2005 MERCEDES-BENZ SLR CLASS parking brake

282 OperationTires and wheelsThoroughly clean the mounting face of
wheels and brake disks, i.e. the inner side
of the wheels/tires, during each rotation.
Check for and ensure proper tire inflation
pressure.
For information on wheel change, see the
“Practical hints” section (
page 349).
Anti-theft wheel nuts
Your vehicle is equipped with anti-theft
wheel nuts that prevent the theft of your
vehicle’s wheels.
1Anti-theft wheel nut
2Wheel nut key
Warning!
G
Have the tightening torque checked after
changing a wheel. Wheels could become
loose if not tightened with a torque of
95 lb-ft (130 Nm).
Only use genuine Mercedes-Benz wheel
bolts specified for your vehicle’s rims.
Warning!
G
Pull the parking brake lever up as many
notches as possible and move the gear se-
lector lever to positionP, before loosening
the wheel bolts. Otherwise the vehicle may
move and cause an accident and/or serious
personal injury. !Do not use air tools, such as an impact
wrench, when installing or removing
the anti-theft wheel nuts. An impact
wrench can damage the anti-theft
wheel nuts and the wheel nut key, or
cause them to malfunction.
!Store wheel bolts and anti-theft wheel
nuts not currently in use in a safe place
to avoid damage to the threads.

298 Practical hintsWhat to do if ...Problem
Possible cause
Suggested solutions
3
(Canada only)
;
(USA only)The red brake warning lamp
comes on while driving and
you hear a warning sound.
You are driving with the parking brake on.

Release the parking brake (
page 49).
There is a malfunction in the SBC brake
system.

Read and observe messages in the display
(page 304).
3
(Canada only)
;
(USA only)
The red brake warning lamp
comes on while driving
There is insufficient brake fluid in the
reservoir.

Risk of accident! Carefully stop the vehicle
and notify an authorized Mercedes-Benz
Center. Do not add brake fluid! This will not
solve the problem.
Warning!
G
Driving with the brake warning lamp illumi-
nated can result in an accident. Have your
brake system checked immediately if the
brake warning lamp stays on. Do not add
brake fluid before checking the brake sys-
tem.
Overfilling the brake fluid reservoir can re-
sult in spilling brake fluid on hot engine
parts and the brake fluid catching fire. You
can be seriously burned.
!If you find that the brake fluid in the
brake fluid reservoir has fallen to the
minimum mark or below, have the
brake system checked for brake pad
thickness and leaks.

299 Practical hints
What to do if ...
Problem
Possible cause
Suggested solutions
ú
(USA only)
±
(Canada only)
The yellow engine malfunc-
tion indicator lamp comes on
while driving.
There is a malfunction in:

The fuel injection system


The ignition system


The emission control system


Systems which effect emissions
Such malfunctions may result in excessive
emissions values and may switch the en-
gine to its limp-home (emergency opera-
tion) mode.

Have the vehicle checked as soon as possi-
ble by an authorized Mercedes-Benz Center.
An on-board diagnostic connector is used by
the service station to link the vehicle to the
shop diagnostics system. It allows the accu-
rate identification of system malfunctions
through the readout of diagnostic trouble
codes. It is located in the front left area of
the footwell next to the parking brake.
Your gas tank is empty.

After refuelling, start, turn off and restart the
engine three or four times in succession.
The limp-home mode is canceled. You do not
need to have your vehicle checked.
The fuel cap is not closed tightly.

Check the fuel cap.

316 Practical hintsWhat to do if ...Left display
Right display
Possible cause
Possible solution
;
(USA only)
3
(Canada only)
Brakes overheated!
Drive carefully
The brake system is overheated
due to an excessive load on the
brakes.

Relieve the load on the brake system.

Drive more smoothly and think ahead to avoid
unnecessary braking.

When driving down steep grades, shift into a
lower gear to use the engine’s braking power
(page 170).

Cautiously continue driving so that the air
stream will cool down the brakes.
Release
parking brake!
You are driving with the parking
brake set.

Release the parking brake (
page 49).
Service brake
Visit
workshop!
There are malfunctions, but the
SBC brake system is operating
normally.

Visit an authorized Mercedes-Benz Center im-
mediately.

347 Practical hints
Replacing bulbs
Front lamps
Rear lamps
Lamp
Type
1
Additional turn signals
LEDs
2
Turn signals
PY, 21 W
3
Side marker lamp
WY 5 W
4
Parking lamps
W5W
5
Low and high beam
lamp
D2S, 35 W
6
High beam flasher
H7, 55 W
7
Front fog lamps
H3, 55 W
Lamp
Type
8
Brake/parking lamp
LEDs
9
Turn signal lamp
LEDs
a
Side marker lamp
P 21 W
b
High mounted brake
lamp
LEDs
c
License plate lamp
C 5 W
d
Rear fog lamp
P 21 W
e
Back up lamp
P 21 W
f
Reflector
-

349 Practical hints
Flat tire
Flat tire
The vehicle is equipped with the TIREFIT
kit.Preparing the vehicle
Park the vehicle as far as possible from
moving traffic on a hard surface.

