2005 SUBARU OUTBACK door lock

2-27
Keys and doors
– CONTINUED –
!Valet mode
When you choose the valet mode, the alarm system
does not operate. In valet mode, the remote transmit-
ter is used only for locking and unlocking the doors
and rear gate (Station wagon) and panic activation.
To enter the valet mode, change the setting of your ve-
hicle’s alarm system for deactivation mode. (Refer to
“Activating and deactivating the alarm system” in this
section.) The security indicator light will continue to
flash once every three seconds indicating that the sys-
tem is in the valet mode (only vehicle with an immobi- lizer).
To exit valet mode, change the setting of your vehi-
cle’s alarm system for activation mode. (Refer to “Ac-
tivating and deactivating the alarm system” in this sec- tion.)
NOTE
If your vehicle is not equipped with an immobiliz-
er, the security indicator light does not flash dur-
ing the valet mode. ! Passive arming
When passive arming mode has been programmed by
the dealer, arming of the system is automatically ac-
complished without using the remote transmitter. Note that in this mode, DOORS MUST BE MANUALLYLOCKED. !
To enter the passive mode
If you wish to program the passive arming mode, have
it done by your SUBARU dealer. ! Arming the system
In passive mode, the system will automatically
activate the alarm but WILL NOT automatically
lock the doors. In order to lock the doors you
must either lock them as indicated in step 4 be-
low or with the key once they have been closed.
Failure to lock the doors manually will result in
a higher security risk.
1. Turn the ignition switch to the “ON” position.

2-28
Keys and doors
A) ON
B) LOCK
2. Turn the ignition switch from “ON” to “LOCK” posi-
tion and remove the key from the ignition switch.
3. Open the doors and get out of the vehicle. 4. Before closing the doors, lock all doors with the in-
side door lock levers.
5. Close the doors. The system will automatically arm
after one minute.
In the passive mode, the system can also be armed
with the remote transmitter or with the power door
locking switches. If the remote transmitter or power
door lock switch is used to lock the vehicle, arming will
take place immediately regardless of whether or not
the passive mode has been selected. !
Disarming the system
To disarm the system, briefly press the “ ” button
on the transmitter.
A
B
UB2215BBUB2535BA

2-30
Keys and doors
Child safety locks
Always use the child safety lock whenever a
child rides in the rear seat. Serious injury could
result if a child accidentally opened the door
and fell out.
Each rear door has a child safety lock that prevents
the doors from being opened even if the inside door
handle is pulled. When the child safety lock lever is in the lock position,
the door cannot be opened from inside regardless of
the position of the inner door handle lock lever. The
door can only be opened from the outside.
UB2501BA

2-31
Keys and doors
– CONTINUED –
Windows !Power windows
To avoid serious personal injury caused by en-
trapment, you must do the following."When operating the power windows, be ex-
tremely careful to prevent anyone’s fingers,
arms, neck or head from being caught in the
window. " Always lock the passengers’ windows using
the lock switch when children are riding in the
vehicle. " Before leaving the vehicle, always remove
the key from the ignition switch for safety and
never allow an unattended child to remain in
the vehicle. Failure to follow this procedure
could result in injury to a child operating the
power window.
The power windows operate only when the ignition
switch is in the “ON” position. !
Driver’s side switches
A) Lock switch
B) For driver’s window
C) For front passenger’s window
D) For rear left passenger’s window
E) For rear right passenger’s window
All door windows can be controlled by the power win-
dow switch cluster at the driver side door.
A
C
E
D B
UB2538BB

2-34
Keys and doors
"
Locking the passengers’ windows
To lock the passengers’ windows, push the lock
switch. When the lock switch is in the “LOCK” position,
the passengers’ windows cannot be opened or closed. !
Passengers’ side switches
Front passenger’s window switch
A) Open
B) Close
To open the window, push the switch down and hold it
until the window reaches the desired position.
UB2540BA
B
A
UB2206CB

2-35
Keys and doors
– CONTINUED –
Rear passengers’ window switches
A) Open
B) Close
To close the window, pull the switch up and hold it until
the window reaches the desired position.
When the lock switch on the power window switch
cluster, located on the driver’s side door, is in the
“LOCK” position, the passengers’ windows cannot be
operated with the passengers’ switches.
Trunk lid (Sedan)
" To prevent dangerous exhaust gas from en-
tering the vehicle, always keep the trunk lid
closed while driving. " Help prevent young children from locking
themselves in the trunk. When leaving the vehi-
cle, either close all windows and lock all doors
or cancel the inside trunk lid release. Also make
certain that the trunk is closed. On hot or sunny
days, the temperature in the trunk could quickly
become high enough to cause death or serious
heat-related injuries including brain damage,
particularly for small children.
! To open and close the trunk lid from
outside
The trunk lid can be opened using the remote keyless entry system. Refer to “Remote keyless entry system
(if equipped)” section in this chapter.
To close the trunk lid, lightly press the trunk lid down
until the latch engages.
A B
UB2216BB

2-36
Keys and doors
NOTE
Do not leave your valuables in the trunk when you
leave your vehicle. !
To open the trunk lid from inside
Pull the trunk lid release lever upward. !
To lock and unlock the trunk lid re- lease lever
When you entrust your vehicle key to another person,
you can lock the trunk lid release lever to prevent lug-
gage in the trunk from being stolen. To lock the trunk
lid release lever, insert the master key or sub key into
the key cylinder at the rear of the release lever and
turn it counterclockwise. To unlock the trunk lid re-
lease lever, turn the key clockwise.
LOCK
UB2225BA
UB2226BA

2-37
Keys and doors
– CONTINUED –
!Internal trunk lid release handle
The internal trunk lid release handle is a device de-
signed to open the trunk lid from inside the trunk. In the
event children or adults become locked inside the
trunk, the handle allows them to open the lid. The han-
dle is located on the inside of the trunk lid.
To open the trunk lid from inside the trunk, press the
yellow handle downward as indicated by the arrow on the handle. This operation unlocks the trunk lid. Then,
push up the lid.
The handle is made of material that remains lumines-
cent for approximately an hour in the dark trunk space
after it is exposed to ambient light even for a short time.
Never allow any child to get in the trunk and
play with the release handle. If the driver starts
the vehicle without knowing that a child is in-
side the trunk and the child opens the lid using
the release handle, the child could fall out and
be killed or seriously injured.
" Do not close the lid while gripping the release
handle. The handle may be damaged. " Do not use the handle as a hook to fasten
straps or ropes to secure your cargo in the
trunk. Such use may result in damage of the
handle." Load the trunk so that cargo can not strike
the release handle. If the cargo hits the handle
while the vehicle is being driven, the handle
may be pushed down and the trunk lid may
open. That may cause cargo to fall out of the
trunk, which could create a traffic safety haz-
ard.
UB2217BA