2005 SUBARU OUTBACK lock

2-10
Keys and doors
Power door locking switches
Driver’s switch
A) Lock
B) Unlock Front passenger’s switch
A) Lock
B) Unlock
All doors and the rear gate (Station wagon) can be
locked and unlocked by the power door locking switch-
es located at the driver’s side and the front passen-
ger’s side doors.
To lock all doors (including the rear gate of a Station
wagon), push the switch to the front (“LOCK”) position.
To unlock all doors (including the rear gate of a Station
wagon), pull the switch to the rear position.
When you close the doors after you set the door locks,
LOCK
A
B
UB2537BB
A
B
UB2206BB

2-11
Keys and doors
– CONTINUED –
the doors remain locked.
NOTE
Make sure that you do not leave the key inside the
vehicle before locking the doors from the outside
using power door locking switches. !Key lock-in prevention function
This function prevents the doors from being locked
with the key still in the ignition switch. ! Behavior with key lock-in prevention function
operative
With the driver’s door open, the doors are automatical-
ly kept unlocked even if the door locking switch is
pushed to the front (“LOCK”) position. ! Behavior with key lock-in prevention function
non-operative
" If the lock lever is turned to the rear (“LOCK”) posi-
tion with the driver’s door open and the driver’s door is
then closed with the lock lever in that position, the driv-
er’s door is locked. " If the spare key is used to lock the driver’s door from
the outside of the vehicle, the door is locked.
This function’s operative/non-operative setting can be
changed. The setting can be changed by a SUBARU dealer.
Contact a SUBARU dealer for details.
NOTE
When leaving the vehicle, make sure you are hold-
ing the key before locking the doors.

2-12
Keys and doors
Remote keyless entry system (if
equipped)
"
Do not expose the transmitter to severe
shocks, such as those experienced as a result
of dropping or throwing. " Do not take the transmitter apart except when
replacing the battery. " Do not get the transmitter wet. If it gets wet,
wipe it dry with a cloth immediately.
This device complies with Part 15 of the FCC
Rules and with RSS-210 of Industry Canada. Oper-
ation is subject to the following two conditions: (1)
This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved
by the party responsible for compliance could
void the user’s authority to operate the equipment.
Two transmitters are provided for your vehicle.
The keyless entry system has the following functions. "
Locking and unlocking the doors (and rear gate on
the Station wagon) without a key " Locking and unlocking the doors (and trunk lid on
the Sedan) without key" Unlocking the rear gate on the Station wagon with-
out key " Unlocking the trunk lid on the Sedan without key
" Sounding a panic alarm
" Arming and disarming the security system (if your
vehicle is equipped with an optional security system).
See the next section “Alarm system” for detailed infor-mation.
The operable distance of the keyless entry system is
approximately 30 feet (10 meters). However, this dis-
tance will vary depending on environmental condi- tions. The system’s operable distance will be shorter
in areas near a facility or electronic equipment emitting
strong radio waves such as a power plant, broadcast
station, TV tower, or remote controller of home elec-
tronic appliances.
The keyless entry system does not operate when the
key is inserted in the ignition switch.

2-13
Keys and doors
– CONTINUED –
: Trunk lid/rear gate unlock button
: Unlock/disarm button
: Lock/arm button
A: Panic button
a: Front
b: Back !
Locking the doors
Press the “ ” button to lock all doors and rear gate
(Station wagon). An electronic chirp will sound once
and the turn signal lights will flash once.
If any of the doors (or the rear gate/trunk lid) is not fully
closed, an electronic chirp will sound five times and
the turn signal lights will flash five times to alert you
that the doors (or the rear gate/trunk lid) are not prop-
erly closed. When you close the door, it will automati-
cally lock and then an electronic chirp will sound once
and the turn signal lights will flash once.
ab A
UB2207BB
UB2211CA