Turn on the hazard warning flashers.

Turn the steering wheel so that the
front wheels are in a straight ahead po-
sition.

Set the parking brake.

Move the gear selector lever to P.

Turn off the engine (
page 58).

Remove the SmartKey from the starter
switch.

Open the driver’s door.

Have any passenger exit the vehicle at
a safe distance from the roadway.
Sealing tires with TIREFIT kit
Small tire punctures, particularly those in
the tread, can be sealed with TIREFIT.
TIREFIT can be used in ambient tempera-
tures down to -4°F (-20°C).

Foreign objects (e.g. screws or nails)
should not be removed from the tire.

Take TIREFIT, the sticker, and the elec-
tric air pump out of the trunk.
!A wheel change should only be carried
out at an authorized Mercedes-Benz
Center. Otherwise there is a danger of
damaging the vehicle by jacking it up
incorrectly.
iOpen door only when conditions are
safe to do so.Warning!
G
Keep TIREFIT away from sparks, open flame
or heat source.
Do not smoke.
Warning!
G
TIREFIT is a limited repair device. TIREFIT
cannot be used for cuts or punctures larger
than approximately 0.16 in (4 mm) and tire
damage caused by driving with extremely
low tire inflation pressure, or on a flat tire, or
a damaged wheel.
Do not drive the vehicle under such circum-
stances.
Contact your nearest Mercedes-Benz
Center for assistance or call Roadside
Assistance. !After using TIREFIT, the tire inflation
pressure sensor may have to be re-
placed.


393 Index
B
BabySmart
TM
Self-test 75
BabySmart
TM airbag deactivation
system 75, 385
BabySmartTM compatible child
seats 385
Back up lamp 347
Bar 278
BAS 79, 81, 385
BAS/ESP
Indicator lamp 296
Batteries, SmartKey
Check lamp 99
Replacing 344
Batteries, vehicle 250
Charging 355
Consumer battery 250, 354
Maintenance 354
Messages in the multifunction
display 310
Starter battery 250
Battery charger 356
Bead 278Bi-Xenon headlamps 385
Body surface 289
Brake fluid 375, 378
Checking 241
Brake lamp
High mounted 347
Brake pads
Messages in the multifunction
display 317
Brake warning lamp 29, 298
Brake/parking lamp 347
Brakes 230
Break-in period 228
Bulbs
Changing 346
Front 347
Messages in the multifunction
display 323
Rear 347
Button
Audio system 146C
CAC 385
CAN system 386
Capacities
Fuels, coolants, lubricants etc. 375
Cargo area see Trunk
Cassette operation
Playing cassettes 152
Catalytic converter 237
CD changer 156
Loading/unloading a CD
magazine 157
Location 157
CD operation 156
CD player
Operating 123
Cellular phone
Delayed switch-off time 205
Inserting the cradle 205
Making calls in hands-free mode 207
Making calls in private mode 206
Re-inserting 206
Removing the cradle 204

401 Index
L
Lamps
Exterior 346
Lamps, indicator and warning
ABS 29, 297
ABS/ESP 29, 296
Airbrake 29, 301
BAS/ESP 296
Battery (SmartKey) 98
Brake warning lamp 29, 298
CHECK ENGINE 29
Coolant 300
Coolant level 29
Engine oil 29
ESP 81
Fuel reserve 29, 301
Gearshift 29
High beam 29
Maintenance service indicator 286
Manual gearshift 301
PASSENGER AIRBAG OFF 303
SBC 84
Seat belt 29, 302
SRS 29, 63, 302
Turn signal 29Language
Multifunction display 130
License plate illumination 347
Light
Sensor 328
Lighting
Automatic headlamp mode 106
Combination switch 109
Daytime running lamp mode 107
Exterior lamp switch 105
Front fog lamps 108
High beams 109
Instruments 113
Interior 111
Locator lighting 108
Low beam 105
Manual headlamp mode 106
Night security illumination 108
Parking lamps 105
Rear fog lamp 109
Settings (control system) 130
Standing lamps 105Limiting the gear range 170
Limp Home Mode 177
Loading terminology 278
Loading the vehicle 256
Location
Audio system 143
Compact guide (Canada only) 341
Telephone 201
Locator lighting 108, 132
Locking 56
Automatic while driving 103
Centrally from inside 103
Fuel filler flap 240
Global, SmartKey 98
Loss of
Keys 100
Service and Warranty Information
Booklet 365
Low and high beam lamp 347