2005 SUZUKI MARUTI display

Downloaded from www.Manualslib.com manuals search engine 4083K
BEFORE DRIVING
4-28
1. Speedometer
2. Display
3. "MODE" knob
4. Tachometer (if equipped)
83K-02-07183K-02-070
5. Fuel gauge
6. Warning and indicator lights
7. Clock knob
Instrument Cluster (For Petrol & Diesel)Petrol
Diesel
Service on or around air bag components
or wiring must be performed only by an
authorized MARUTI SUZUKI dealer.
Improper service could result in unintended
air bag deployment or could render the air
bag inoperative. Either of these two
conditions may result in severe injury.
To prevent damage or unintended inflation
of the air bag system, be sure the battery
is disconnected and the ignition switch has
been in the “LOCK” position for at least 90
seconds before performing any electrical
service work on your MARUTI SUZUKI. Do
not touch air bag system components or
wires. The wires are wrapped with yellow
tape or yellow tubing, and the couplers are
yellow for easy identification.
Scrapping a car that has an uninflated air
bag can be hazardous. Contact your
MARUTI SUZUKI authorized dealer, body
repair shop or scrap yard for help with dis-
posal.
According to accident statistics, children are
safer when properly restrained on rear seats
than front passenger’s seat. Whenever
possible, MARUTI SUZUKI recommends
that child restraint systems be installed on
the rear seat.

Downloaded from www.Manualslib.com manuals search engine 4683K
BEFORE DRIVING
4-34(1) Speedometer
(2) Display
(3) “MODE” knobSpeedometerThe speedometer indicates vehicle speed in
km/h.Odometer/Trip meterThe odometer/trip meter is shown when the
ignition switch is in the “ON” position. The
odometer records the total distance the
vehicle has been driven. The trip meter can
be used to measure the distance traveled
on short trips or between fuel stops.Speedometer/Odometer/Trip meter/
Meter Illumination Control
83K-02-090
EXAMPLE
NOTE:
When the ignition switch is turned to “ON”,
the display (2) shows the latest display that
the ignition switch was turned to “OFF” last
time.Keep track of your odometer reading
and check the maintenance schedule
regularly for required services.
Increased wear or damage to certain
parts can result from failure to
perform required services at the
proper mileage intervals.
NOTICE
83K-02-091
When the ignition switch is turned to “ON”,
the display shows three or six types of
indication; odometer (a), trip meter A (b),
trip meter B (c), and if your vehicle is
equipped with the information display,
instantaneous fuel consumption (d), average
fuel consumption (e), and driving range (f).
Push the “MODE” knob (3) quickly to switch
the indication among three or six. For the
indication (d), (e), or (f), refer to “Information
Display” in this section for details.
If you attempt to adjust the display
while driving, you could lose control
of the vehicle.
Do not attempt to adjust the display
while driving.
w ww w
w WARNING
83K-02-092

Downloaded from www.Manualslib.com manuals search engine 4783KTo reset the trip meter to zero, hold the
“MODE” knob (3) for more than 2 seconds
when the display (2) shows the indication
of trip meter (b) or (c).Meter illumination control
83K-02-092A
When the display shows the indication of
trip meter B (c) or driving range (f) if your
vehicle is equipped with the information
display and the headlights are on, you can
change the indication to illumination intensity
by pushing the “MODE” knob (3).
To change the meter illumination brightness,
push and hold in the “MODE” knob (3). The
indication will change as shown in the
illustration. The illumination gets dimmer
then returns to the brightest condition after
it reaches the dimmest.
NOTE:
When you reconnect the negative (-)
terminal to the battery, the brightness of the
instrument panel lights will be reinitialized.
Readjust the brightness according to your
preference.
83K-02-09383K-02-094
EXAMPLE EXAMPLE
Never drive with the engine speed
indicator in the red zone or severe
engine damage can result.
When downshifting to a lower gear,
make sure not to operate with exces-
sive revolution speeds of the engine.
Refer to “Downshifting maximum
allowable speeds” in the “OPERATING
YOUR VEHICLE” section.
CAUTION
Fuel GaugeEXAMPLEWhen the ignition switch is in the “ON”
position, this gauge gives an approximate
indication of the amount of fuel in the fuel
tank. “F” stands for full and “E” stands for
empty.
If the fuel meter indicator shows only one
segment to “E”, refill the tank as soon as
possible.
The mark (1) indicates that the fuel filler door
is located on the left side of the vehicle.
83K-02-095
Tachometer (if equipped)(Petrol)
(Diesel)
The tachometer indicates engine speed in
revolutions per minute.
BEFORE DRIVING
4-35

