Page 388 of 507
11 - 7
Maintenance and service
– CONTINUED –
from the slot in the hood and return the prop to its re-
tainer.
2. Lower the hood until it approaches about 12 in (30
cm) from the closed position and let it drop.
After closing the hood, be sure the hood is securely
locked.
If this does not close the hood, release it from a slightly
higher position. Do not push the hood forcibly to close
it. It could deform the metal.
Always check that the hood is properly locked
before you start driving. If it is not, it might fly
open while the vehicle is moving and block
your view, which may cause an accident and
serious bodily injury.
Page 395 of 507
11 - 1 4
Maintenance and service
2.5-liter non-turbo models
4. Drain out the engine oil by removing the drain plug
while the engine is still warm. The used oil should be
drained into an appropriate container and disposed of
properly.
Be careful not to burn yourself with hot engine
oil.
5. Wipe the seating surface of the drain plug with a
clean cloth and tighten it securely with a new sealing washer after the oil has completely drained out.
6. Remove under cover (for Turbo).
Turbo models
UGB057DA
UGB083BA
Page 402 of 507
11 -2 1
Maintenance and service
– CONTINUED –
3. Loosen the radiator cap to drain the coolant from
the radiator. Then drain the coolant from the reserve
tank. Tighten the drain plug securely.
NOTE (Turbo model only)
The cap (without tabs) on top of the radiator does
not need to be removed. To add coolant, remove
the cap (with tabs) on the coolant tank on top of
the engine.
Never attempt to remove the radiator cap until
the engine has been shut off and has cooled
down completely. Since the coolant is under
pressure, you may suffer serious burns from a
spray of boiling hot coolant when the cap is re-
moved.
4. Install the under cover. Non-turbo models
1) Filler neck
2) Fill up to this level
1
2
UGB508BB
Page 443 of 507
11 - 6 2
Maintenance and service
4. Align the claws of the plastic support with the
grooves in the blade rubber assembly, then slide the
blade rubber assembly into place.
Securely retain both ends of the rubber with the stop-
pers on the plastic support ends. If the rubber is not re-
tained properly, the wiper may scratch the rear win-
dow glass.
5. Install the wiper blade assembly to the wiper arm.
Make sure that it locks in place.
6. Hold the wiper arm by hand and slowly lower it in position.
USB586CAUSB584BA
Page 460 of 507
11 -7 9
Maintenance and service
– CONTINUED –
1) Backup light
2) Rear turn signal light
3) Brake/tail light
4) Tail light
5) Brake light
2. Open the rear portion of the side trunk trim panel.
3. Remove the bulb holder from the rear combination
light assembly by turning it counterclockwise.
4. Remove the bulb from the socket by pushing it and
turning counterclockwise. Install a new bulb.
5. Set the bulb holder into the rear combination light
assembly and turn it clockwise until it locks.
6. Secure the rear trunk trim panel with the clips. T
Wagon
1. Using a Phillips screwdriver, remove the upper and
lower screws that secure the side cover of the rear
combination light assembly.
554
2
3
1
UGB539BB
UGB540BA
Page 503 of 507

14-8
Index
Trunk light ................................................... 11-82
REV indicator light and buzzer .......................... 3-13
Rocking the vehicle ........................................... 8-16
Roof rail and crossbar ....................................... 8-20 S Seat Fabric ........................................................... 10-6
Heater ............................................................. 1-7
Seatbelt .................................................................. 6
Maintenance ................................................. 1-27
Pretensioners ............................................... 1-28
Safety tips ..................................................... 1-13
Warning light and chime ...................... 1-15, 3-20
Seatbelts ........................................................... 1-13
Security system ................................................. 2-17
Selector lever .................................................... 7-23 Position indicator .......................................... 3-27
Shift lock release ............................................... 7-27
Side ventilators .................................................... 4-3
Snow tires ......................................................... 8-14
Sounding a panic alarm ..................................... 2-11
Spark plugs ..................................................... 11-28
Specifications .................................................... 12-2
Speedometer .............................................. 3-8, 3-15
SRS airbag (Supplemental Restraint System airbag) ....................................................... 6, 1-53 SRS airbag system monitors ............................. 1-73
SRS airbag system servicing ............................ 1-74
SRS airbag system warning light ...................... 3-20
SRS frontal airbag ............................................. 1-57
SRS side airbag ................................................ 1-65
Starting the engine .............................................. 7-9
State emission testing (U.S. only) ....................... 7-7
Stopping the engine .......................................... 7-11
Storage compartments ........................................ 6-5
Sun shades ....................................................... 2-35
Sun visors ........................................................... 6-4
Supplemental Restraint System airbag
(SRS) ............................................................. 1-53
Synthetic leather upholstery .............................. 10-6 T
Tachometer ................................................ 3-9, 3-16
Temperature gauge .................................. 3-11, 3-18
Temporary spare tire ........................................... 9-3
Tilt steering wheel ............................................. 3-50 Tire
Chains .......................................................... 8-16
Inspection ................................................... 11-47
Pressures and wear ................................... 11-48
Replacement .............................................. 11-53
Rotation ...................................................... 11-52
Tires .................................................................. 12-5