ject heavier than 250 g (0.55 lb.) in
it.
Type A (driver’s side roof)
Type B (instrument panel)
Position 1 Position 2
Type C (instrument panel without seat
heater switches)

05 SIENNA_U (L/O 0409)
357
2005 SIENNA from Sep. ’04 Prod. (OM45431U)
Type D (instrument panel with seat heater
switches)
Type E (upper side of the glove box)
Type F (front door)
Type G (quarter trim)
Type H (spare tire cover)
Type I (front seat side table)

05 SIENNA_U (L/O 0409)
359
2005 SIENNA from Sep. ’04 Prod. (OM45431U)
The cup holder is designed for holding
cups or drinkcans. To use them, ob-
serve the following illustrations.
Type C and D—For details, see “Front
seat side table” on page 367 in this Sec-
tion.
Type G—For details, see “Removable con-
sole box” on page 362 in this Section.
CAUTION
Do not place anything else other
than cups or drinkcans in the cup
holder, as such items may be
thrown about and possibly injure
people in the vehicle during sudden
braking or in an accident.
Type A and F—To reduce the
chance of injury in case of an acci-
dent or a sudden stop while driv-
ing, keep the cup holder closed
when it is not in use.
Type A (instrument panel)
Type B (quarter trim)
Type C (front side of the front seat side
table)
Type D (rear side of the front seat side
table)
Cup holders

05 SIENNA_U (L/O 0409)
369
2005 SIENNA from Sep. ’04 Prod. (OM45431U)
These hooks are designed to hang
things like grocery bags.
Type A—To use the hook, pull it down.
Type D—To use the hook, pull it up.
CAUTION
Type A and D—To reduce the chance
of injury in case of an accident or a
sudden stop while driving, keep the
hook stored when it is not in use.
NOTICE
Type A, B, and C—To prevent dam-
age to the hook, do not hang any
object heavier than 4 kg (8.8 lb.) in
it.
 Type D—To prevent damage to the
hook, avoid hanging heavy loads on
it.
Type A (instrument panel)
Type B (front seats)
Type C (third seats)
Type D (under the back door)
Gro cery bag ho o ks

05 SIENNA_U (L/O 0409)
386
2005 SIENNA from Sep. ’04 Prod. (OM45431U)
The brake pad wear limit indicators on
your disc brakes give a warning noise
when the brake pads are worn to where
replacement is required.
If you hear a squealing or scraping noise
while driving, have the brake pads
checked and replaced by your Toyota
dealer as soon as possible. Expensive ro-
tor damage can result if the pads are not
replaced when necessary.The vehicle identification number (VIN)
is the legal identifier for your vehicle.
This number is on the left top of the
instrument panel, and can be seen
through the windshield from outside.
This is the primary identification number
for your Toyota. It is used in registering
the ownership of your vehicle.The vehicle identification number (VIN) is
also on the Certification Label.
Brake pad wear limit
indicatorsYour Toyota’s identification—
—Vehicle identification
number

05 SIENNA_U (L/O 0409)
399
2005 SIENNA from Sep. ’04 Prod. (OM45431U)
When stowing cargo and luggage in
the vehicle, observe the following: Put cargo and luggage in the lug-
gage compartment when at all
possible. Be sure all items are se-
cured in place.
 Be careful to keep the vehicle bal-
anced. Locating the weight as far
forward as possible helps maintain
balance.
 For better fuel economy, do not
carry unneeded weight.
CAUTION
To prevent cargo and l uggage
from sliding forward during
braking, do not stack anything
in the luggage compartment
higher than the seatbacks.
Keep cargo and luggage low,
as close to the floor as pos-
sible.
 Never allow anyone to ride in
the luggage compartment. It is
not designed for passengers.
They should ride in their seats
with their seat belts properly
fastened. Otherwise, they are
much more likely to suffer seri-
ous bodily injury, in the event
of sudden braking or a colli-
sion.
 Do not drive with objects left
on top of the instrument panel.
They may interfere with the
driver’s field of view. Or they
may move during sharp vehicle
acceleration or turning, and im-
pair the driver’s control of the
vehicle. In an accident they
may injure the vehicle occu-
pants.Cargo capacity depends on the to-
tal weight of the occupants.
(Cargo capacity) = (Total load capac-
ity) – (Total weight of occupants)
STEPS FOR DETERMINING
CORRECT LOAD LIMIT
1. Locate the statement “The com- bined weight of occupants and
cargo should never exceed XXX
pounds” on your vehicle’s placard.
2. Determine the combined weight of the driver and passengers that will
be riding in your vehicle.
3. Subtract the combined weight of the driver and passengers from
XXX kilograms or XXX pounds.
4. The resulting figure equals the available amount of cargo and lug-
gage load capacity. For example,
if the “XXX” am ount equals 1400
lbs. and there will be five 150 lb.
passengers in your vehicle, the
amount of available cargo and lug-
gage load capacity is 650 lbs.
(1400–750 (5x150)=650 lbs).
Cargo and luggage—
—Stowage precautions —Capacity and distribution