2005 Mercury Mountaineer turn signal

Audio Features
2
3
4
5
67
8
10 9
AUDIOPHILE SATELLITEREADY
INDASH SIXCD RADIO
(IF EQUIPPED)
If your Mountaineer came equipped
with another audio system, please see
your Owner’s Guide.
1. SCAN FUNCTIONIn radio mode, press to hear a sampling of
all listenable stations. In CD mode, press to hear a brief sampling of all selections on
the current CD.
2. CD/AUXPress to select CD/AUX modes. No CD will display
if there is not a CD in the audio system. If a disc is
loaded, there will be a number (16) inside the
circle on the display. When in radio mode, press
CD/AUX to play a loaded CD.
3. LOADING CDPress LOAD and then a preset number to select a
slot. Press and hold LOAD to activate autoload.
4. VOLUME/POWER CONTROLPress the control to turn the audio system on or
off. Turn the control to raise or lower volume. The
speed sensitive volume feature automatically
adjusts radio volume in accordance with vehicle
speed to compensate for road and wind noise. To
engage, press and hold the volume control for five
seconds (with the radio on), then simultaneously
press SEL to choose the compensation level.
5. AM/FM SELECTIn radio mode, press AM/FM to select AM, FM1, or
FM2 frequency bands. In CD mode, press AM/FM
to stop play and begin radio play. Press and hold
AM/FM to activate autoset.
6. SATELLITE Your Audiophile radio comes equipped with
satelliteready capability. The kit to enable
satellite reception is available through your
Mercury dealer. Detailed satellite instructions are
included with the dealerinstalled kit.
7. DISC/TUNE CATIn radio mode, press to move to the next
frequency up or down the band. In CD mode,
press to select a disc in the CD player. CAT is only
available when equipped with satellite radio.
8. DIGITAL SIGNAL PROCESSINGPress DSP to access the ambiance menu.
Ambiance gives the feeling of “being there” to
your music. Press SEL to engage/disengage.
9. SEEK FUNCTION In radio mode, press to move to the next
listenable station up or down the band. In CD
mode, press to select the next/previous track on
the current disc.
10.SETTING THE CLOCKPress MENU until SELECT HOUR or SELECT MINS
is displayed. Press SEL to set the time. Press
MENU again to disengage the clock mode.
11. SETTING MEMORY PRESET STATIONSSelect AM, FM1, or FM2 band, then select a
station. Next, press and hold a numbered control
until the sound returns.
1
11
CAUTION: DO NOT USE CDs WITH ADHESIVE LABEL*
* CDs with adhesive labels and irregularly shaped CDs may get stuck in the CD player. Homemade CDs
should be identified with permanent felt tip marker rather than adhesive labels.

2
4
5
3
Interior Features
HEADLAMP CONTROLS
Pull the release lever to release the parking brake. Driving with the parkingbrake engaged will cause the brakes to wear out quickly and reduce fuel
economy.The parking brake is not recommended to stop a moving vehicle.
However, if the normal brakes fail, the parking brake can be used to stop your
vehicle in an emergency. Because the parking brake applies only the rear
brakes, the vehicle’s stopping distance will increase greatly and the handling
of your vehicle will be adversely affected.
Your antilock braking system (ABS) detects the onset of wheel lockup during
brake applications and helps prevent wheels from locking during extreme
braking situations. The ABS warning light will illuminate when you start your
engine; however, if it stays on, continues to flash, or fails to illuminate, see your
dealership's service department immediately.
ANTILOCK BRAKES
Push the lever down to activate your left turn signal; up to activate the right
turn signal. To use your windshield wiper washers: For a single swipe, push
the end of the stalk briefly. Push and hold for three swipes with wash. Push
and hold for a longer wash (up to ten seconds). The bars of varying length are
for intermittent wipers. Rotate the windshield wiper control upward for fast
intervals and downward for slow intervals. The control ring on the right side of
the stalk operates the rear window wiper. Rotate the control to the normal
speed (INT2) or intermittent (INT1).
TURN SI GNALS AND WINDSHIELD WIPER WASHERS
This control is on the lower left of your instrument panel. The first position to
your right controls your parking lamps and the second position controls your
headlamps. If your vehicle is equipped with fog lights, pull the control switch
out one position to aid your visibility in fog, snow, or rain.
Autolamp (if
equipped) automatically activates/deactivates your headlampsas necessary.
To use autolamp, rotate the control counterclockwise;to deactivate, rotate the
control clockwise to the OFF position.
PARKING BRAKE RELEASE