2005 SAAB 9-2X coolant level

11 - 8Maintenance and service
18 February 2004
Engine compartment overview"2.5-liter non-turbo models
13 1112 10 86 5 4 3 2 1
7
9
UGB090BB
1) Air cleaner element (page 11-
22)
2) Manual transmission oil level
gauge (MT) (page 11-28) or Dif-
ferential gear oil level gauge
(AT) (page 11-32)
3) Clutch fluid reservoir (page 11-
38)
4) Automatic transmission fluid lev-
el gauge (page 11-30)
5) Brake fluid reservoir (page 11-
37)
6) Fuse box (page 11-62)
7) Battery (page 11-60)
8) Windshield washer tank (page
11-52)
9) Engine oil filler cap (page 11-10)
10) Engine coolant reservoir (page
11-17)
11) Engine oil level gauge (page 11-
10)
12) Radiator cap (page 11-17)
13) Power steering fluid reservoir
(page 11-35)
ProCarManuals.com

11 - 9
Maintenance and service
– CONTINUED –
11
18 February 2004
"2.0-liter turbo models
13 12 11 10 86 5 4 3 2 1
7
9
UGB091BB
1) Air cleaner element (page 11-
22)
2) Manual transmission oil level
gauge (MT) (page 11-28) or Dif-
ferential gear oil level gauge
(AT) (page 11-32)
3) Clutch fluid reservoir (page 11-
38)
4) Automatic transmission fluid lev-
el gauge (page 11-30)
5) Brake fluid reservoir (page 11-
37)
6) Fuse box (page 11-62)
7) Battery (page 11-60)
8) Windshield washer tank (page
11-52)
9) Engine oil filler cap (page 11-10)
10) Engine coolant reservoir (page
11-17)
11) Engine oil level gauge (page 11-
10)
12) Radiator cap (page 11-17)
13) Power steering fluid reservoir
(page 11-35)
ProCarManuals.com

11 -1 7
Maintenance and service
– CONTINUED –
11
26 December 2003
ed parts. The alcohol contained in the enginecoolant may damage the paint surface."Cooling fan, hose and connectionsYour vehicle employs an electric cooling fan which is
thermostatically controlled to operate when the engine
coolant reaches a specific temperature.
If the radiator cooling fan does not operate even when
the engine coolant temperature gauge exceeds the
normal operating range, the cooling fan circuit may be
defective. Check the fuse and replace it if necessary.
If the fuse is not blown, have the cooling system
checked by your Saab dealer.
If frequent addition of coolant is necessary, there may
be a leak in the engine cooling system. It is recom-
mended that the cooling system and connections be
checked for leaks, damage, or looseness.
"Engine coolant!Checking the coolant level1) “FULL” level mark
2) “LOW” level markCheck the coolant level at each fuel stop.
1. Check the coolant level on the outside of the reser-
voir while the engine is cool.
2. If the level is close to or lower than the “LOW” level
mark, add coolant up to the “FULL” level mark. If the
reserve tank is empty, remove the radiator cap and re-
fill as required.
FULL
LOW
UG9032DB
1
2
ProCarManuals.com

11 -1 9
Maintenance and service
– CONTINUED –
11
26 December 2003
NOTE (Turbo model only)The cap (without tabs) on top of the radiator does
not need to be removed. To add coolant, remove
the cap (with tabs) on the coolant tank on top of
the engine.Never attempt to remove the radiator cap until
the engine has been shut off and has cooled
down completely. Since the coolant is under
pressure, you may suffer serious burns from a
spray of boiling hot coolant when the cap is re-moved.
4. Install the under cover.
Non-turbo models
1) Filler neck
2) Fill up to this level
1
2
UGB122BB
ProCarManuals.com

11 - 2 0Maintenance and service
26 December 2003
Turbo models
1) Filler neck
2) Fill up to this level5. Slowly pour the coolant and fill up to just below the
filler neck, allowing enough room to add the genuine
cooling system conditioner in the radiator. Add genu-
ine cooling system conditioner until the coolant level
reaches the filler neck. Do not pour the coolant too
quickly, as this may lead to insufficient air bleeding
and trapped air in the system.
Guideline of coolant quantity (including coolant in reservoir
tank):
Non-turbo models:
MT. 7.4 US qt (7.0 liters, 6.2 Imp qt)
AT. 7.3 US qt (6.9 liters, 6.1 Imp qt)
Turbo models:
MT. 8.1 US qt (7.7 liters, 6.8 Imp qt)
AT. 8.0 US qt (7.6 liters, 6.7 Imp qt)
1) “FULL” level mark
2) “LOW” level mark
1
2
USB518BB
FULL
LOW
UG9032DB
1
2
ProCarManuals.com

11 -2 1
Maintenance and service
– CONTINUED –
11
26 December 2003
!Be careful not to spill engine coolant when
adding it. If coolant touches the exhaust pipe, it
may cause a bad smell, smoke, and/or a fire.
!Do not splash the engine coolant over paint-
ed parts. The alcohol contained in the enginecoolant may damage the paint surface.
6. Pour the coolant and fill to the reservoir tank’s
“FULL” level mark.1) Rubber gaskets
7. Put the radiator cap back on and tighten firmly. At
this time, make sure that the rubber gasket in the radi-
ator cap is correctly in place.
8. Start and run the engine for more than five minutes
at 2,000 to 3,000 rpm.
9. Stop the engine and wait until the coolant cools
down (122 to 140°F [50 to 60°C]). If there is any loss
of coolant, add coolant to the radiator’s filler neck and
to the reserve tank’s “FULL” level.
10.Put the radiator cap and reservoir cap back on and
tighten firmly.
1
HSB026BB
ProCarManuals.com

11 -5 3
Maintenance and service
– CONTINUED –
11
26 December 2003
Reservoir tankIf the fluid level is near the “Low” mark, add washer flu-
id until it reaches the “Full” mark on the reservoir tank
or the “Hi” mark on the level gauge.
Use windshield washer fluid. If windshield washer fluid
is unavailable use clean water.
In areas where water freezes in winter, use an anti-
freeze type windshield washer fluid.
Never use engine coolant as washer fluid be-cause it could cause paint damage.
UGB124BA
ProCarManuals.com