2005 SUZUKI SWIFT ECU

[x] Cancel search: ECU

Page 274 of 1496

SUZUKI SWIFT 2005 2.G Service Workshop Manual Downloaded from www.Manualslib.com manuals search engine 1C-2 Engine Electrical Devices: 
MAP Sensor InspectionS7RS0B1306002
1) Remove air cleaner assembly.
2) Disconnect connector from MAP sensor.
3)

Page 277 of 1496

SUZUKI SWIFT 2005 2.G Service Workshop Manual Downloaded from www.Manualslib.com manuals search engine Engine Electrical Devices:  1C-5
Electric Throttle Body System CalibrationS7RS0B1306004
NOTE
If working the service described under the 
“Pre

Page 279 of 1496

SUZUKI SWIFT 2005 2.G Service Workshop Manual Downloaded from www.Manualslib.com manuals search engine Engine Electrical Devices:  1C-7
Installation
Reverse removal procedure noting the following.
• Clean mating surfaces of ECT sensor and therm

Page 280 of 1496

SUZUKI SWIFT 2005 2.G Service Workshop Manual Downloaded from www.Manualslib.com manuals search engine 1C-8 Engine Electrical Devices: 
Installation
Reverse removal procedure noting the following.
• Tighten heated oxygen sensor to specified tor

Page 281 of 1496

SUZUKI SWIFT 2005 2.G Service Workshop Manual Downloaded from www.Manualslib.com manuals search engine Engine Electrical Devices:  1C-9
CKP Sensor Removal and InstallationS7RS0B1306014
Removal1) Disconnect negative (–) cable at battery.
2) Remo

Page 283 of 1496

SUZUKI SWIFT 2005 2.G Service Workshop Manual Downloaded from www.Manualslib.com manuals search engine Engine Electrical Devices:  1C-11
MAF and IAT Sensor On-Vehicle InspectionS7RS0B1306018
NOTE
Before performed this inspection, be sure to 
read

Page 288 of 1496

SUZUKI SWIFT 2005 2.G Service Workshop Manual Downloaded from www.Manualslib.com manuals search engine 1D-3 Engine Mechanical: 
Oil Control Valve
The oil control valve switches and adjusts the hydraulic 
pressure applied to the cam timing sprocke

Page 296 of 1496

SUZUKI SWIFT 2005 2.G Service Workshop Manual Downloaded from www.Manualslib.com manuals search engine 1D-11 Engine Mechanical: 
2) Remove oil, old sealant, and dust from sealing surfaces on cylinder head and cover. After cleaning, 
apply sealant
Page:   < prev 1-8 9-16 17-24 25-32 33-40 41-48 49-56 ... 144 next >