2005 SUBARU OUTBACK bulb

11 -7 5
Maintenance and service
– CONTINUED –
"It may be difficult to replace the bulbs. Have
your SUBARU dealer replace the bulbs if neces-
sary. ! Low beam light bulbs
1. Remove the bulb cover, by turning it counterclock- wise. 2. Disconnect the electrical connector.
3. Remove the retainer spring.
4. Replace the bulb, then set the retainer spring se-curely.
5. Reconnect the electrical connector.
6. Install the bulb cover.
UBB529BA
UBB530BA

11 - 7 6
Maintenance and service
!
High beam light bulbs
1. Disconnect the electrical connector from the bulb.
2. Remove the bulb from the headlight assembly by
turning it counterclockwise.
3. Replace the bulb with new one.
4. Reconnect the electrical connector. At this time,
use care not to touch the bulb surface.
5. To install the bulb to the headlight assembly, turn it
clockwise until it clicks. ! Parking light
It may be difficult to replace the bulbs. Have your SUB-
ARU dealer replace the bulbs if necessary. !
Front turn signal light
It may be difficult to replace the bulbs. Have your SUB-
ARU dealer replace the bulbs if necessary. ! Front fog light (if equipped)
It may be difficult to replace the bulbs. Have your SUB-
ARU dealer replace the bulbs if necessary. ! Rear combination lights
! Sedan
1. Push the knobs of the cover to open the cover.
UBB531BA
UBB210BA

11 -7 7
Maintenance and service
– CONTINUED –
A) Rear turn signal light
B) Backup light
C) Brake/tail and rear side marker light
2. Remove the bulb holder from the rear combination
light assembly by turning it counterclockwise.
3. Remove the bulb from the socket by pushing it and
turning counterclockwise. Install a new bulb.
4. Set the bulb holder into the rear combination light
assembly and turn it clockwise until it locks.
5. Securely lock the cover against the trunk trim by
using the screwdriver to turn the top knob clockwise. !
Station wagon
1. Using a Phillips screwdriver, remove the upper andlower screws.
A
B
CUBB206BB
UBB533BA

11 -7 9
Maintenance and service
– CONTINUED –
A) Brake/tail light
B) Rear turn signal light
C) Rear side marker light
4. Remove the bulb holder from the rear combination
light assembly by turning it counterclockwise.
5. Remove the bulb from the socket by pushing it and
turning counterclockwise. Install a new bulb.
6. Set the bulb holder into the rear combination light
assembly and turn it clockwise until it locks.
7. Close the cover and latch the lock.
8. Reinstall the rear combination light assembly and
its side cover. !
Backup light (Station wagon)
1. Use a flat-head screwdriver to remove the light cov-
er from the top of the left hand rear gate trim.
C A
B
UBB201BB
UBB536BA

11 - 8 0
Maintenance and service
2. Turn the bulb socket counterclockwise and remove it.
3. Pull the bulb out of the bulb socket and replace it
with a new one.
4. Install the bulb socket by turning it clockwise. Install
the light cover on the rear gate. !
License plate light
! Sedan
It may be difficult to replace the bulbs. Have your SUB-
ARU dealer replace the bulbs if necessary.
UBB590BAUBB538BA

11 -8 1
Maintenance and service
– CONTINUED –
!Station wagon0
1. Remove the mounting screws using a Phillips
screwdriver.
2. Remove the lens. 3. Pull the bulb out of the socket. Install a new bulb.
4. Reinstall the lens and cover.
5. Tighten the mounting screws.
UBB547BA
UBB548BA

11 - 8 2
Maintenance and service
!
Dome light
1. Remove the lens by prying the edge of the lens with
a flat-head screwdriver. 2. Turn the bulb until the flat surfaces at its ends are
aligned vertically. Pull the bulb straight downward to
remove it. Install a new bulb.
3. Reinstall the lens.
UBB541BA
UBB589BA

11 -8 3
Maintenance and service
– CONTINUED –
!Map light0
1. Remove the lens by prying the edge of the lens with
a flat-head screwdriver. 2. Turn the bulb until the flat surfaces at its ends are
aligned vertically. Pull the bulb straight downward to remove it.
3. Install a new bulb.
4. Reinstall the lens.
PASSENGER
UB9200BA
UBB580BA