2005 SUBARU OUTBACK ECU

11 - 6
Maintenance and service
3. Release the secondary hood release located under
the front grille by moving the lever toward the left.
4. Lift up the hood, release the hood prop from its re-
tainer and put the end of the hood prop into the slot in
the hood.
To close the hood:
1. Lift the hood slightly and remove the hood prop
from the slot in the hood and return the prop to its re-
tainer.
2. Lower the hood until it approaches about 12 in (30
cm) from the closed position and let it drop.
3. After closing the hood, be sure the hood is securely
locked.
If this does not close the hood, release it from a slightly
higher position. Do not push the hood forcibly to close
UBB503BAUBB504BA

11 - 1 4
Maintenance and service
2. Park the vehicle on a level surface and stop the en-
gine.
3. Remove the oil filler cap.
2.5-liter turbo models Other models
4. Drain out the engine oil by removing the drain plug
while the engine is still warm. The used oil should be
drained into an appropriate container and disposed of
properly.
Be careful not to burn yourself with hot engine
oil.
5. Wipe the seating surface of the drain plug with a
clean cloth and tighten it securely with a new sealing
UBB200BA
UBB200CA

11 -2 1
Maintenance and service
– CONTINUED –
loosen the drain plug.
3. Loosen the radiator cap to drain the coolant from
the radiator. Then drain the coolant from the reserve
tank. Tighten the drain plug securely.
Never attempt to remove the radiator cap until
the engine has been shut off and has cooled
down completely. Since the coolant is under
pressure, you may suffer serious burns from a
spray of boiling hot coolant when the cap is re-
moved.
4. Install the under cover. Non-turbo models
A) Fill up to here
A
UBB510BB

11 - 6 6
Maintenance and service
4. Align the claws of the plastic support with the
grooves in the blade rubber assembly, then slide the
blade rubber assembly into place.
Securely retain both ends of the rubber with the stop-
pers on the plastic support ends. If the rubber is not re-
tained properly, the wiper may scratch the rear win-
dow glass.
5. Install the wiper blade assembly to the wiper arm.
Make sure that it locks in place.
6. Hold the wiper arm by hand and slowly lower it in position.
USB586CAUSB584BA

11 -7 7
Maintenance and service
– CONTINUED –
A) Rear turn signal light
B) Backup light
C) Brake/tail and rear side marker light
2. Remove the bulb holder from the rear combination
light assembly by turning it counterclockwise.
3. Remove the bulb from the socket by pushing it and
turning counterclockwise. Install a new bulb.
4. Set the bulb holder into the rear combination light
assembly and turn it clockwise until it locks.
5. Securely lock the cover against the trunk trim by
using the screwdriver to turn the top knob clockwise. !
Station wagon
1. Using a Phillips screwdriver, remove the upper andlower screws.
A
B
CUBB206BB
UBB533BA