2005 SUBARU LEGACY remote start

26
Function settings
A SUBARU dealer can change the settings of the functions shown below to meet your personal requirements. Con-
tact the nearest SUBARU dealer for details.Item Function Possible settings Default set- tingPage
Alarm system Alarm system Operation / Non-operation Operation 2-23 Monitoring start delay time (after
closure of doors) 0 second / 30 seconds 30 seconds 2-25
Impact sensor operation
(only vehicles with shock sensors
(dealer option)) Operation / Non-operation Non-opera-
tion2-29
Passive arming Operation / Non-operation Non-opera- tion2-27
Remote keyless entry sys-tem Hazard warning flasher Operation / Non-operation Operation 2-12
Audible signal Operation / Non-operation Operation 2-15
Key lock-in prevention Key lock-in prevention Operation / Non-operation Operation 2-11
Rear window defogger Rear window defogger Operation for 15 min. / Continuous operationOperation for
15 min.3-57

2-22
Keys and doors
NOTE
If the code entered the second time is not identical to the code entered the first time, an error will oc-
cur. In this event, perform the procedure again be-
ginning with part 5. If an error occurs five times,
perform the procedure again starting with part 3.
10.If you wish to program another transmitter code
into the system (up to four transmitter codes can be
programmed into the system), perform the procedure
beginning with part 4. When you have finished pro-
gramming all of the necessary transmitter codes into
the system, remove the key from the ignition switch.
11.Test every registered transmitter to confirm correct
operation. !
Deleting old transmitter codes
The control unit of the keyless entry system has four
memory locations to store transmitter codes, giving it
the ability to operate with up to four transmitters. When
you lose a transmitter, the lost transmitter’s code re-
mains in the memory. For security reasons, lost trans-
mitter codes should be deleted from the memory.
To delete old transmitter codes, program four trans-
mitter codes into the system. If you have only one cur-
rent transmitter, program it four times. If you have two
current transmitters, program each one twice. If you
have three current transmitters, program two of them once and the third one twice. This process will leave
only current transmitter codes in the system’s memo-ry.
NOTE
Make sure no one else is operating their keyless
entry system within range of your vehicle when
programming transmitters. If someone else were
to operate their remote transmitter while you are
programming your transmitters, it is possible that
their transmitter code will be programmed into
your system, allowing them unauthorized access
to your vehicle.

2-25
Keys and doors
– CONTINUED –
6. Briefly press the “ ” button (for less than two sec-
onds). All doors (and the rear gate on the Station wag-
on) will lock, an electronic chirp will sound one time,
the turn signal lights will flash one time and the indica-
tor light starts flashing slowly (approximately twice ev-
ery two seconds).
The system will then be armed for surveillance after a
standby time of approximately 30 seconds.
If any of the doors, (rear gate or trunk lid) is not fully
closed, an electronic chirp sounds five times, the turn
signal lights flash five times to alert you that the doors
(or the rear gate) are not properly closed. When you
close the door, the system will automatically arm and doors will automatically lock.
NOTE "
The system can be armed even if the engine
hood, the windows and/or moonroofs are opened.
Always make sure that they are fully closed before
arming the system. " The 30-second standby time can be eliminated if
you prefer. Have it performed by your SUBARU
dealer. " If your vehicle is a Sedan and you unlock the
trunk using the remote transmitter’s “ ” but-
ton with the alarm system armed, the system will
be temporarily placed in a standby state. The sys-
tem will go back to the surveillance state upon
locking the trunk. " The system is in the standby mode for a 30-sec-
ond period after locking the doors with the remote
transmitter. The security indicator light will flash
at short intervals during this period. " If any of the following actions is done during the
standby period, the system will not switch to the
surveillance state. "Doors are unlocked using the remote trans-
mitter." Any door (including the rear gate of a Station
wagon or the trunk of a Sedan) is opened. " Ignition switch is turned to the “ON” position.
UB7507KA

2-26
Keys and doors
"
The alarm system is triggered when the ignition
switch is turned to the “ON” position during sur-
veillance. However, this does not occur if the vehi-
cle is equipped with an immobilizer and the key
used for turning the ignition switch has been reg-
istered. " If your vehicle is not equipped with an immobi-
lizer, the engine does not start even when the igni- tion switch is turned to the “START” position once
the alarm system has been triggered. ! Disarming the system
Briefly press the “ ” button (for less than two sec-
onds) on the remote transmitter. The driver’s door will
unlock, an electronic chirp will sound twice, the turn
signal lights will flash twice and the indicator light will
go off.
To unlock all other doors and the rear gate (Station
wagon), briefly press the “ ” button a second time.
NOTE
If the interval between the first and second press-
es of the “ ” button (for unlocking of all of the
doors and the rear gate) is extremely short, the
system may not respond.
Or the system can be disarmed by the following method, too. "
Insert the key in the door lock of the driver’s
door and turn it to the unlock position." Cycle the ignition switch from the “LOCK” to the
“ON” position three times within 5 seconds (only
vehicle without immobilizer). ! Emergency disarming
If you cannot disarm the system using the transmitter
(i.e. the transmitter is lost, broken or the transmitter
battery is too weak), you can disarm the system with-
out using the transmitter.
Vehicle with immobilizer
The system can be disarmed if you turn the ignition
switch from the “LOCK” to the “ON” position with a reg-
istered key.
Vehicle without immobilizer
1. Unlock the door with the key and then open the
door.
2. Insert the key into the ignition switch and cycle it
from the “LOCK” to the “ON” position three times with-
in 5 seconds .
All models
Insert the key in the door lock of the driver’s door and
turn it to the unlock position.

14-2
Index
A
ABS (Anti-lock Brake System) ........................... 7-38
Warning light ........................................ 3-28, 7-39
Accessories ..................................................... 11-72
Accessory power outlet ..................................... 6-14
Active head restraint ............................................ 1-8
Air cleaner element ......................................... 11-24
Air conditioner ..................................................... 4-9
Air filtration system ............................................ 4-19
Air flow selection ................................................. 4-2
Alarm system ..................................................... 2-23
All-wheel drive warning light (AT vehicles) ........ 3-31
Aluminum wheels ............................................ 11-57
Antenna system .................................................. 5-2
Anti-lock Brake System (ABS) ........................... 7-38
Arming the system ............................................. 2-24
Armrest .............................................................. 1-14
Ashtray .............................................................. 6-19
AT OIL TEMPerature warning light ................... 3-27
Audio control button .......................................... 5-56
Audio set ............................................................. 5-3
Auto-dimming mirror/compass .......................... 3-59
Automatic climate control system ...................... 4-10
Automatic transmission 4 speed ......................................................... 7-16
5 speed ......................................................... 7-25
Capacities ..................................................... 12-4 Fluid ............................................................ 11-33
Manual mode ....................................... 7-20, 7-30
Selector lever ...................................... 7-17, 7-26
Shift lock release ................................. 7-24, 7-35
Temperature warning light (AT OIL TEMP) .. 3-27
Automatic/Emergency Locking Retractor (A/ELR) .......................................................... 1-18
B
Battery ............................................................. 11-67 Jump starting ................................................ 9-17
Replacement (Remote keyless entry system) ...................................................... 2-16
Brake Booster ....................................................... 11-44
Fluid ............................................................ 11-42
Pad and lining ............................................. 11-47
Pedal .......................................................... 11-45
Brake pedal
Free play .................................................... 11-45
Reserve distance ........................................ 11-45
Brake system .................................................... 7-37
Warning light ................................................ 3-29
Braking .............................................................. 7-37
Breaking-in of new brake pads and linings ....................................................... 11-47
Tips ............................................................... 7-37