2005 MINI Hardtop 2 Door window

36
CONVERTIBLE TOPOpening and closing1To close2To open
To conserve battery power, if possible operate the convertible top only
while the engine is running.

Before closing the convertible top, remove
any foreign objects from the windshield
frame. They could prevent the convertible
top from closing.

The loading aid must be locked and the lug
-
gage compartment cover must be in its
lower position, refer to page
86.<
In ignition key position 1 or higher, with the
vehicle at a standstill:1. Observe the safety precautions
described above2. Press the corresponding button for con
-
vertible top operation in order to open
the folding roof. Pressing the button
again opens the convertible top.
The side windows open when the button for convertible top operation
is pressed.<
Once the opening procedure is finished and
the indicator lamp has gone out, press and
hold the button for more than two seconds
to close the windows again. During the
closing procedure, the folding roof is also
closed.
If the convertible top is left open for a longer period of time, it may be nec
-
essary to support the first automatic clos
-
ing procedure manually.

If the convertible top stops just before the
closing procedure is finished, press against
the front convertible top frame from out
-
side in order to support the closing proce
-
dure while the button is pressed until the
procedure continues automatically.<
Indicator lamps>The indicator lamp lights up during con
-
vertible top operation until the opening
or closing procedure is completely fin
-
ished>The indicator lamp flashes after the but
-
ton has been released:

The opening or closing procedure is not
yet completely finished.

The procedure can be continued in the
desired direction by pressing the appro
-
priate button>The indicator lamp flashes rapidly. The
convertible top cannot be operated:

The luggage compartment cover is not in
its lower position, refer to page
86, or the
loading aid is not correctly locked, refer
to page
86.

37
OVERVIEW REPAIRS OPERATIONCONTROLS DATA INDEX
CONVERTIBLE TOPInterruptionThe automatic movement is immediately
interrupted when the buttons for convert
-
ible top operation are released. The proce
-
dure can be continued in the desired direc
-
tion by pressing the appropriate buttons.Movement is also interrupted when there
is a mechanical blockage. In this case, in
order to operate the convertible top again:1. Turn off the ignition and then switch it
on again2. Press the button to continue the proce
-
dure in the desired direction.
If the convertible top can only be moved in one direction after several
consecutive attempts to operate it, the
convertible top system has overheated.
Allow the system to cool down for approx.
20
minutes while the ignition is switched
on.<
Before the closing procedure is fin
-
ished, do not close the side windows
with the power window buttons. Other
-
wise it is not ensured that the side win
-
dows will close properly against the rubber
seals of the convertible top.<
If the opening or closing procedure is inter
-
rupted by releasing the buttons, the con
-
vertible top stays in its current position for
several seconds before it slowly moves into
a more stable position. The procedure can
be continued by pressing the buttons.
Do not interrupt and restart the clos
-
ing procedure several times one after
another, or the fully automatic convertible
top mechanism could be damaged.<
Convenience operationFor convenience operation using the
remote control refer to page
26, for opera
-
tion via the door lock refer to page
27.
Manual closing in the event of an
electrical malfunction
Only close the convertible top manu
-
ally if it is absolutely necessary. Never
open it manually. Improper handling of the
convertible top can result in damage. Before closing 1. Open the tailgate2. Release the loading aid, refer to page
86
3. Remove the cover from the side panel on
the left-hand side4. Using the screwdriver from the onboard
tool kit, refer to page
120
, unscrew the
corresponding screw, arrow, in the direc
-
tion of the arrow by rotating it one and a
half turns.

60
WASHER/WIPER SYSTEMwindshield wipers are automatically con
-
trolled depending on the amount of mois
-
ture, including snow, on the windshield. To activate the rain sensor:From ignition key position
1:
Lever in position 1.

The wipers move over the windshield once.To deactivate the rain sensor:Put lever in position
0.
Switch the rain sensor off when pass
-
ing through an automatic car wash.
Failure to do so could result in damage
caused by undesired wiper activation. <
Normal wiper speedWhen the vehicle is stationary, the wipers
switch automatically to intermittent wip
-
ing.
You can have this function activated/deactivated.<
Fast wiper speedWhen the vehicle is stationary, the wipers
switch automatically to normal wiper
speed.
You can have this function activated/deactivated. <
Cleaning windshield and headlamps * The system sprays washer fluid against the
windshield. The wipers are automatically
activated for a brief period.When the vehicle lighting is on, the head
-
lamps are also cleaned at appropriate inter
-
vals.
Do not use the washers if there is any danger that the fluid will freeze on
the windshield. For this reason, use an anti
-
freeze agent, refer to page
108
.
Do not use the washers when the reservoir
is empty, since this could cause damage to
the washing pump. automatically when the ignition key is in
position
2.
Rear window wiper * 6 Intermittent operation:

Turn the cap to position
6.
The rear window wiper moves across the
window a number of times before
switching to interm ittent operationCleaning the rear window * 7 Intermittent operation:

Turn the cap to position
7 and hold in
place
8 In lever position
0:
Turn the cap to position
8 and hold in
place

75
OVERVIEW REPAIRS OPERATIONCONTROLS DATA INDEX
AIR CONDITIONING SYSTEM
*
1Air onto the windshield and onto the
side windows 2 Air for the upper body area
77
3 Air for the front and rear footwells
4 Temperature
76
5 Windshield heating
* 76
6 Air volume/Blower
76
7 Air conditioning
76
8 Air distribution
76
9 Recirculated air mode
76
10 Rear window defroster
76

76
AIR CONDITIONING SYSTEM
*
Air volume/Blower
You can select blower speeds from 1 to 4. Position
0: fan is
turned off. The button for recir
-
culated air mode fully blocks the
supply of air from outside.
The heating, ventilation and air condition
-
ing operate in position 1 or higher.Temperature
Turn to the right, red, to increase the temperature of the passen
-
ger compartment.Rapid heating: turn to the
extreme right. Then select a pleasant inte
-
rior temperature.Air distribution
Air distribution in upper body region
, upper body region
and footwell
, footwell
,
footwell and windows
, and
windows
.
All intermediate positions are possible,
refer to illustration and overview on
page
75.
Rear window defroster
Rear window defroster switched on:

Indicator lamp lights up.

