2005 TOYOTA HIGHLANDER warning light

[x] Cancel search: warning light

Page 152 of 430

TOYOTA HIGHLANDER 2005 XU20 / 1.G Owners Manual ’05 HIGHLANDER_U (L/O 0409)
142
2005 HIGHLANDER from Nov. ’04 Prod. (OM48570U)
Tw o−wheel drive models only—The “TRAC
OFF” indicator light will come on when the
“VSC” warning light com

Page 153 of 430

TOYOTA HIGHLANDER 2005 XU20 / 1.G Owners Manual ’05 HIGHLANDER_U (L/O 0409)
143
2005 HIGHLANDER from Nov. ’04 Prod. (OM48570U)
CHECKING SERVICE REMINDER
INDICATORS (except the low fuel level
warning light and low windshield
washer fluid level w

Page 167 of 430

TOYOTA HIGHLANDER 2005 XU20 / 1.G Owners Manual ’05 HIGHLANDER_U (L/O 0409)
157
2005 HIGHLANDER from Nov. ’04 Prod. (OM48570U)
TRACTION CONTROL OFF MODE
If your wheels get stuck in an ditch
when you are driving on a severe off
road and sand, tu

Page 168 of 430

TOYOTA HIGHLANDER 2005 XU20 / 1.G Owners Manual ’05 HIGHLANDER_U (L/O 0409)
158
2005 HIGHLANDER from Nov. ’04 Prod. (OM48570U)
In the following cases, contact your Toyota
dealer:
The warning light does not  come on
after the ignition key is tu

Page 169 of 430

TOYOTA HIGHLANDER 2005 XU20 / 1.G Owners Manual ’05 HIGHLANDER_U (L/O 0409)
159
2005 HIGHLANDER from Nov. ’04 Prod. (OM48570U)
When the traction control system is oper-
ating, the following conditions occur:
The system controls the spinning of

Page 171 of 430

TOYOTA HIGHLANDER 2005 XU20 / 1.G Owners Manual ’05 HIGHLANDER_U (L/O 0409)
161
2005 HIGHLANDER from Nov. ’04 Prod. (OM48570U)
“VSC” warning light
This light warns that there is a problem
somewhere in the vehicle stability control
system or

Page 172 of 430

TOYOTA HIGHLANDER 2005 XU20 / 1.G Owners Manual ’05 HIGHLANDER_U (L/O 0409)
162
2005 HIGHLANDER from Nov. ’04 Prod. (OM48570U)
LOW TIRE PRESSURE WARNING LIGHT
This light comes on when the ignition key
is turned to the “ON” position. It goes

Page 173 of 430

TOYOTA HIGHLANDER 2005 XU20 / 1.G Owners Manual ’05 HIGHLANDER_U (L/O 0409)
163
2005 HIGHLANDER from Nov. ’04 Prod. (OM48570U)
The loading is over  the limit or imbal-
anced.
Initialization was not performed correct-
ly after replacing or rot