2005 SUBARU OUTBACK light

11 - 5 0
Maintenance and service
following table shows the required tire pressures that
correspond to various outside temperatures when the
temperature in the garage is 60
°F (15.6 °C).
Standard tire pressures:
Front: 32 psi (220 kPa, 2.2 kgf/cm 2
)
Rear: 30 psi (210 kPa, 2.1 kgf/cm 2
)
Garage temperature: 60 °F (15.6 °C)
If the low tire pressure warning light comes on when
you drive the vehicle in cold outside air after adjusting
the tire pressures in a warm garage, re-adjust the tire
pressures using the method described above. Then,
increase the vehicle speed to at least 20 mph (32 km/
h) and check to see that the low tire pressure warning
light goes off a few minutes later. If the low tire pres-
sure warning light does not go off, the tire pressure
monitoring system may not be functioning normally. In this event, go to a SUBARU dealer to have the system
inspected as soon as possible.
While the vehicle is driven, friction between tires and
the road surface causes the tires to warm up. After il-
lumination of the low tire pressure warning light, any
increase in the tire pressures caused by an increase in
the outside air temperature or by an increase in the
temperature in the tires can cause the low tire pres-
sure warning light to go off.
System resetting is necessary when the wheels are
changed (for example, a switch to snow tires) and new
TPMS valves are installed on the newly fitted wheels.
Have this work performed by a SUBARU dealer fol-
lowing wheel replacement.
It may not be possible to install TPMS valves on cer-
tain wheels that are on the market. Therefore, if you
change the wheels (for example, a switch to snow
tires), use wheels that have the same part number as
the standard-equipment wheels. Without four opera-
tional TPMS valve/sensors on the wheels, the TPMS
will not fully function and the warning light in the instru-
ment panel will flash.
When a tire is replaced, adjustments are necessary to
ensure continued normal operation of the tire pressure
monitoring system. As with wheel replacement, there-
Outside temperature Adjusted pressure
[psi (kPa, kgf/cm2
)]
front rear
30 °F (–1 °C) 35 (240, 2.4) 33 (230, 2.3)
10 °F (–12 °C) 37 (255, 2.55) 35 (245, 2.45)
–10 °F (–23 °C) 39 (270, 2.7) 37 (260, 2.6)

11 -5 1
Maintenance and service
– CONTINUED –
fore, you should have the work performed by a SUBA-
RU dealer.
If the low tire pressure warning light does not
come on briefly after the ignition switch is
turned ON or the light is flashing, you should
have your Tire Pressure Monitoring System
checked at a SUBARU dealer as soon as possi-
ble.
If this light comes on while driving, never brake
suddenly and keep driving straight ahead while
gradually reducing speed. Then slowly pull off
the road to a safe place. Otherwise an accident
involving serious vehicle damage and serious
personal injury could occur.
If this light still comes on while driving after ad-
justing the tire pressure, a tire may have signif-
icant damage and a fast leak that causes the
tire to lose air rapidly. If you have a flat tire, re-
place it with a spare tire as soon as possible.
When a spare tire is mounted or a wheel rim is
replaced without the original pressure sensor/
transmitter being transferred, the low tire pres-
sure warning light will flash. This indicates the
TPMS is unable to monitor all four road wheels.
Contact your SUBARU dealer as soon as possi- ble for tire and sensor replacement and/or sys-
tem resetting. If the light flashes, promptly con-
tact a SUBARU dealer to have the system in-
spected.
! Tire inspection
Check on a daily basis that the tires are free from se-
rious damage, nails, and stones. At the same time,
check the tires for abnormal wear.
Contact your SUBARU dealer immediately if you find
any problem.
NOTE " When the wheels and tires strike curbs or are
subjected to harsh treatment as when the vehicle
is driven on a rough surface, they can suffer dam-
age that cannot be seen with the naked eye. This
type of damage does not become evident until
time has passed. Try not to drive over curbs, pot-
holes or on other rough surfaces. If doing so is un-
avoidable, keep the vehicle’s speed down to a
walking pace or less, and approach the curbs as
squarely as possible. Also, make sure the tires are
not pressed against the curb when you park thevehicle. " If you feel unusual vibration while driving or find

11 - 5 4
Maintenance and service
"
Abnormally high tire pressure (tread worn in cen-
ter)
Ride comfort is poor. Also, the tire magnifies the ef-
fects of road-surface bumps and dips, possibly result-
ing in vehicle damage.
Driving at high speeds with excessively low tire
pressures can cause the tires to deform severe-
ly and to rapidly become hot. A sharp increase
in temperature could cause tread separation,
and destruction of the tires. The resulting loss
of vehicle control could lead to an accident.
! Wheel balance
Each wheel was correctly balanced when your vehicle
was new, but the wheels will become unbalanced as
the tires become worn during use. Wheel imbalance
causes the steering wheel to vibrate slightly at certain
vehicle speeds and detracts from the vehicle’s
straight-line stability. It can also cause steering and
suspension system problems and abnormal tire wear.
If you suspect that the wheels are not correctly bal-
anced, have them checked and adjusted by your SUB-
ARU dealer. Also have them adjusted after tire repairs
and after tire rotation.
NOTE
Loss of correct wheel alignment* causes the tires
to wear on one side and reduces the vehicle’s run-
ning stability. Contact your SUBARU dealer if you
notice abnormal tire wear.
*: The suspension system is designed to hold each wheel at
a certain alignment (relative to the other wheels and to the
road) for optimum straight-line stability and cornering perfor-
mance.
HSB054AA