As long as the indicator lamp is lit, the win
-
dow heater is operating.

The heater switches off automatically after
a short time.Windshield heating*
Windshield heating switched on:

Indicator lamp lights up.

As long as the indicator lamp is
lit, the window heater is operating.

The heater switches off automatically after
a short time.
Air conditioning
Air conditioning switched on: indicator lamp lights up.

The air is cooled and dehumidi
-
fied and, depending on the temperature
setting, rewarmed.

After the engine has started, the wind
-
shield can temporarily fog over. Condensa
-
tion on the windows is reduced when the
air conditioning is turned on.
When the air conditioning is on, con
-
densation is formed which then exits
under the vehicle. Traces of condensed
water on the ground are therefore nor
-
mal. Supply of outside air into the vehicle is blocked:

Indicator lamp lights up.

The air within the vehicle is recirculated.
If the windows fog up in the recircu
-
lated air mode, turn the recirculated
air mode off and if necessary increase the
air supply. The recirculated air mode should
not be constantly used over a longer period
of time, as the air quality in the vehicle's
interior will otherwise gradually deterio
-
rate.<

77
OVERVIEW REPAIRS OPERATIONCONTROLS DATA INDEX
AIR CONDITIONING SYSTEM
*
Draft-free ventilation Air supply for the upper body area:Button
1: air outlets can be opened and
closed by turning.

The points indicate the position in each
case.Nozzle
2: change the direction of the air
-
flow by swiveling.
Microfilter* The integrated microfilter removes dust
and pollen from the incoming or recircu
-
lated air.Your MINI Dealer will replace it during rou
-
tine maintenance. A substantial reduction
in the air supply indicates that the filter
must be replaced before scheduled mainte
-
nance.
Defrosting and demisting windows1. Set the rotary blower speed control for
the airflow rate to position
4
2. Turn the rotary temperature control
completely to the right, red3. Turn the rotary switch for air distribu
-
tion to position
.
Condensation is removed from the win
-
dows more quickly by activating the air
conditioning
4. Turn on windshield heating if necessary5. To defrost the rear window: turn on the
rear window heater.

78
1 Air onto the windshield and onto the
side windows2 Air for the upper body area
80
3 Air for the front and rear footwells4 Rear window defroster and windshield
heating
* 79
5 Interior temperature sensor, please keep
clear and unobstructed6 Recirculated air mode
79
7 Air conditioning
76
8 Automatic air distribution and
volume
79
9 Defrosting and demisting the windshield
and side windows
80
10 Temperature
79
11 Display for air temperature and air
volume
79
12 Air volume/Blower, switching air con
-
ditioner on/off
79
13 Individual air distribution
80
AUTOMATIC CLIMATE CONTROL
*

79
OVERVIEW REPAIRS OPERATIONCONTROLS DATA INDEX
AUTOMATIC CLIMATE CONTROL
*
Automatic air distribution and volume
Automatic program (AUTO):

Indicator lamp lights up.

Automatic adjustment of the air distribu
-
tion and volume, and adaptation of the
specified temperatures to external influ
-
ences, i.e. outside temperature and sun
-
light.In the automatic program (AUTO), the air
conditioning is activated automatically. To
create a pleasant air climate, the air tem
-
perature coming from the vents in the
upper body area is lower than the air tem
-
perature in the footwell.Air volume/Blower

Switching automatic climate control
off/on
Air volume/Blower.

Press the left or right half of the
button. The air volume varies. Automatic
adjustment of the air volume is deacti
-
vated.Switching air conditioner on/off.

Press the left half of the button while the
blower is at the lowest setting. The blower,
heating and air conditioning are switched
off. All displays go out.
Switch the automatic climate control back
on by pressing any button.Air conditioning
Indicator lamp lights up.

The air is cooled and dehumidified
and, depending on the temperature set
-
ting, rewarmed.In the automatic program (AUTO), the air
conditioning is activated automatically. After the engine has started, the wind
-
shield can temporarily fog over. In the air
conditioning mode, there is less condensa
-
tion on the windows.
When the air conditioning is on, con
-
densation is formed which then exits
under the vehicle. Traces of condensed
water on the ground are therefore nor
-
mal. Supply of outside air into the vehi
-
cle is blocked. indicator lamp lights
up.

The air within the vehicle is recirculated.In the automatic program (AUTO) in hot
weather conditions, the recirculated air
mode is activated temporarily to enable
faster cooling.

The indicator lamp for the recirculated air
button is not lit.
The recirculated air mode should not be constantly used over a longer period of
time, as the air quality in the vehicle's interior
will otherwise gradually deteriorate. If the
windows fog up in the recirculated air mode,
turn the recirculated air mode off and if nec
-
essary increase the air supply.
<
Rear window defroster and windshield
heating*
Indicator lamp lights up.

As long as the indicator lamp is lit,
the window heater is operating.

The heater switches off automatically after a
short time. Temperature
Tap or turn the wheel in the appro
-
priate direction to change the tem
-
perature step by step.The figures in the display provide a
general indication of interior temperature.
When you start the vehicle, the system
ensures that the selected temperature is
achieved as quickly as possible and then main
-
tained.