Downloaded from www.Manualslib.com manuals search engine 4883K
Information Display(1) Clock
(2) Instantaneous fuel consumption/Average
fuel consumption/ Driving range
(3) “MODE” knob
(4) Clock knob
83K-02-095A
NOTE:
If the last segment blinks, it means that
the fuel tank is almost empty.
The fuel meter indicator varies depend-
ing on road conditions (for example,
slope or curve) and driving conditions
because of fuel moving in the tank.Clock (1)The clock is shown when the ignition switch
is in the “ON” position.
To set the clock, follow the instructions
below.
Hold in the clock knob (4) for more than
2 seconds. Push the clock knob (4) to
advance the minute display while the
minute display is flashing. Release the
clock knob (4) for 5 seconds to set theminute display.
The hour display flash after the minute
display is set. Push the clock knob (4)
to advance the hour display. Release the
clock knob (4) for 5 seconds to set the
hour display.
If you attempt to adjust the display
while driving, you could lose control
of the vehicle.
Do not attempt to adjust the display
while driving.
w ww w
w WARNING
NOTE:
When you reconnect the negative (–)
terminal to the battery, the clock indication
will be reinitialized. Change the indication
again to your preference.Fuel Consumption and Driving
Range (2)This display can be changed to show
instantaneous fuel consumption, average
fuel consumption, or driving range. Also, the
display shows odometer and trip meter.
83K-02-091R
Every time you push the “MODE” knob (3),
the display will be changed among the
following six displays.
(a) Odometer
(b) Trip meter A
(c) Trip meter B
(d) Instantaneous fuel consumption
(if equipped)
(e) Average fuel consumption (if equipped)
(f) Driving range (if equipped)
BEFORE DRIVING
4-36

Downloaded from www.Manualslib.com manuals search engine 4983K
BEFORE DRIVING
4-37
w ww w
w WARNING
If you attempt to adjust the display
while driving, you could lose control
of the vehicle.
Do not attempt to adjust the display
while driving.NOTE:
Refer to “Speedometer/ Odometer/ Trip
meter” in this section for details of (a), (b),
and (c) indication.Instantaneous fuel consumption (d) (if
equipped)
If you selected instantaneous fuel
consumption the last time you drove the
vehicle, the display indicates “—.-” when the
ignition switch is turned to the “ON” position.
Unless the vehicle is moving, the display will
indicate “—.-”.NOTE:
Depending on the vehicle’s specification,
the fuel consumption units of initial
setting are indicated as L/100km, km/L.
For “L/100km” or “km/L” setting, the
indicated maximum value of
instantaneous fuel consumption is 30. No
more than 30 will be indicated on the
display even if the actual instantaneous
fuel consumption is higher.
Average fuel consumption (e) (if
equipped)If you selected average fuel consumption
the last time you drove the vehicle, the
display shows the last value of average fuel
consumption when the ignition switch is
turned to the “ON” position. Unless you
reset the value of average fuel consumption,
the display indicates the value of average
fuel consumption which includes average
fuel consumption during previous driving.
To reset the value of average fuel
consumption, hold in the “MODE” knob (5)
for a while when the display shows the
average fuel consumption. The display will
indicate “—.-” and then will show a new
average fuel consumption value after driving
for a short time.NOTE:
When you reset the indication or reconnect
the negative (–) terminal to the battery, the
value of average fuel consumption will be
shown after driving for a while.Driving range (f) (if equipped)If you selected driving range the last time
you drove the vehicle, the display shows “—
-” for a few seconds and then shows the
current driving range when the ignition
switch is turned to the “ON” position.
The driving range shown in the display is
NOTE:
If you refuel when the ignition switch is
in the “ON” position, the driving range
may not indicate the correct value.
When you reconnect the negative (–)
terminal to the battery, the value of
driving range will be shown after driving
for a while.
For a new vehicle with low mileage, the
driving range may not be shown
promptly in the display when beginning
to drive. The driving range will be shown
after a while.
NOTE:
The values of fuel consumption and driving
range shown in the display are affected by
conditions such as the following;the approximate distance you can drive until
the fuel gauge indicates “E” based current
driving conditions.
When the low fuel warning light comes on,
the display “—-” will appear.
If the low fuel warning light comes on, fill
the fuel tank immediately regardless of the
value of driving range shown in the display.
As the driving range after refueling is
calculated based on the last driving
condition,the value is different each time you
refuel.

Downloaded from www.Manualslib.com manuals search engine 5083K
road condition
surrounding traffic condition
driving condition
vehicle condition
when the malfunction indicator light
comes on or blinksUnit indication of fuel consumption
(For “L/100km” or “km/L” setting)You can change the unit indication of fuel
consumption when selecting instantaneous
fuel consumption in the display.
You should operate the display before the
vehicle moves.
To change the unit indication in the display,
hold in the “MODE” knob (3) for more than
2 seconds.
Every time you hold in the “MODE” knob
(3) for more than 2 seconds, the unit
indication in the display will be changed
between the following two displays.
83K-04-095B
NOTE:
When you reconnect the negative (–)
terminal to the battery, the information
display will be reinitialized. Readjust the
display. If you select driving range, the
display will be shown after driving for a
while.
83K-02-096
w ww w
w WARNING
To avoid possible injury, do not oper-
ate controls by reaching through the
steering wheel.Lighting Control LeverLighting Operation
EXAMPLE
83K-02-097
To turn the lights on or off, twist the knob
on the end of the lever. There are three
positions:
BEFORE DRIVING
4-38