2-14
Keys and doors
!
Unlocking the doors
Press the “ ” button to unlock the driver’s door. An
electronic chirp will sound twice and the turn signal
lights will flash twice. To unlock all doors and rear gate
(Station wagon), briefly press the “ ” button a sec-
ond time within 5 seconds.
NOTE
If the interval between the first and second press-
es of the “ ” button (for unlocking of all of the
doors and the rear gate) is extremely short, the
system may not respond. !
Unlocking the trunk lid/rear gate
! Sedan
The trunk lid unlocks when the “ ” button is
pressed continuously for at least 2 seconds. An elec-
tronic chirp will sound twice and the turn signal lights
will flash twice. ! Station wagon
Pressing the “ ” button opens the rear gate.
An electronic chirp will sound twice and the turn signal
lights will flash twice.
UB2211DAUB2211EA

2-15
Keys and doors
– CONTINUED –
!Illuminated entry
The interior (dome) light will illuminate when the
“ ” button is pressed. This light stays illuminated
for approximately 30 seconds if any of the doors or the
rear gate (Station wagon) is not opened.
If the “ ” button is pressed before 30 seconds have
elapsed, this light will go out. The interior light must be
set to the middle position in order for this function to
operate.
A SUBARU dealer can change the illumination period
setting of the interior light in accordance with your
preference. Contact the nearest SUBARU dealer for
details. ! Vehicle finder function
Use this function to find your vehicle parked among
many vehicles in a large parking lot. Provided you are
within 30 feet (10 meters) of the vehicle, pressing the
“ ” button three times in a five-second period will
cause your vehicle’s horn to sound once and its turn
signal lights to flash three times.
NOTE
If the interval between presses is too short when
you press the “ ” button three times, the sys-
tem may not respond to the signals from the re-mote transmitter. !
Sounding a panic alarm
A “PANIC” button is located on the back of the trans-mitter.
To activate the alarm, press the “PANIC” button once.
The horn will sound and the turn signal lights will flash.
To deactivate the panic alarm, press the “ ”,
“ ”, “ ” or the “PANIC” button. Unless a but-
ton on the remote is pressed, the alarm will be deacti-
vated after approximately 30 seconds. ! Selecting audible signal operation
Using an electronic chirp, the system will give you an
audible signal when the doors lock and unlock. If de-
UB2222BA

2-16
Keys and doors
sired, you may turn the audible signal off.
To turn the audible signal off, unlock the doors by
pushing “ ” button and then simultaneously de-
press “ ” and “ ” buttons for more than two sec-
onds. An electronic chirp will sound twice and the turn
signal lights will flash twice to inform you that the audi-
ble signal has been turned off.
To turn the audible signal on, unlock the doors by
pushing “ ” button and then simultaneously de-
press “ ” and “ ” buttons for more than two sec-
onds. An electronic chirp will sound once and the turn
signal lights will flash once to inform you that the audi-
ble signal has been turned on.
You may have the above settings done by your SUB-
ARU dealer. !
Replacing the battery
Do not let dust, oil or water get on or in the
transmitter when replacing the battery.
When the transmitter battery begins to get weak,
transmitter range will begin to decrease and the LED
will not illuminate. Replace the battery as soon as pos- sible.
To replace the battery:
1. Open the transmitter case using a flat-head screw-
driver.
UB2208BA

2-19
Keys and doors
– CONTINUED –
3. Perform the following steps within 45 seconds.
1) Open and close the driver’s door once. A) LOCK
B) ON
2) Insert the key into the ignition switch, then turn it
from the “LOCK” position to the “ON” position 10
times within 15 seconds.
NOTE " When you complete step 2), an electronic tone
will sound once, a buzzer will continue to sound
and the interior light will continue to flash until the
transmitter codes are completely registered." If you do not perform steps 1) and 2) within 45
seconds, an error will occur. Neither an electronic
tone nor the buzzer will sound, and the interior
HS2019CA
B
A
UB2215CB