RADIO NAVIGATION SYSTEM56
NAVIGATION
In the symbol and map display, an antenna
symbol will indicate that the system is tuned
into a current TMC station.
TMCThe system is tuned into a TMC
station.
Note
This does not affect the radio station that you
are actually listening to. If the station you select-
ed is no longer within reception range, the sys-
tem will automatically tune into the nearest TMC
station.
Switching dynamic navigation on/off
•Press the traffic congestion key ^^ ^^
^.
The traffic congestion menu will appear.
•Mark and confirm the “Route option” menu
field.
The route options menu will appear.
•Mark the “Dynamisation” menu field.
•Press the menu knob to switch dynamisa-
tion on or off.
The active setting is marked in blue and with a
triangle.
The traffic congestion status is indicated in the
symbol and map display:
TMCdynamic navigation off
TMCDdynamic navigation on, route ad-
justment possible
To store the selected options permanently,
mark and confirm the “Route option” menu
field.
Notes
Once you have activated route dynamisation,
the other route options are fixed and can no
longer be changed.
Dynamisation can also be switched on or off
during active route guidance.
If the dynamisation function is switched on, the
“GALA” function is switched off, page 15.
RADIO NAVIGATION SYSTEM64
NAVIGATION
Cancelling the electronic block
Enter the correct code to cancel the electronic
block.
Enter this information exactly as described in
the following:
•Switch the system on.
After you see the opening screen with the
·koda logo, you will see the menu for entering
the code with the message: “Please enter your
numerical code.”
•To enter the number code, use the menu
knob to mark and confirm each number on the
number bar one after the other.
The numbers selected will appear in the 4
number fields at the bottom.
•To confirm the code you have entered, use
the menu knob to mark the “OK” menu field
and press the menu knob.
Note
You can also confirm the code by pressing the
menu knob (for longer than 2 seconds).
Now you can once again operate the sys-
tem! Entering an incorrect code number
If you confirm an incorrect code number,
“SAFE” will flash in the number fields and the
display will then show the incorrect code just
entered. The following message will appear
below the number fields “1st code entered is
wrong!”.
Now you can repeat the entire process
once.
If the next code entered is also incorrect,
“SAFE” will appear in the number fields. The
following message will appear below the
number fields: “Unit locked!”. The system will
be blocked for approx. 1 hour, i.e. it will not
be possible to use it. After 1 hour has elapsed
- the system must remain switched on with
the key in the ignition - the message will
disappear from the display and the electronic
block can be removed as described above.
The cycle of two attempts, one hour blocked
will remain in effect.
Note
If you lose the equipment card with the code
number, please contact a ·koda Auto service
centre.