11 -6 7
Maintenance and service
– CONTINUED –
Battery
"Before beginning work on or near any bat-
tery, be sure to extinguish all cigarettes, match-
es, and lighters. Never expose a battery to an
open flame or electric sparks. Batteries give off
a gas which is highly flammable and explosive." For safety, in case an explosion does occur,
wear eye protection or shield your eyes when
working near any battery. Never lean over a bat-tery. " Do not let battery fluid contact eyes, skin,
fabrics, or paint because battery fluid is a cor-
rosive acid. If battery fluid gets on your skin or
in your eyes, immediately flush the area with
water thoroughly. Seek medical help immedi-
ately if acid has entered the eyes.
If battery fluid is accidentally swallowed, imme-
diately drink a large amount of milk or water,
and seek medical attention immediately. " To lessen the risk of sparks, remove rings,
metal watchbands, and other metal jewelry.
Never allow metal tools to contact the positive
battery terminal and anything connected to it
WHILE you are at the same time in contact with any other metallic portion of the vehicle be-
cause a short circuit will result."
Keep everyone including children away from
the battery." Charge the battery in a well-ventilated area.
" Battery posts terminals and related accesso-
ries contain lead and lead compounds, chemi-
cals known to the State of California to case
cancer and reproductive harm. Wash hands af-
ter handling.
Never use more than 10 amperes when charg-
ing the battery because it will shorten battery
life.
It is unnecessary to periodically check the battery fluid
level or periodically refill with distilled water.

11 - 7 0
Maintenance and service
The fuse puller is stored in the main fuse box in the en-
gine compartment.
A) Good
B) Blown
If any lights, accessories or other electrical controls do
not operate, inspect the corresponding fuse. If a fuse
has blown, replace it.
1. Turn the ignition switch to the “LOCK” position and
turn off all electrical accessories.
2. Remove the cover.
(For behind the coin tray: open the coin tray and pull it
horizontally to remove it.)
3. Determine which fuse may be blown. The back side
of each fuse box cover and the “Fuses and circuits”
section in chapter 12 in this manual show the circuit for
UB9569BA
AB
HSB067BB

11 - 7 2
Maintenance and service
Installation of accessories
Always consult your SUBARU dealer before installing
fog lights or any other electrical equipment in your ve-
hicle. Such accessories may cause the electronic sys-
tem to malfunction if they are incorrectly installed or if
they are not suited for the vehicle.

11 - 7 4
Maintenance and service
!
Headlight
Halogen headlight bulbs become very hot while
in use. If you touch the bulb surface with bare
hands or greasy gloves, finger prints or grease
on the bulb surface develop into hot spots,
causing the bulb to break. If there are finger
prints or grease on the bulb surface, wipe them
away with a soft cloth moistened with alcohol.
NOTE "If headlight aiming is required, consult your
SUBARU dealer for proper adjustment of the head-
light aim.
Wattage Bulb No.
1) High beam headlight 12V-60W 9005 (HB3)
2) Low beam headlight 12V-55W H7
3) Front turn signal/Park- ing and front side
marker light 12V-27/8W 3157A
4) Map light 12V-8W –
5) Dome light 12V-8W –
6) Door step light 12V-3.5W –
7) Fog light Except OUTBACK 12V-55W H3
OUTBACK 12V-51W 9006 (HB4)
8) Trunk room light (Sedan) 12V-5W –
9) High mount stop light (Sedan) 12V-21W (W21W)
10) Rear turn signal light (Sedan) 12V-21W (W21W)
11) Backup light (Sedan) 12V-16W 921
12) Brake/tail and rear side marker light (Sedan) 12V-21/5W (W21/5W)
13) Cargo area light 12V-13W –
14) Brake/tail light (Station wagon) 12V-21/5W (W21/5W) 15) Rear side marker light
(Station wagon) 12V-5W 168
16) Rear turn signal light (Station wagon) 12V-21W (W21W)
17) Backup light (Station wagon) 12V-16W 921
18) Licence plate light 12V-5W 168 Wattage Bulb No.

11 -7 5
Maintenance and service
– CONTINUED –
"It may be difficult to replace the bulbs. Have
your SUBARU dealer replace the bulbs if neces-
sary. ! Low beam light bulbs
1. Remove the bulb cover, by turning it counterclock- wise. 2. Disconnect the electrical connector.
3. Remove the retainer spring.
4. Replace the bulb, then set the retainer spring se-curely.
5. Reconnect the electrical connector.
6. Install the bulb cover.
UBB529BA
UBB530BA