2005 Mercury Mountaineer window

The remote entry system allows you
to lock or unlock all vehicle doorsand liftgate, and open the liftgate
window without a key.
UNLOCKING THE
DOORS/LIFTGATE
Press this control to
unlock the driver’s door.
The interior lamps will illuminate
with the ignition in OFF. Press
the control a second time
within three seconds to unlockall doors and the liftgate.
LOCKING THE
DOORS/LIFTGATE
Press this control
once to lock all doors and liftgate.
The doors and liftgate will lock and theparking lamps will flash once as long as all
doors, liftgate, and the liftgate glass are
closed. To confirm that all doors are closed
and locked, press the control a second time
within three seconds. The doors will lock
again, the horn will chirp, and the lamps
will flash. If any door, the liftgate or the
liftgate glass are not closed properly, thelamps will not flash, and the horn will chirp
twice if the control is pressed a second
time within three seconds.
OPENING THE LIFTGATE WINDOWPress the control to open the
liftgate window.
SOUNDING A PANIC ALARMThe Panic feature will only
operate when the ignition is in
the OFF or ACCESSORY position. Press
this control to activate the alarm. The
personal panic alarm will cycle the hornand the parklamps will flash for amaximum of 3 minutes.
MEMORY SEAT FEATURE (IF EQUIPPED)The remote entry system can also control
the memory seat and pedal features. Press
the control once to unlock the driver’s door
and move the memory seat and power
adjustable pedal to the corresponding
memory position (just as if you had pressed
the memory control in the vehicle). Please
consult your Owner’s Guide for complete
details on this feature.
REMOTE ENTRY SYSTEM
Additional Features
Using radiofrequency pressure sensors, this system monitors tire pressure on all
road tires and provides the driver with a yellow warning light when air needs to
be added. (Message Center equipped vehicles provide additional warning
messages.) The TPMS warning light will reset itself (turn off ) after the tires are
set to specification and the vehicle is either parked up to 1 hour or the vehicle is
driven above 20 mph for 10 seconds.
Please note:Outside temperature affects tire pressure. Please see your Owner’s
Guide for additional information.
TIRE PRESSURE MONITORING SYSTEM (IF EQUIPPED)

Mountaineer is so accommodating that its available heated seats allow
both driver and front passenger to add warmth to their travels.
To operate the heated seats:
Activate by pushing the control on the side of the seat, on the
outboard portion of the plastic side shield. The heated seat icon in
the Dual Automatic Temperature Control (DATC) (if equipped) will
illuminate when activated.
To deactivate, push the control again.
HEATED SEATS (IF EQUIPPED)
DUAL AUTOMATIC TEMPERATURE CONTROL (DATC) (IF EQUIPPED)
1. ON/OFF— With the ignition in the ON position, press AUTO, any of the override controls, the
fan speed control, or either of the temperature selection controls to turn the system on.
Press OFF to turn the system off. If the outside temperature function has been selected, it
will continue to operate until the ignition is turned off.
2. AUTO— To initiate automatic operation, press AUTO and select the desired temperature.
When AUTO is selected, the air conditioning system automatically makes climate controladjustments based on existing conditions.
3. DUAL— As the driver, you can press DUAL to enable or disable the dual zone temperature
feature. Your passenger may also initiate the dual temperature zone feature by pressing the
passenger side temperature control. When DUAL is selected, the indicator will illuminate.
The display window will indicate the current driverselected temperature setting and the last
passengerselected temperature setting.
4. TEMPERATURE CONTROL — To control the temperature on the driver’s side, select any
temperature between 60°F and 90°F by pressing the temperature control. The display
window indicates the selected temperature and allows for manual control of fan speed if
automatic fan speed is not desired. Have your passenger press the passenger side
temperature control to select any temperature between 60°F and 90°F.
12
3
44
If your Mountaineer came
equipped with another climate
control system, please see your
Owner’s Guide.

2
4
5
3
Interior Features
HEADLAMP CONTROLS
Pull the release lever to release the parking brake. Driving with the parkingbrake engaged will cause the brakes to wear out quickly and reduce fuel
economy.The parking brake is not recommended to stop a moving vehicle.
However, if the normal brakes fail, the parking brake can be used to stop your
vehicle in an emergency. Because the parking brake applies only the rear
brakes, the vehicle’s stopping distance will increase greatly and the handling
of your vehicle will be adversely affected.
Your antilock braking system (ABS) detects the onset of wheel lockup during
brake applications and helps prevent wheels from locking during extreme
braking situations. The ABS warning light will illuminate when you start your
engine; however, if it stays on, continues to flash, or fails to illuminate, see your
dealership's service department immediately.
ANTILOCK BRAKES
Push the lever down to activate your left turn signal; up to activate the right
turn signal. To use your windshield wiper washers: For a single swipe, push
the end of the stalk briefly. Push and hold for three swipes with wash. Push
and hold for a longer wash (up to ten seconds). The bars of varying length are
for intermittent wipers. Rotate the windshield wiper control upward for fast
intervals and downward for slow intervals. The control ring on the right side of
the stalk operates the rear window wiper. Rotate the control to the normal
speed (INT2) or intermittent (INT1).
TURN SI GNALS AND WINDSHIELD WIPER WASHERS
This control is on the lower left of your instrument panel. The first position to
your right controls your parking lamps and the second position controls your
headlamps. If your vehicle is equipped with fog lights, pull the control switch
out one position to aid your visibility in fog, snow, or rain.
Autolamp (if
equipped) automatically activates/deactivates your headlampsas necessary.
To use autolamp, rotate the control counterclockwise;to deactivate, rotate the
control clockwise to the OFF position.
PARKING BRAKE RELEASE

8
10
11
7
9
To engage speed controls, make sure you’re traveling at or above 30 mph and
press ON. To set a higher speed, press and hold SET + ; release when you’ve
reached the desired speed. To set a lower speed, press and hold COAST or
CST – ; release when you’ve slowed to the desired speed. To return to a
previously set speed, press RES (you must be traveling above 30 mph).
To disengage, press the brake pedal or press the OFF button.
SPEED CONTROL
SERVICE ENGINE SOON WARNING LIGHT
DUAL AUTOMATIC TEMPERATURE CONTROL (DATC) (IF EQUIPPED)
(Please see reverse side for more details.)
To defrost/defog your windshield, select defrost. To defrost your rear window,
press the rear defroster control on your instrument panel; press again to turn it
off. (Defrost turns off automatically after 10 minutes; if you need more defrost
time, press again.) If the outside temperature is about 43°F or higher, the air
conditioner will dehumidify your interior automatically.
CLOCK (6CD RADIO ONLY)
WINDSHIELD DEFROSTING/DEFOGGING
6AUDIO SYSTEM
(Please see reverse side for more details.)
SETTING THE CLOCK: Press MENU until SELECT HOUR or SELECT MINS is
displayed. Use the SEL control to manually increase or decrease the hours or
minutes. Press MENU again to disengage the clock mode.
This light is located on the upper right of your instrument cluster. It illuminates
when you start your engine. However if it stays on, it may indicate your fuel cap
isn’t securely tightened, your vehicle is out of fuel or fuel quality is poor, or
another condition requiring attention exists.